PLPengxin Liu

Pengxin Liu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Pengxin Liu has a total of 47 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Effects of the micro-blowing on the wall heat flux of the turbulent boundary layer at Mach 6

    by Dong Sun, Hao Wang, Junyang Li, Pengxin Liu, Chen Li, Qilong Guo, Xianxu Yuan

    This study investigates micro-blowing effects on wall heat flux reduction in a Mach 6.0 turbulent boundary layer by direct numerical simulations, with three blowing strengths and a baseline case. Decomposition of the mean heat flux indicates that the reduction is predominantly attributable to convection and turbulent heat transport. The contribution of convection is associated with boundary-layer thickening, in a manner analogous to the friction-reduction mechanism, whereas the contribution of turbulent transport to the heat flux reduction is enhanced by blowing, which removes heated fluid from the near-wall region via advection. Meanwhile, micro-blowing also increases near-wall Reynolds stresses, whose work partially offsets the reduction. For fluctuations, a strong correlation with dilatation is found, with correlation coefficients rising from 0.49 (baseline) to 0.59 (strongest blowing). This stems from amplified wall-normal velocity fluctuations, which strengthen genuine compressibility and thereby enhance heat flux fluctuations. Premultiplied spectra reveal energy transfer from longitudinal streaks to traveling wave-packet structures, which dominate heat-flux generation. Conditional averaging of extreme positive events indicates that the associated coherent structures consist of counter-rotating vortices, alternating velocity streaks, and expansion/compression structures around the extreme-heat-flux location.

  • Characterising drag and wall heat flux reduction of micro-blowing control in compressible turbulent boundary layers

    by Ming Yu, Cheng Peng, Pengxin Liu, Xianxu Yuan, Chunxiao Xu

    Direct numerical simulations are performed on compressible turbulent boundary layers with micro-blowing controls applied to the walls at a free stream Mach number of 2.0 to investigate the influences of wall-blowing mass flux and spatial arrangements on drag reduction. Using law-of-the-wall for uniform blowing control, an estimation of skin friction is proposed based on Reynolds number and wall-blowing mass flux. At a given Reynolds number, the drag reduction rate increases almost logarithmically with wall-blowing mass flux within the control region. Downstream of the interaction zone, the drag reduction rate increases linearly. The disparities of the drag reduction rate in the integral sense among cases with different spatial arrangements are attributed to the asymmetric pressure gradient associated with flow compression, and expansion at the commencement and termination of the micro-blowing region.

  • Wall temperature effects of compressible turbulent boundary layers at moderate Reynolds numbers

    by Ming Yu, Jiahui Qin, Pengxin Liu, Xianxu Yuan, Chun-Xiao Xu

    In this paper, we investigate the influences of wall temperature on compressible turbulent boundary layers at free-stream Mach number 6.0 and moderate Reynolds numbers. The findings demonstrate that turbulent statistics, including the logarithmic scaling of Reynolds stresses in the overlap region, the presence of very-large-scale motions in the outer layer, and their superposition on near-wall turbulence, exhibit qualitative invariance across varying wall temperatures. However, the reduced scale separation between near-wall small-scale motions and outer-layer large-scale motions leads to a contraction in the vertical extent of Reynolds stresses adhering to the logarithmic law. Very-large-scale motions are attenuated in viscous units but intensified in global scalings due to the lower free-stream Reynolds number, following approximately the power law. Their superposition effects on near-wall turbulence, when weighted by density, show only weak dependence on wall temperature. Conversely, the modulation of near-wall velocity and temperature fluctuations by very-large-scale motions diminishes with decreasing wall temperature. Through detailed analysis of spanwise spectra in the outer region, a distinct inertial subrange obeying the classical $-5/3$ scaling law is identified, alongside a universal scaling over the dissipative range. These observations suggest that the mechanisms governing energy cascade processes and the associated small-scale turbulent fluctuations remain independent of wall temperature variations.


  • Comprehensive interscale energy transfer in homogeneous isotropic turbulence

    by Jun-Yang Li, Dong Sun, Si-Wei Dong, Peng-Xin Liu, Xian-Xu Yuan

    This study examines interscale energy transfer, conventionally denoted as the "energy cascade," in forced homogeneous isotropic turbulence. By employing spatial filtering techniques, the turbulent kinetic energy is decomposed into distinct large- and small-scale components, as well as local- and subfilter-scale constituents-specifically encompassing large-scale, small-scale, subfilter-large-scale, and subfilter-small-scale terms. Transport equations for each component are derived to establish an analytical framework elucidating the mechanisms governing cross-scale energy transfer. Within this framework, energy is primarily transferred scale-by-scale from the large-scale and subfilter-small-scale components to the small-scale and subfilter-large-scale portions of the turbulent kinetic energy. Building upon this framework, the following results and discussions are presented. First, the scaling laws governing interscale energy transfer and viscous dissipation rates are elucidated across both the dissipative and inertial subranges. Second, via Leonard decomposition, the subfilter-large-scale and subfilter-small-scale stress tensors are partitioned into Leonard, cross, and Reynolds components. In the dissipative range, interscale energy transfer is predominantly governed by the Leonard and cross-stress terms, whereas all three components contribute significantly in the inertial subrange, with their respective contributions quantitatively assessed. Third, the accuracy of several classical models in predicting interscale energy transfer rates-both from large to subfilter-large scales and from subfilter-small to small scales-is validated. Finally, investigation of extreme dissipation events reveals substantial amplification at small scales and marked alterations in scaling behavior near the inertial subrange, which are closely associated with turbulent intermittency, as evidenced by probability density distributions.

