Adel Aitbara
Adel Aitbara has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Sabir Hazourli
Laboratoire de Traitement des Eaux et Valorisation des Déchets Industriels Département de Chimie, Faculté des Sciences Université Badji Mokhtar, B.P. 12, Annaba, Algérie
2 shared publications - Amina Eulmi1 shared publication
- Jean-Pierre Leclerc
Laboratoire Réactions et Génie des Procédés (LRGP) UMR 7274, CNRS, Université de Lorraine, 1 rue Grandville, BP 20451, 54001 Nancy cedex, France
1 shared publication - Marwa Bendaia
Materials Physico-Chemistry Laboratory, Science and Technology Faculty, Chadli Bendjedid – El Tarf University , P.B. 73 , El Tarf , 36000 , Algeria
1 shared publication - Mouna Cherifi
Laboratoire de traitement des eaux et valorisation des déchets industriels, Faculté des Sciences, Département de chimie, Bp12, Annaba 23000, Algérie, Tel. +213 550094053, Tel. +213 555527386, Tel. +213 663243605
1 shared publication - Mouna Cherifi
Badji Mokhtar Univ, Chem Dept, Lab Water Treatment & Valorizat Ind Wastes, Fac Sci, Bp 12, Annaba 23000, Algeria
1 shared publication
Latest Publications
- 1 October 2019
- Published by Walter de Gruyter GmbH in International Journal of Chemical Reactor Engineering
- Vol. 17 (12)
Evaluation of Electrocoagulation and Activated Carbon Adsorption Techniques Used Separately or Coupled to Treat Wastewater from Industrial Dairy
This present study focuses on the evaluation of the effectiveness and the feasibility of a combined treatment between the electrocoagulation (EC) and the adsorption on an activated carbon in grains (GAC) in a continuous mode. The peculiarity of this work is that the experiments are conducted with real wastewater from an industrial dairy. This combined treatment first required an optimization of the EC followed by an adsorption. For each of these techniques, different influential operating parameters such as the current density, the reaction time, the GAC dose, the initial turbidity of water … etc., have been studied. The Turbidity and the COD have been continuously analyzed, while the phosphorus, the BOD5, TSS, nitrogen and the grease have been punctually analyzed, and this happened before and after the water treatment. The EC adsorption coupling results have shown that the addition of an appropriate dose of GAC (2 gL−1) in a separate column, increases the effectiveness of treatment; more than 98 % of reduction for the COD, the BOD5, the turbidity and the greases. A mechanism explaining the phenomena which are involved in this combined treatment is proposed. On the basis of these results of efficiency, speed, low operational cost (~ 3 $m−3of the treated water), and in comparison with the EC used alone, the EC coupling/the adsorption GAC, could be recommended as a treatment of separation for waters at a high load in organic pollutants.
- 1 October 2019
- Published by Walter de Gruyter GmbH in International Journal of Chemical Reactor Engineering
- Vol. 17 (12)
Evaluation of Electrocoagulation and Activated Carbon Adsorption Techniques Used Separately or Coupled to Treat Wastewater from Industrial Dairy
This present study focuses on the evaluation of the effectiveness and the feasibility of a combined treatment between the electrocoagulation (EC) and the adsorption on an activated carbon in grains (GAC) in a continuous mode. The peculiarity of this work is that the experiments are conducted with real wastewater from an industrial dairy. This combined treatment first required an optimization of the EC followed by an adsorption. For each of these techniques, different influential operating parameters such as the current density, the reaction time, the GAC dose, the initial turbidity of water … etc., have been studied. The Turbidity and the COD have been continuously analyzed, while the phosphorus, the BOD5, TSS, nitrogen and the grease have been punctually analyzed, and this happened before and after the water treatment. The EC adsorption coupling results have shown that the addition of an appropriate dose of GAC (2 gL−1) in a separate column, increases the effectiveness of treatment; more than 98 % of reduction for the COD, the BOD5, the turbidity and the greases. A mechanism explaining the phenomena which are involved in this combined treatment is proposed. On the basis of these results of efficiency, speed, low operational cost (~ 3 $m−3of the treated water), and in comparison with the EC used alone, the EC coupling/the adsorption GAC, could be recommended as a treatment of separation for waters at a high load in organic pollutants.
- Open Access
- 1 February 2016
- Published by Elsevier in Desalination and Water Treatment
- Vol. 57 (8) , 3395-3404
Continuous treatment of industrial dairy effluent by electrocoagulation using aluminum electrodes
Electrocoagulation is one of the most efficient and convenient techniques for the elimination of several types of pollutants. Its efficiency has been validated for numerous industrial effluents (food, mechanical, textiles, paper industries, etc.). This paper deals with the treatment of dairy wastewater in Algeria by electrocoagulation using aluminum electrodes. The experiments were conducted in a small continuous reactor at laboratory scale. Turbidity and chemical oxygen demand (COD) were followed continuously during the startup period and at steady-state, where as BOD5 (five-day biological oxygen demand), greases, and phosphorus were analyzed punctually at steady state using the better operating conditions. The effect of operational parameters, such as current density, initial pH, inlet flow rate, and the temperature of waste water, were examined to optimize the effectiveness of the treatment. A satisfactory reduction of 98% of the turbidity and 90% of the COD were obtained for the optimal conditions. The abatements of BOD5 and greases were close to 97%, whereas 70% of the phosphorus was eliminated. Treatment of industrial wastewater concentrated with several milk powder concentrations has been also analyzed. Reasonable energy consumption of around 2 to 3.5 kWh/m3 for adequate operating conditions validates the economic reliability of this choice of treatment.
- 1 February 2016
- Published by Elsevier in Desalination and Water Treatment
- Vol. 57 (8) , 3395-3404
Open AccessContinuous treatment of industrial dairy effluent by electrocoagulation using aluminum electrodes
Electrocoagulation is one of the most efficient and convenient techniques for the elimination of several types of pollutants. Its efficiency has been validated for numerous industrial effluents (food, mechanical, textiles, paper industries, etc.). This paper deals with the treatment of dairy wastewater in Algeria by electrocoagulation using aluminum electrodes. The experiments were conducted in a small continuous reactor at laboratory scale. Turbidity and chemical oxygen demand (COD) were followed continuously during the startup period and at steady-state, where as BOD5 (five-day biological oxygen demand), greases, and phosphorus were analyzed punctually at steady state using the better operating conditions. The effect of operational parameters, such as current density, initial pH, inlet flow rate, and the temperature of waste water, were examined to optimize the effectiveness of the treatment. A satisfactory reduction of 98% of the turbidity and 90% of the COD were obtained for the optimal conditions. The abatements of BOD5 and greases were close to 97%, whereas 70% of the phosphorus was eliminated. Treatment of industrial wastewater concentrated with several milk powder concentrations has been also analyzed. Reasonable energy consumption of around 2 to 3.5 kWh/m3 for adequate operating conditions validates the economic reliability of this choice of treatment.