DSDong Sun

Dong Sun

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Dong Sun has a total of 32 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Low-frequency oscillations of shock wave/turbulent boundary layer interaction over a vibrating panel

    by Hengyu Cai, Ming Yu, Bo Li, Dong Sun, Zhengyin Ye, Xianxu Yuan

    This study employs direct numerical simulations to investigate the influence of a vibrating wall panel on the oblique shock wave/turbulent boundary layer interaction flows at incoming free-stream Mach number 2.9. We examine two distinct low-frequency vibration modes, defined by their streamwise deformation patterns: a full-panel (symmetric) mode and a half-panel (antisymmetric) mode. By analysing phase-average flow quantities, we demonstrate that the antisymmetric mode primarily forces a streamwise oscillation of the separation bubble, whereas the symmetric mode amplifies its inherent expansion–contraction (‘breathing’) motion. Both panel vibrating modes enhance quasi-periodic shock oscillation and modulate the plateau in the mean wall pressure distributions. Spectral analysis confirms that low-frequency pressure fluctuations are amplified not only at the mean separation point but also in the mid-region of the panel. Through correlation analysis and dynamic mode decomposition, we establish that these vibrations lead to strong spatiotemporal coherence, associating upstream fluctuations near the separation to downstream propagation. Critically, a comparative analysis reveals that the symmetric mode facilitates significantly longer downstream propagation of pressure disturbances than the antisymmetric mode. This highlights how the spatial pattern of panel deformation, not just the vibration frequency, modulates the unsteady flow characteristics.

  • Effects of the micro-blowing on the wall heat flux of the turbulent boundary layer at Mach 6

    by Dong Sun, Hao Wang, Junyang Li, Pengxin Liu, Chen Li, Qilong Guo, Xianxu Yuan

    This study investigates micro-blowing effects on wall heat flux reduction in a Mach 6.0 turbulent boundary layer by direct numerical simulations, with three blowing strengths and a baseline case. Decomposition of the mean heat flux indicates that the reduction is predominantly attributable to convection and turbulent heat transport. The contribution of convection is associated with boundary-layer thickening, in a manner analogous to the friction-reduction mechanism, whereas the contribution of turbulent transport to the heat flux reduction is enhanced by blowing, which removes heated fluid from the near-wall region via advection. Meanwhile, micro-blowing also increases near-wall Reynolds stresses, whose work partially offsets the reduction. For fluctuations, a strong correlation with dilatation is found, with correlation coefficients rising from 0.49 (baseline) to 0.59 (strongest blowing). This stems from amplified wall-normal velocity fluctuations, which strengthen genuine compressibility and thereby enhance heat flux fluctuations. Premultiplied spectra reveal energy transfer from longitudinal streaks to traveling wave-packet structures, which dominate heat-flux generation. Conditional averaging of extreme positive events indicates that the associated coherent structures consist of counter-rotating vortices, alternating velocity streaks, and expansion/compression structures around the extreme-heat-flux location.

  • Effects of micro-blowing slit distribution on drag and heat reduction in high-speed turbulent boundary layers

    by Cheng Peng, Ming Yu, Dong Sun, Xianxu Yuan

    In this paper, we conduct direct numerical simulations to explore the mechanisms of skin friction and wall heat flux reduction in a Mach 6.0 turbulent boundary layer with micro-blowing control through periodically arranged rectangular slits. Three slit arrangements and three blowing intensities are considered. We find that micro-blowing thickens the boundary layer, weakens the near-wall velocity and temperature gradients, and thereby reduces both skin friction and wall heat flux. Within the blowing region, the drag and heat flux reduction rates increase nearly linearly with blowing intensity, while the local control performance depends strongly on slit arrangement. Farther downstream, the influence of slit geometry becomes weak, and the response is governed primarily by the overall blowing intensity. The heat flux reduction remains higher than the drag reduction, indicating a nonequilibrium recovery between momentum and temperature transport. Integral decomposition analyses show that drag reduction is mainly associated with favorable variations in the viscous and streamwise inhomogeneity contributions, whereas heat flux reduction is sustained by the variations in turbulent heat transport and molecular-stress work.

