Stefan Penthor
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Stefan Penthor has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
- Tobias Pröll
Universität für Bodenkultur Wien
10 shared publications - Hermann Hofbauer
Technische Universität Wien (TU Wien)
8 shared publications - Karl Mayer
Tech Univ Wien, Getreidemarkt 9, A-1060 Vienna, Austria
7 shared publications Hermann Hofbauer
4 shared publicationsOtmar Bertsch
3 shared publicationsFlorian Zerobin
2 shared publications
Latest Publications
- Open Access
- 5 May 2021
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 13 (6) , 5095-5106
Innovative laboratory unit for pre-testing of oxygen carriers for chemical-looping combustion
Chemical-looping combustion (CLC) is a highly efficient CO2 separation technology with no direct contact between combustion air and fuel. A metal oxide is used as an oxygen carrier (OC) and acts in a dual fluidized bed as a separation tool and supplies the fuel with oxygen, which as an oxidation medium causes combustion to CO2 and H2O. The use of solid fuels, especially biomass, is the focus of current investigations. The OC plays a key role, because it must meet special requirements for solid fuels, which are different to gaseous fuels. The ash content, special reaction mechanisms, and increased abrasion make research into new types of OC essential. Preliminary testing of OC before their use in larger plants regarding their suitability is recommended. For this reason, this work shows the design and the results of a laboratory reactor, which was planned and built for fundamental investigation of OC. Designed as a transient fluidized bed, the reactor, equipped with its own fuel conveying system and an in situ solid sampling, is intended to be particularly suitable for cheap and rapid pre-testing of OC materials. During the tests, it was shown that the sampling device enables non-selective sampling. Different OC were tested under various operating conditions, and their ability to convert different fuels could be quantified. The results indicate that OC can be sufficiently investigated to recommend operation in larger plants.
- 5 May 2021
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 13 (6) , 5095-5106
Open AccessInnovative laboratory unit for pre-testing of oxygen carriers for chemical-looping combustion
Chemical-looping combustion (CLC) is a highly efficient CO2 separation technology with no direct contact between combustion air and fuel. A metal oxide is used as an oxygen carrier (OC) and acts in a dual fluidized bed as a separation tool and supplies the fuel with oxygen, which as an oxidation medium causes combustion to CO2 and H2O. The use of solid fuels, especially biomass, is the focus of current investigations. The OC plays a key role, because it must meet special requirements for solid fuels, which are different to gaseous fuels. The ash content, special reaction mechanisms, and increased abrasion make research into new types of OC essential. Preliminary testing of OC before their use in larger plants regarding their suitability is recommended. For this reason, this work shows the design and the results of a laboratory reactor, which was planned and built for fundamental investigation of OC. Designed as a transient fluidized bed, the reactor, equipped with its own fuel conveying system and an in situ solid sampling, is intended to be particularly suitable for cheap and rapid pre-testing of OC materials. During the tests, it was shown that the sampling device enables non-selective sampling. Different OC were tested under various operating conditions, and their ability to convert different fuels could be quantified. The results indicate that OC can be sufficiently investigated to recommend operation in larger plants.
- Open Access
- 12 November 2018
- Published by Wiley in Energy Technology
- Vol. 6 (12) , 2333-2343
Chemical Looping Combustion Using Two Different Perovskite Based Oxygen Carriers: A Pilot Study
Two perovskite type oxygen carriers, for the application in chemical looping combustion, called C14 and C28 are investigated. The composition of C14 is CaMn0.9Mg0.1O3−δ and CaMn0.775Mg0.1Ti0.125O3−δ for C28, respectively. Both oxygen carriers allow chemical looping with oxygen uncoupling (CLOU), they release oxygen under conditions with low oxygen partial pressure. The materials are tested in a 120 kWth pilot plant at TU Wien. Operating temperatures from 800 °C to 960 °C are investigated, further the influence of active inventory and air equivalence number is reviewed. In addition to the experiments in the pilot plant, particle analysis is performed. In total, the CLC operation for C14 was 29.5 h and 22.7 h for C28, resulting in 75 different operating points. Both oxygen carrier materials are able to fully convert the natural gas, used as fuel. A temperature dependency is noticeable for both, the best results are achieved at 960 °C, the highest investigated temperature. Both, C14 and C28 are able to release about 10 % of the total available oxygen via oxygen uncoupling. The performance of both oxygen carriers is strongly linked to the air equivalence number and the resulting amount of excess oxygen in the air reactor. Low oxygen partial pressures lead to incomplete fuel conversion.
