Erhan Burak Pancar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Erhan Burak Pancar has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Aytuğ Kumandaş
ONDOKUZ MAYIS ÜNİVERSİTESİ, MÜHENDİSLİK FAKÜLTESİ, İNŞAAT MÜHENDİSLİĞİ BÖLÜMÜ
3 shared publications - Erman Çavdar
Karadeniz Technical University
2 shared publications - Muhammet Vefa Akpinar
Department of Civil Engineering, Karadeniz Technical University, Trabzon, Turkey
2 shared publications - Neslihan Şahan
Karadeniz Teknik Üniversitesi
2 shared publications - Şeref Oruç
Karadeniz Technical University
2 shared publications - Baha Vural Kök
Firat Universitesi
1 shared publication
Latest Publications
- 3 April 2025
- Published by Taylor & Francis in Road Materials and Pavement Design
- Vol. 27 (1) , 1-58
Biopolymers as bitumen additives: a systematic quantitative literature review
- 3 April 2025
- Published by Taylor & Francis in Road Materials and Pavement Design
- Vol. 27 (1) , 1-58
Biopolymers as bitumen additives: a systematic quantitative literature review
- Open Access
- 1 July 2024
- Published by Teknik Dergi in Turkish Journal of Civil Engineering
- Vol. 35 (4) , 1-26
Investigation of Rutting and Low Temperature Cracking Behavior of Reactive Ethylene Terpolymer and Waste Cooking Oil Modified Bitumen
With sustainability being the most crucial issue of recent years, the use of waste materials in bitumen modification is increasing and becoming widespread. In this experimental study, it was aimed to investigate the high- and low-temperature behavior of bitumen samples modified with waste cooking oil (WCO), reactive ethylene terpolymer (RET), and polyphosphoric acid (PPA). Accordingly, the multiple stress creep and recovery (MSCR) test and the bending beam rheometer (BBR) test were conducted. Depending on the increasing WCO ratio, the Jnr,R%,∆T_c,and λ parameters of modified bitumens were examined in detail. It was observed that with increasing WCO ratio,the Jnr value increased, and elastic recovery and stiffness decreased. In addition, it has been determined that this composite-modified bitumen is resistant to heavy traffic loads and has sufficient flexibility at low temperatures.
- 1 July 2024
- Published by Teknik Dergi in Turkish Journal of Civil Engineering
- Vol. 35 (4) , 1-26
Open AccessInvestigation of Rutting and Low Temperature Cracking Behavior of Reactive Ethylene Terpolymer and Waste Cooking Oil Modified Bitumen
With sustainability being the most crucial issue of recent years, the use of waste materials in bitumen modification is increasing and becoming widespread. In this experimental study, it was aimed to investigate the high- and low-temperature behavior of bitumen samples modified with waste cooking oil (WCO), reactive ethylene terpolymer (RET), and polyphosphoric acid (PPA). Accordingly, the multiple stress creep and recovery (MSCR) test and the bending beam rheometer (BBR) test were conducted. Depending on the increasing WCO ratio, the Jnr,R%,∆T_c,and λ parameters of modified bitumens were examined in detail. It was observed that with increasing WCO ratio,the Jnr value increased, and elastic recovery and stiffness decreased. In addition, it has been determined that this composite-modified bitumen is resistant to heavy traffic loads and has sufficient flexibility at low temperatures.
- Open Access
- 1 January 2021
- Published by Wiley in Advances in Civil Engineering
- Vol. 2021 (1)
The Effects of Geocell Height and Lime Stabilization on Unpaved Road Settlements at Different Water Contents
In this study, lime stabilization and geocell reinforcement methods were investigated for a clayey subgrade of unpaved road at different water contents. This study is especially important in terms of determining the soil improvement method for road construction on wet lands. The effects of the geocell height (50, 100, 150, and 200 mm) and lime content (3, 6, and 12%) on the settlement of the subgrade soil at different water contents (25, 28, 30, 32, and 35%) were analyzed. Accordingly, a large scale plate loading test was designed, and it is utilized to achieve loading‐settlement curves. The bearing capacity and modulus of subgrade (k) of soil were determined. It was detected that the geocell height and lime content have different effects at different water contents, and the modulus of subgrade reaction became stable beyond a constant height of the geocell. It was understood that none of these two improvements did not meet the Highways Technical Specifications. It is detected that at least these two improvement techniques are needed to be applied together to meet the specifications for the soil examined in this study.
- 1 January 2021
- Published by Wiley in Advances in Civil Engineering
- Vol. 2021 (1)
Open AccessThe Effects of Geocell Height and Lime Stabilization on Unpaved Road Settlements at Different Water Contents
In this study, lime stabilization and geocell reinforcement methods were investigated for a clayey subgrade of unpaved road at different water contents. This study is especially important in terms of determining the soil improvement method for road construction on wet lands. The effects of the geocell height (50, 100, 150, and 200 mm) and lime content (3, 6, and 12%) on the settlement of the subgrade soil at different water contents (25, 28, 30, 32, and 35%) were analyzed. Accordingly, a large scale plate loading test was designed, and it is utilized to achieve loading‐settlement curves. The bearing capacity and modulus of subgrade (k) of soil were determined. It was detected that the geocell height and lime content have different effects at different water contents, and the modulus of subgrade reaction became stable beyond a constant height of the geocell. It was understood that none of these two improvements did not meet the Highways Technical Specifications. It is detected that at least these two improvement techniques are needed to be applied together to meet the specifications for the soil examined in this study.
