Arne Ilseng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Arne Ilseng has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Bjørn H. Skallerud
Biomechanics Department of Structural Engineering NTNU Norwegian University of Science and Technology 7491 Trondheim Norway
4 shared publications- Bjorn Torger Stokke
Norwegian University of Science and Technology (NTNU)
3 shared publications - Victorien Prot
Biomechanics, Department of Structural Engineering, The Norwegian University of Science and Technology (NTNU), NO-7491, Trondheim, Norway
3 shared publications Arild H. Clausen
2 shared publications- Bjørn Skallerud
Department of Structural Engineering, Norwegian University of Science and Technology, Trondheim, Norway
2 shared publications - Arild Holm Clausen
Structural Impact Laboratory (SIMLab), Department of Structural Engineering, Norwegian University of Science and Technology (NTNU), NO-7491 Trondheim, Norway
1 shared publication
Latest Publications
- 4 February 2021
- Published by Wiley in Journal of Applied Mechanics
- Vol. 88 (5) , 1-15
A Perturbation Analysis Approach for Studying the Effect of Swelling Kinetics on Instabilities in Hydrogel Plates
The onset of surface instability during diffusion-driven swelling of hydrogels depends on the kinetics of the swelling process. Here, we outline a perturbation analysis framework using a finite difference approach for calculating the stability limit of swelling hydrogel plates with graded material properties accounting for kinetic effects. The framework is implemented as a Python routine which is made freely available. Results obtained for bilayered hydrogel plates illustrate that the onset of instability occurs earlier in time and at a lower global swelling ratio when kinetics is accounted for compared to the homogeneous swelling case. This work presents an accessible calculation tool for stability analysis of swelling gels, providing input for the design of novel hydrogel systems.
- 4 February 2021
- Published by Wiley in Journal of Applied Mechanics
- Vol. 88 (5) , 1-15
A Perturbation Analysis Approach for Studying the Effect of Swelling Kinetics on Instabilities in Hydrogel Plates
The onset of surface instability during diffusion-driven swelling of hydrogels depends on the kinetics of the swelling process. Here, we outline a perturbation analysis framework using a finite difference approach for calculating the stability limit of swelling hydrogel plates with graded material properties accounting for kinetic effects. The framework is implemented as a Python routine which is made freely available. Results obtained for bilayered hydrogel plates illustrate that the onset of instability occurs earlier in time and at a lower global swelling ratio when kinetics is accounted for compared to the homogeneous swelling case. This work presents an accessible calculation tool for stability analysis of swelling gels, providing input for the design of novel hydrogel systems.
- Open Access
Donnan Contribution and Specific Ion Effects in Swelling of Cationic Hydrogels are Additive: Combined High-Resolution Experiments and Finite Element Modeling
Finite element modeling applied to analyze experimentally determined hydrogel swelling data provides quantitative description of the hydrogel in the aqueous solutions with well-defined ionic content and environmental parameters. In the present study, we expand this strategy to analysis of swelling of hydrogels over an extended concentration of salt where the Donnan contribution and specific ion effects are dominating at different regimes. Dynamics and equilibrium swelling were determined for acrylamide and cationic acrylamide-based hydrogels by high-resolution interferometry technique for step-wise increase in NaCl and NaBr concentration up to 2 M. Although increased hydrogel swelling volume with increasing salt concentration was the dominant trend for the uncharged hydrogel, the weakly charged cationic hydrogel was observed to shrink for increasing salt concentration up to 0.1 M, followed by swelling at higher salt concentrations. The initial shrinking is due to the ionic equilibration accounted for by a Donnan term. Comparison of the swelling responses at high NaCl and NaBr concentrations between the uncharged and the cationic hydrogel showed similar specific ion effects. This indicates that the ion non-specific Donnan contribution and specific ion effects are additive in the case where they are occurring in well separated ranges of salt concentration. We develop a novel finite element model including both these mechanisms to account for the observed swelling in aqueous salt solution. In particular, a salt-specific, concentration-dependent Flory–Huggins parameter was introduced for the specific ion effects. This is the first report on finite element modeling of hydrogels including specific ionic effects and underpins improvement of the mechanistic insight of hydrogel swelling that can be used to predict its response to environmental change.
