Karl Mayer
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Karl Mayer has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
Hermann Hofbauer
7 shared publications- Stefan Penthor
TU Wien, Institute of Chemical, Environmental and Bioscience Engineering (ICEBE), Wien, Austria
7 shared publications - Tobias Pröll
Universität für Bodenkultur Wien
7 shared publications - Hermann Hofbauer
Technische Universität Wien (TU Wien)
6 shared publications Stefan Penthor
5 shared publicationsMichael Stollhof
3 shared publications
Latest Publications
- 1 December 2019
- Published by Elsevier in Applied Energy
- Vol. 255
Evaluation of a new DCFB reactor system for chemical looping combustion of gaseous fuels
- 1 December 2019
- Published by Elsevier in Applied Energy
- Vol. 255
Evaluation of a new DCFB reactor system for chemical looping combustion of gaseous fuels
- 1 June 2019
- Published by Elsevier in Powder Technology
- Vol. 352, 422-435
Influence of the loop seal fluidization on the operation of a fluidized bed reactor system
- 1 June 2019
- Published by Elsevier in Powder Technology
- Vol. 352, 422-435
Influence of the loop seal fluidization on the operation of a fluidized bed reactor system
- 1 January 2019
- Published by Elsevier in Chemical Engineering Science
- Vol. 193, 102-119
Unsteady three-dimensional theoretical model and numerical simulation of a 120-kW chemical looping combustion pilot plant
- 1 January 2019
- Published by Elsevier in Chemical Engineering Science
- Vol. 193, 102-119
Unsteady three-dimensional theoretical model and numerical simulation of a 120-kW chemical looping combustion pilot plant
- Open Access
- 12 November 2018
- Published by Wiley in Energy Technology
- Vol. 6 (12) , 2333-2343
Chemical Looping Combustion Using Two Different Perovskite Based Oxygen Carriers: A Pilot Study
Two perovskite type oxygen carriers, for the application in chemical looping combustion, called C14 and C28 are investigated. The composition of C14 is CaMn0.9Mg0.1O3−δ and CaMn0.775Mg0.1Ti0.125O3−δ for C28, respectively. Both oxygen carriers allow chemical looping with oxygen uncoupling (CLOU), they release oxygen under conditions with low oxygen partial pressure. The materials are tested in a 120 kWth pilot plant at TU Wien. Operating temperatures from 800 °C to 960 °C are investigated, further the influence of active inventory and air equivalence number is reviewed. In addition to the experiments in the pilot plant, particle analysis is performed. In total, the CLC operation for C14 was 29.5 h and 22.7 h for C28, resulting in 75 different operating points. Both oxygen carrier materials are able to fully convert the natural gas, used as fuel. A temperature dependency is noticeable for both, the best results are achieved at 960 °C, the highest investigated temperature. Both, C14 and C28 are able to release about 10 % of the total available oxygen via oxygen uncoupling. The performance of both oxygen carriers is strongly linked to the air equivalence number and the resulting amount of excess oxygen in the air reactor. Low oxygen partial pressures lead to incomplete fuel conversion.
- 12 November 2018
- Published by Wiley in Energy Technology
- Vol. 6 (12) , 2333-2343
Open AccessChemical Looping Combustion Using Two Different Perovskite Based Oxygen Carriers: A Pilot Study
Two perovskite type oxygen carriers, for the application in chemical looping combustion, called C14 and C28 are investigated. The composition of C14 is CaMn0.9Mg0.1O3−δ and CaMn0.775Mg0.1Ti0.125O3−δ for C28, respectively. Both oxygen carriers allow chemical looping with oxygen uncoupling (CLOU), they release oxygen under conditions with low oxygen partial pressure. The materials are tested in a 120 kWth pilot plant at TU Wien. Operating temperatures from 800 °C to 960 °C are investigated, further the influence of active inventory and air equivalence number is reviewed. In addition to the experiments in the pilot plant, particle analysis is performed. In total, the CLC operation for C14 was 29.5 h and 22.7 h for C28, resulting in 75 different operating points. Both oxygen carrier materials are able to fully convert the natural gas, used as fuel. A temperature dependency is noticeable for both, the best results are achieved at 960 °C, the highest investigated temperature. Both, C14 and C28 are able to release about 10 % of the total available oxygen via oxygen uncoupling. The performance of both oxygen carriers is strongly linked to the air equivalence number and the resulting amount of excess oxygen in the air reactor. Low oxygen partial pressures lead to incomplete fuel conversion.
- 1 August 2018
- Published by Elsevier in Powder Technology
- Vol. 336, 1-11
Estimation of the solid circulation rate in circulating fluidized bed systems
- 1 August 2018
- Published by Elsevier in Powder Technology
- Vol. 336, 1-11
Estimation of the solid circulation rate in circulating fluidized bed systems
- 1 April 2018
- Published by Elsevier in International Journal of Greenhouse Gas Control
- Vol. 71, 86-94
Fate of sulfur in chemical looping combustion of gaseous fuels using a copper-based oxygen carrier
- 1 April 2018
- Published by Elsevier in International Journal of Greenhouse Gas Control
- Vol. 71, 86-94
Fate of sulfur in chemical looping combustion of gaseous fuels using a copper-based oxygen carrier
- 1 March 2018
- Published by Elsevier in Chemical Engineering Science
- Vol. 178, 48-60
Fluid dynamic evaluation of a 10 MW scale reactor design for chemical looping combustion of gaseous fuels
- 1 March 2018
- Published by Elsevier in Chemical Engineering Science
- Vol. 178, 48-60
Fluid dynamic evaluation of a 10 MW scale reactor design for chemical looping combustion of gaseous fuels
- 1 November 2015
- Published by Elsevier in Applied Energy
- Vol. 157, 323-329
The different demands of oxygen carriers on the reactor system of a CLC plant – Results of oxygen carrier testing in a 120 kWth pilot plant
- 1 November 2015
- Published by Elsevier in Applied Energy
- Vol. 157, 323-329
The different demands of oxygen carriers on the reactor system of a CLC plant – Results of oxygen carrier testing in a 120 kWth pilot plant