Roy E. Olson
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Roy E. Olson has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- A. J. Sheehan
Major, United States Air Force, Scott AFB, United States Air Force, St. Clair County, Illinois,
1 shared publication - Cem Akgüner
Associate Professor, Dept. of Civil Engineering, TED Univ., Ankara 06420, Turkey. ORCID:
1 shared publication - K. Park
Major, United States Air Force, Scott AFB, United States Air Force, St. Clair County, Illinois,
1 shared publication - Kenneth H. Stokoe
Maseeh Department of Civil, Architectural and Environmental Engineering, University of Texas at Austin, Austin, TX, United States
1 shared publication
Latest Publications
- 15 February 2010
- Published by American Society of Civil Engineers (ASCE)
- p. 1708-1717
Estimation of Settlement of Footings under Working Loads Using Equivalent-Linear Elasticity
The use of significantly different methods for estimating settlements of footings in sands and clays, under working loads, poses a problem when intermediate soils are encountered. In this paper we propose a method of analysis based on equivalent-linear elasticity that applies to all soil types, and is simple to apply. We also propose methods to determine and/or estimate the needed soil properties. We report here on a field test of a full scale footing in silty sand and sandy silt, in which measured settlement is compared with settlement predicted using the theory and soil properties determined in the field from seismic tests and in the laboratory from dynamic tests. We also compare measured settlements with values calculated with several widely used methods and make appropriate recommendations.
- 15 February 2010
- Published by American Society of Civil Engineers (ASCE)
- p. 1708-1717
Estimation of Settlement of Footings under Working Loads Using Equivalent-Linear Elasticity
The use of significantly different methods for estimating settlements of footings in sands and clays, under working loads, poses a problem when intermediate soils are encountered. In this paper we propose a method of analysis based on equivalent-linear elasticity that applies to all soil types, and is simple to apply. We also propose methods to determine and/or estimate the needed soil properties. We report here on a field test of a full scale footing in silty sand and sandy silt, in which measured settlement is compared with settlement predicted using the theory and soil properties determined in the field from seismic tests and in the laboratory from dynamic tests. We also compare measured settlements with values calculated with several widely used methods and make appropriate recommendations.
- 10 March 2009
- Published by American Society of Civil Engineers (ASCE)
- p. 270-277
Empirical Correlations of Young's Modulus for Displacements of Driven Piles
The displacements of axially loaded single piles can be analyzed using a variety of techniques. One of the simplest is based on the theory of elasticity and, thus, is most useful for estimating movements in working range of loads. An advantage of this method is that it requires use of only two soil properties: Young's modulus and Poisson's ratio. Predictions are relatively insensitive to the selected values of Poisson's ratio. Values of Young's modulus are not usually obtained during a site investigation. In situ values in the free field may not be relevant for prediction of pile displacements because pile driving is likely to change the properties in critical regions right around the pile. Consequently, the most practical approach seems to be to find values of Young's modulus that cause predictions to match measurements and develop correlations with data from conventional field testing. Such analyses were performed using data from a number of pile load tests performed in California. The results are presented here.
- 10 March 2009
- Published by American Society of Civil Engineers (ASCE)
- p. 270-277
Empirical Correlations of Young's Modulus for Displacements of Driven Piles
The displacements of axially loaded single piles can be analyzed using a variety of techniques. One of the simplest is based on the theory of elasticity and, thus, is most useful for estimating movements in working range of loads. An advantage of this method is that it requires use of only two soil properties: Young's modulus and Poisson's ratio. Predictions are relatively insensitive to the selected values of Poisson's ratio. Values of Young's modulus are not usually obtained during a site investigation. In situ values in the free field may not be relevant for prediction of pile displacements because pile driving is likely to change the properties in critical regions right around the pile. Consequently, the most practical approach seems to be to find values of Young's modulus that cause predictions to match measurements and develop correlations with data from conventional field testing. Such analyses were performed using data from a number of pile load tests performed in California. The results are presented here.