- 12 November 2018
- Published by Wiley in Energy Technology
- Vol. 6 (12) , 2333-2343
Open AccessChemical Looping Combustion Using Two Different Perovskite Based Oxygen Carriers: A Pilot Study
Two perovskite type oxygen carriers, for the application in chemical looping combustion, called C14 and C28 are investigated. The composition of C14 is CaMn0.9Mg0.1O3−δ and CaMn0.775Mg0.1Ti0.125O3−δ for C28, respectively. Both oxygen carriers allow chemical looping with oxygen uncoupling (CLOU), they release oxygen under conditions with low oxygen partial pressure. The materials are tested in a 120 kWth pilot plant at TU Wien. Operating temperatures from 800 °C to 960 °C are investigated, further the influence of active inventory and air equivalence number is reviewed. In addition to the experiments in the pilot plant, particle analysis is performed. In total, the CLC operation for C14 was 29.5 h and 22.7 h for C28, resulting in 75 different operating points. Both oxygen carrier materials are able to fully convert the natural gas, used as fuel. A temperature dependency is noticeable for both, the best results are achieved at 960 °C, the highest investigated temperature. Both, C14 and C28 are able to release about 10 % of the total available oxygen via oxygen uncoupling. The performance of both oxygen carriers is strongly linked to the air equivalence number and the resulting amount of excess oxygen in the air reactor. Low oxygen partial pressures lead to incomplete fuel conversion.
- 1 April 2018
- Published by Elsevier in International Journal of Greenhouse Gas Control
- Vol. 71, 86-94
Fate of sulfur in chemical looping combustion of gaseous fuels using a copper-based oxygen carrier
- 1 April 2018
- Published by Elsevier in International Journal of Greenhouse Gas Control
- Vol. 71, 86-94
Fate of sulfur in chemical looping combustion of gaseous fuels using a copper-based oxygen carrier
- 1 March 2018
- Published by Elsevier in Chemical Engineering Science
- Vol. 178, 48-60
Fluid dynamic evaluation of a 10 MW scale reactor design for chemical looping combustion of gaseous fuels
- 1 March 2018
- Published by Elsevier in Chemical Engineering Science
- Vol. 178, 48-60
Fluid dynamic evaluation of a 10 MW scale reactor design for chemical looping combustion of gaseous fuels
- Open Access
- 1 July 2017
- Published by Elsevier in Energy Procedia
- Vol. 114, 395-406
The EU-FP7 Project SUCCESS – Scale-up of Oxygen Carrier for Chemical Looping Combustion using Environmentally Sustainable Materials
- 1 July 2017
- Published by Elsevier in Energy Procedia
- Vol. 114, 395-406
Open AccessThe EU-FP7 Project SUCCESS – Scale-up of Oxygen Carrier for Chemical Looping Combustion using Environmentally Sustainable Materials
- 1 July 2017
- Published by Elsevier in Powder Technology
- Vol. 316, 569-577
Fluidized bed reactor design study for pressurized chemical looping combustion of natural gas
- 1 July 2017
- Published by Elsevier in Powder Technology
- Vol. 316, 569-577
Fluidized bed reactor design study for pressurized chemical looping combustion of natural gas
- 27 June 2016
- Published by Wiley in Energy Technology
- Vol. 4 (10) , 1299-1304
Concept Study for Competitive Power Generation from Chemical Looping Combustion of Natural Gas
Chemical looping combustion (CLC) offers the possibility for efficient fuel conversion with inherent CO2 capture and is expected to significantly reduce the energy penalty associated with CO2 capture processes. Feasibility of the concept has been shown and studied thoroughly in lab experiments whereas the potential for power generation on a large scale will depend on the process configuration. Two different scenarios for competitive power generation from atmospheric pressure CLC of natural gas have been assessed in this study using process simulation. Process design is shown and discussed based on net electric efficiencies.
- 27 June 2016
- Published by Wiley in Energy Technology
- Vol. 4 (10) , 1299-1304
Concept Study for Competitive Power Generation from Chemical Looping Combustion of Natural Gas
Chemical looping combustion (CLC) offers the possibility for efficient fuel conversion with inherent CO2 capture and is expected to significantly reduce the energy penalty associated with CO2 capture processes. Feasibility of the concept has been shown and studied thoroughly in lab experiments whereas the potential for power generation on a large scale will depend on the process configuration. Two different scenarios for competitive power generation from atmospheric pressure CLC of natural gas have been assessed in this study using process simulation. Process design is shown and discussed based on net electric efficiencies.
- 1 January 2016
- Published by Elsevier in Powder Technology
- Vol. 287, 61-69
Detailed fluid dynamic investigations of a novel fuel reactor concept for chemical looping combustion of solid fuels
- 1 January 2016
- Published by Elsevier in Powder Technology
- Vol. 287, 61-69
Detailed fluid dynamic investigations of a novel fuel reactor concept for chemical looping combustion of solid fuels
- 1 November 2015
- Published by Elsevier in Applied Energy
- Vol. 157, 323-329
The different demands of oxygen carriers on the reactor system of a CLC plant – Results of oxygen carrier testing in a 120 kWth pilot plant
- 1 November 2015
- Published by Elsevier in Applied Energy
- Vol. 157, 323-329
The different demands of oxygen carriers on the reactor system of a CLC plant – Results of oxygen carrier testing in a 120 kWth pilot plant