- Open Access
- 25 August 2016
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2016, 1-8
Comparison of Effects of Using Geosynthetics and Lime Stabilization to Increase Bearing Capacity of Unpaved Road Subgrade
So many soil improvement methods have been developed in order to increase bearing capacity of superstructure of the road to be constructed on the soft clayey road base soils, decrease settlements, and increase other strength specifications (CBR,,values, etc.). In this paper, lime stabilization of clayey road base soil with high water content and its improvement with geosynthetics (geocell + geotextile) reinforcement and comparisons of these two different improvement methods were made. For this purpose, plate loading experimental comparisons of clayey soil, which had high water content by 10% increasing the optimum water content, were made after it was improved with lime at the rates of 3, 6, and 12%, geotextile reinforcement, geocell reinforcement, geosynthetics reinforcement, and geosynthetics reinforcement + lime stabilization at various rates. It was understood that these improvement methods will not yield sufficient results on clayey soils with high water content on their own, and method of improvement with lime and then reinforcement with geosynthetics yields better results on these types of soils. Only one improvement state among ten different states examined in this study gave the sufficient results for the soil to be used for unpaved roads.- 25 August 2016
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2016, 1-8
Open AccessComparison of Effects of Using Geosynthetics and Lime Stabilization to Increase Bearing Capacity of Unpaved Road Subgrade
So many soil improvement methods have been developed in order to increase bearing capacity of superstructure of the road to be constructed on the soft clayey road base soils, decrease settlements, and increase other strength specifications (CBR,,values, etc.). In this paper, lime stabilization of clayey road base soil with high water content and its improvement with geosynthetics (geocell + geotextile) reinforcement and comparisons of these two different improvement methods were made. For this purpose, plate loading experimental comparisons of clayey soil, which had high water content by 10% increasing the optimum water content, were made after it was improved with lime at the rates of 3, 6, and 12%, geotextile reinforcement, geocell reinforcement, geosynthetics reinforcement, and geosynthetics reinforcement + lime stabilization at various rates. It was understood that these improvement methods will not yield sufficient results on clayey soils with high water content on their own, and method of improvement with lime and then reinforcement with geosynthetics yields better results on these types of soils. Only one improvement state among ten different states examined in this study gave the sufficient results for the soil to be used for unpaved roads. - Open Access
- 1 January 2016
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2016, 1-8
Using Recycled Glass and Zeolite in Concrete Pavement to Mitigate Heat Island and Reduce Thermal Cracks
Urban heat island (UHI) effect is built environmental issue related to pavements. It is desired to reduce pavement high surface temperature in summer to mitigate UHI effect. High surface temperature also affects slab temperature difference (the top surface temperature minus the bottom surface temperature of the slab). The increased slab temperature difference induces a high possibility of cracking in concrete roads. The prime aim of this study was to reduce the slab surface temperature by using recycled glass as a fine aggregate and zeolite as cement in concrete. Recycled glass was used to replace fine aggregate in proportions of 10%, 20%, and 30% by total weight of aggregate. Zeolite replaced Portland cement in proportions of 10% and 30% for three different proportions of recycled glass concrete mixtures. Optimum proportions were determined by examining mechanical properties of samples and alkali-silica reactions. It was noticed that using recycled glass and zeolite together in concrete reduces pavement surface temperature and temperature gradient in summer.
- 1 January 2016
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2016, 1-8
Open AccessUsing Recycled Glass and Zeolite in Concrete Pavement to Mitigate Heat Island and Reduce Thermal Cracks
Urban heat island (UHI) effect is built environmental issue related to pavements. It is desired to reduce pavement high surface temperature in summer to mitigate UHI effect. High surface temperature also affects slab temperature difference (the top surface temperature minus the bottom surface temperature of the slab). The increased slab temperature difference induces a high possibility of cracking in concrete roads. The prime aim of this study was to reduce the slab surface temperature by using recycled glass as a fine aggregate and zeolite as cement in concrete. Recycled glass was used to replace fine aggregate in proportions of 10%, 20%, and 30% by total weight of aggregate. Zeolite replaced Portland cement in proportions of 10% and 30% for three different proportions of recycled glass concrete mixtures. Optimum proportions were determined by examining mechanical properties of samples and alkali-silica reactions. It was noticed that using recycled glass and zeolite together in concrete reduces pavement surface temperature and temperature gradient in summer.
- 24 February 2015
- Published by Springer Nature
- p. 559-568
Information Systems and Artificial Intelligence Technology Applied in Concrete Road Design
- 24 February 2015
- Published by Springer Nature
- p. 559-568
Information Systems and Artificial Intelligence Technology Applied in Concrete Road Design