Open AccessDonnan Contribution and Specific Ion Effects in Swelling of Cationic Hydrogels are Additive: Combined High-Resolution Experiments and Finite Element Modeling
Finite element modeling applied to analyze experimentally determined hydrogel swelling data provides quantitative description of the hydrogel in the aqueous solutions with well-defined ionic content and environmental parameters. In the present study, we expand this strategy to analysis of swelling of hydrogels over an extended concentration of salt where the Donnan contribution and specific ion effects are dominating at different regimes. Dynamics and equilibrium swelling were determined for acrylamide and cationic acrylamide-based hydrogels by high-resolution interferometry technique for step-wise increase in NaCl and NaBr concentration up to 2 M. Although increased hydrogel swelling volume with increasing salt concentration was the dominant trend for the uncharged hydrogel, the weakly charged cationic hydrogel was observed to shrink for increasing salt concentration up to 0.1 M, followed by swelling at higher salt concentrations. The initial shrinking is due to the ionic equilibration accounted for by a Donnan term. Comparison of the swelling responses at high NaCl and NaBr concentrations between the uncharged and the cationic hydrogel showed similar specific ion effects. This indicates that the ion non-specific Donnan contribution and specific ion effects are additive in the case where they are occurring in well separated ranges of salt concentration. We develop a novel finite element model including both these mechanisms to account for the observed swelling in aqueous salt solution. In particular, a salt-specific, concentration-dependent Flory–Huggins parameter was introduced for the specific ion effects. This is the first report on finite element modeling of hydrogels including specific ionic effects and underpins improvement of the mechanistic insight of hydrogel swelling that can be used to predict its response to environmental change.
- Open Access
Buckling initiation in layered hydrogels during transient swelling
Subjected to compressive stresses, soft polymers with stiffness gradients can display various buckling patterns. These compressive stresses can have different origins, like mechanical forces, temperature changes, or, for hydrogel materials, osmotic swelling. Here, we focus on the influence of the transient nature of osmotic swelling on the initiation of buckling in confined layered hydrogel structures. A constitutive model for transient hydrogel swelling is outlined and implemented as a user-subroutine for the commercial finite element software Abaqus. The finite element procedure is benchmarked against linear perturbation analysis results for equilibrium swelling showing excellent correspondence. Based on the finite element results we conclude that the initiation of buckling in a two-layered hydrogel structure is highly affected by transient swelling effects, with instability emerging at lower swelling ratios and later in time with a lower diffusion coefficient. In addition, for hard-on-soft systems the wavelength of the buckling pattern is found to decrease as the diffusivity of the material is reduced for gels with a relatively low stiffness gradient between the substrate and the upper film. This study highlights the difference between equilibrium and transient swelling when it comes to the onset of instability in hydrogels, which is believed to be of importance as a fundamental aspect of swelling as well as providing input to guiding principles in the design of specific hydrogel systems.
Open AccessBuckling initiation in layered hydrogels during transient swelling
Subjected to compressive stresses, soft polymers with stiffness gradients can display various buckling patterns. These compressive stresses can have different origins, like mechanical forces, temperature changes, or, for hydrogel materials, osmotic swelling. Here, we focus on the influence of the transient nature of osmotic swelling on the initiation of buckling in confined layered hydrogel structures. A constitutive model for transient hydrogel swelling is outlined and implemented as a user-subroutine for the commercial finite element software Abaqus. The finite element procedure is benchmarked against linear perturbation analysis results for equilibrium swelling showing excellent correspondence. Based on the finite element results we conclude that the initiation of buckling in a two-layered hydrogel structure is highly affected by transient swelling effects, with instability emerging at lower swelling ratios and later in time with a lower diffusion coefficient. In addition, for hard-on-soft systems the wavelength of the buckling pattern is found to decrease as the diffusivity of the material is reduced for gels with a relatively low stiffness gradient between the substrate and the upper film. This study highlights the difference between equilibrium and transient swelling when it comes to the onset of instability in hydrogels, which is believed to be of importance as a fundamental aspect of swelling as well as providing input to guiding principles in the design of specific hydrogel systems.
- Open Access
- 1 July 2019
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 128, 219-238
Buckling initiation in layered hydrogels during transient swelling
- 1 July 2019
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 128, 219-238
Open AccessBuckling initiation in layered hydrogels during transient swelling
- Open Access
- 1 October 2017
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 107, 33-48
Volume growth during uniaxial tension of particle-filled elastomers at various temperatures – Experiments and modelling
- 1 October 2017
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 107, 33-48
Open AccessVolume growth during uniaxial tension of particle-filled elastomers at various temperatures – Experiments and modelling
- 1 March 2017
- Published by Elsevier in Mechanics of Materials
- Vol. 106, 44-57
An experimental and numerical study on the volume change of particle-filled elastomers in various loading modes
- 1 March 2017
- Published by Elsevier in Mechanics of Materials
- Vol. 106, 44-57
An experimental and numerical study on the volume change of particle-filled elastomers in various loading modes
- 1 February 2016
- Published by Elsevier in Polymer Testing
- Vol. 49, 128-136
Tension behaviour of HNBR and FKM elastomers for a wide range of temperatures
- 1 February 2016
- Published by Elsevier in Polymer Testing
- Vol. 49, 128-136
Tension behaviour of HNBR and FKM elastomers for a wide range of temperatures