  • Comprehensive interscale energy transfer in homogeneous isotropic turbulence

    by Jun-Yang Li, Dong Sun, Si-Wei Dong, Peng-Xin Liu, Xian-Xu Yuan

    This study examines interscale energy transfer, conventionally denoted as the "energy cascade," in forced homogeneous isotropic turbulence. By employing spatial filtering techniques, the turbulent kinetic energy is decomposed into distinct large- and small-scale components, as well as local- and subfilter-scale constituents-specifically encompassing large-scale, small-scale, subfilter-large-scale, and subfilter-small-scale terms. Transport equations for each component are derived to establish an analytical framework elucidating the mechanisms governing cross-scale energy transfer. Within this framework, energy is primarily transferred scale-by-scale from the large-scale and subfilter-small-scale components to the small-scale and subfilter-large-scale portions of the turbulent kinetic energy. Building upon this framework, the following results and discussions are presented. First, the scaling laws governing interscale energy transfer and viscous dissipation rates are elucidated across both the dissipative and inertial subranges. Second, via Leonard decomposition, the subfilter-large-scale and subfilter-small-scale stress tensors are partitioned into Leonard, cross, and Reynolds components. In the dissipative range, interscale energy transfer is predominantly governed by the Leonard and cross-stress terms, whereas all three components contribute significantly in the inertial subrange, with their respective contributions quantitatively assessed. Third, the accuracy of several classical models in predicting interscale energy transfer rates-both from large to subfilter-large scales and from subfilter-small to small scales-is validated. Finally, investigation of extreme dissipation events reveals substantial amplification at small scales and marked alterations in scaling behavior near the inertial subrange, which are closely associated with turbulent intermittency, as evidenced by probability density distributions.

  • Open Access

    Direct numerical simulation of a turbulent boundary layer on a transpiration wall at Mach number 7.3

    by Hao Wang, Chen Li, Pengxin Liu, Dong Sun, Ke Jin, Xianxu Yuan


  • Direct numerical investigation on the effects of the uniform blowing in a turbulent boundary layer at Mach 6

    by Dong Sun, Chen Li, Hao Wang, Qilong Guo, Pengxin Liu, Xianxu Yuan

    Direct numerical simulations of a turbulent boundary layer at Mach 6 were conducted to investigate the impact of uniform blowing. The boundary thickness was augmented, and the instantaneous structures were strengthened greatly in the blowing regions. The extended Renard–Deck formula was used to analyze the mechanism of friction reduction. The viscous dissipation term and convection term were identified as the main causes of friction reduction, while the turbulent kinetic energy production term increased friction. Further analysis revealed that convection in the normal direction played a dominant role in friction reduction by transporting the lower momentum fluid near the wall to the outer boundary layer, thereby decreasing the velocity gradient near the surface. The streaks of fluctuating friction coefficient broke down as the blowing strength increased, which was further validated by two-point autocorrelations. The uniform blowing can modulate the energy in the large-scale and small-scale structures by enhancing the compressibility of the flow near the wall. The conditional analysis was further performed to demonstrate the impact of the uniform blowing on the compressibility near the wall.


  • Open Access

    Coherent structures and turbulent model refinement in oblique shock/hypersonic turbulent boundary layer interactions

    by Ming Yu, Dong Sun, QingQing Zhou, PengXin Liu, XianXu Yuan

    In the present study, we investigate the evolution of turbulent statistics and coherent structures in hypersonic turbulent boundary layers at the Mach number of 5 impinged by oblique shock waves generated by the wedge with the angles of 14°, 10°, and 6°, inducing strong, mild, and incipient flow separation, by exploiting direct numerical simulation databases, for the purpose of revealing the underlying flow physics that are of significance to turbulent modeling. We found that the large-scale structures are amplified within the interaction zone, manifested in the form of large-scale low- and high-speed streaks with the spanwise length scale of boundary layer thickness, and gradually decay downstream, the process of which is extremely long. The abrupt variation in the characteristic length, time, and velocity scales as well as the incompatible viscous dissipation of the mean and turbulent kinetic energy results in the incorrect predictions by the Reynolds-Averaged Navier–Stokes (RANS) equation simulations, provided the models are established based on solving the transport equations of the turbulent kinetic equation and its viscous dissipation (k−ε or k−ω models, for instance). To amend this issue, we propose to refine the parameters in the model as the functions of wall pressure, the flow quantities related to multiple flow features. The RANS simulations with the k−ω SST model utilizing the proposed refinement improve greatly the accuracy of the skin friction, wall heat flux, and Reynolds shear stress downstream of the interaction zone, and the wall pressure distributions in hypersonic turbulence over compression ramp, suggesting its promising prospect in engineering applications.


  • Open Access

    Investigation on the generation and propagation mechanism of triple-point structures on rotating detonation front

    by Pengxin Liu, Hongmin Su, Qilong Guo, Dong Sun, Chen Li

    Based on the Navier–Stokes equation with chemical reaction kinetics, rotating detonation waves are numerically simulated using premixed reactants H2/air at a stoichiometric ratio. The triple-point structure on the detonation front is captured. The self-sustained combustion process in rotating detonation waves is analyzed. Through innovatively utilizing the cell structure, the essential moments of the generation and propagation of new triple-point structures at the unbounded side of the rotating detonation front are discriminated successfully. The generation model of the new triple-point structure is proposed. The new model helps deeply understand the essence of self-sustained combustion in rotating detonation waves, which may serve as guidance in the engineering design of the rotating detonation engines.


  • High-enthalpy effects on turbulent coherent structures over a curved compression corner

    by Dong Sun, Qilong Guo, Xianxu Yuan, Chen Li, Pengxin Liu