  • Coherent Structures in Thermochemical Non-equilibrium Turbulent Boundary Layers Using Clustering Method

    by Qin Jiahui, Li Junyang, Yu Ming, Liu Pengxin

    当飞行器在稠密大气高速飞行时,其表面边界层强可压缩湍流与高温非平衡效应耦合,气动环境十分复杂。拟序结构作为反映湍流边界层动力学过程的关键特征,其运动学和动力学特征对壁面摩阻热流的产生具有重要影响。为揭示热化学非平衡效应下湍流边界层的拟序结构特征,并检验Townsend附着涡模型等经典壁湍流理论的适用性,本文采用聚类连通方法,识别并提取了热化学非平衡湍流边界层中的五类拟序结构:强流向速度脉动结构、强平动温度脉动结构、强振动温度脉动结构、雷诺切应力结构以及湍流热通量结构。条件平均结果与结构空间分布表明,这五类结构均具有几何自相似性,符合Townsend附着涡模型的尺度关系。结合壁面摩阻热流的定量分解分析表明,在提取到的各类拟序结构中,速度壁附着结构与雷诺切应力结构对壁面摩阻热流的贡献最为突出。

  • Direct numerical investigation on the effects of the uniform blowing in a turbulent boundary layer at Mach 6

    by Dong Sun, Chen Li, Hao Wang, Qilong Guo, Pengxin Liu, Xianxu Yuan

    Direct numerical simulations of a turbulent boundary layer at Mach 6 were conducted to investigate the impact of uniform blowing. The boundary thickness was augmented, and the instantaneous structures were strengthened greatly in the blowing regions. The extended Renard–Deck formula was used to analyze the mechanism of friction reduction. The viscous dissipation term and convection term were identified as the main causes of friction reduction, while the turbulent kinetic energy production term increased friction. Further analysis revealed that convection in the normal direction played a dominant role in friction reduction by transporting the lower momentum fluid near the wall to the outer boundary layer, thereby decreasing the velocity gradient near the surface. The streaks of fluctuating friction coefficient broke down as the blowing strength increased, which was further validated by two-point autocorrelations. The uniform blowing can modulate the energy in the large-scale and small-scale structures by enhancing the compressibility of the flow near the wall. The conditional analysis was further performed to demonstrate the impact of the uniform blowing on the compressibility near the wall.


  • Investigations on the influence of high-enthalpy nonequilibrium on turbulent flows: Exploring similarities through direct numerical simulation and a priori analysis

    by Pengxin Liu, Jinglei Xu

    During hypersonic flight in low-altitude, vehicles encounter a complex phenomenon at their surfaces: the coupled interaction between turbulence and high-enthalpy (HE) nonequilibrium effects. This work utilizes DNS (Direct Numerical Simulation)-generated data to reveal similarities between high-enthalpy and low-enthalpy (LE) turbulence, aiming at garnering critical insights that could enhance Reynolds-Averaged Navier–Stokes (RANS) modeling. Overall, this research reveals fundamental statistical similarities between HE and LE turbulent flows, with mean velocity profiles conforming to the law of the wall, yet significant deviations in the von Kármán constant κ raise challenges for its use in RANS modeling. The Reynolds stress anisotropy tensor shows minimal sensitivity to enthalpy effects, providing potential for constructing turbulence models. Notably, Bradshaw's coefficient a1 shows a low dependence on enthalpy but reveals increased near-wall values in both HE and LE conditions compared to the incompressible scenario. Turbulent Prandtl and Schmidt numbers exhibit variations in the buffer layer (5 < y+ < 30), requiring consideration in future turbulence modeling efforts. The turbulent kinetic energy budget highlights differences in production and dissipation rates, confirming the non-negligible compressibility effects present in the viscous sublayer (0 < y+ < 5).

  • Wall attached structures of velocity and temperature fluctuations in high-speed turbulent channel flows

    by Junyang Li, Qingqing Zhou, Dong Sun, Ming Yu, Xianxu Yuan, Pengxin Liu

    本研究采用聚类连通法,提取高速槽道湍流中强流向速度脉动与强温度脉动对应的拟序结构。依据空间位置,结构被划分为壁面附着型与壁面分离型。部分壁面附着结构在尺度上呈现自相似性,符合Townsend附着涡假说,据此进一步细分为矮结构、自相似结构和高结构。条件平均结果表明,流向雷诺正应力和温度脉动在对数区满足对数率,这一现象同样与附着涡假设相符合;同时,附着结构内速度脉动与温度脉动间仍保持强雷诺比拟关系。基于RD分解恒等式的分析显示,低速高结构主导了壁面摩阻和热流的生成,而高温高结构则在法向热流传输中起主要作用。