Mariia Lukaniuk
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Mariia Lukaniuk has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Ivan Z. Indutnyi
National Academy of Sciences of Ukraine
4 shared publications - Victor Myn’ko
V. Lashkaryov Institute of Semiconductor Physics, Nat. Acad. of Sci. of Ukraine, Prospect Nauky, 41, 03028 Kyiv, Ukraine
4 shared publications - Petro Shepeliavyi
NAS Ukraine, V Lashkaryov Inst Semicond Phys, 41 Prosp Nauky, UA-03680 Kiev, Ukraine
3 shared publications - Viktor A. Dan’kO
National Academy of Sciences of Ukraine
3 shared publications - Andrii A. Korchovyi
V. Lashkaryov Institute of Semiconductors Physics, National Academy of Science of Ukraine, 41 Nauky Ave., 03028 Kyiv, Ukraine
2 shared publications Mykola Dmitruk
V. Lashkaryov Institute of Semiconductor Physics, Nat. Acad. of Sci. of Ukraine, 45, Prospect Nauky, 03028, Kyiv, Ukraine
2 shared publications
Latest Publications
- 1 June 2017
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) in Ukrainian Journal of Physics
- Vol. 62 (5) , 365-371
Nanostructured Au Chips with Enhanced Sensitivity for Sensors Based on Surface Plasmon Resonance
The enhancement of the sensitivity of a surface-plasmon-resonance refractometer by forming a periodic relief in the form of a grating with a submicron period on the surface of an Au chip has been studied. Periodic reliefs with the spatial frequency v = (3370 ± 5) line/mm and various depths were formed on the Au film surface using interference lithography and vacuum chalcogenide photoresists. The degree of refractometer sensitivity enhancement and the variation interval of the environment refractive index, Δn, in which this enhancement is observed, are found to depend on the grating relief depth. The interval Δn decreases with the growth of the relief depth, whereas the sensitivity increases from 110 deg/RIU for a standard chip to 154 and 363 deg/RIU for structured chips with relief depths of 11.7 ± 2 and 18.5 ± 2 nm, respectively.
- 1 June 2017
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) in Ukrainian Journal of Physics
- Vol. 62 (5) , 365-371
Nanostructured Au Chips with Enhanced Sensitivity for Sensors Based on Surface Plasmon Resonance
The enhancement of the sensitivity of a surface-plasmon-resonance refractometer by forming a periodic relief in the form of a grating with a submicron period on the surface of an Au chip has been studied. Periodic reliefs with the spatial frequency v = (3370 ± 5) line/mm and various depths were formed on the Au film surface using interference lithography and vacuum chalcogenide photoresists. The degree of refractometer sensitivity enhancement and the variation interval of the environment refractive index, Δn, in which this enhancement is observed, are found to depend on the grating relief depth. The interval Δn decreases with the growth of the relief depth, whereas the sensitivity increases from 110 deg/RIU for a standard chip to 154 and 363 deg/RIU for structured chips with relief depths of 11.7 ± 2 and 18.5 ± 2 nm, respectively.
- Open Access
- 11 March 2017
- Published by Springer Nature in Discover Nano
- Vol. 12 (1) , 190
Au Gratings Fabricated by Interference Lithography for Experimental Study of Localized and Propagating Surface Plasmons
Optical properties of high-frequency Au gratings with a fixed period (296.6 ± 0.5 nm) and a variable modulation depth are studied using measurements of spectral and angular dependence of transmission and reflection of polarized light in order to build the dispersion curves of excited optical modes and to identify their types. It was shown that in gratings with small modulation depth only propagating surface plasmon-polaritons (SPP) modes were observed. With increasing of modulation depth, the intensity of SPP decreases and localized plasmon (LP) resonance appears, which is more intense at small incident angles, and overlaps with the SPP modes. For grating with isolated grooves (nanowires), mostly LP resonance is observed. After additional deposition of gold onto grating with isolated grooves, the intensity of the SPP mode increases again, and the LP band maximum shifts to longer wavelengths.
- 11 March 2017
- Published by Springer Nature in Discover Nano
- Vol. 12 (1) , 190
Open AccessAu Gratings Fabricated by Interference Lithography for Experimental Study of Localized and Propagating Surface Plasmons
Optical properties of high-frequency Au gratings with a fixed period (296.6 ± 0.5 nm) and a variable modulation depth are studied using measurements of spectral and angular dependence of transmission and reflection of polarized light in order to build the dispersion curves of excited optical modes and to identify their types. It was shown that in gratings with small modulation depth only propagating surface plasmon-polaritons (SPP) modes were observed. With increasing of modulation depth, the intensity of SPP decreases and localized plasmon (LP) resonance appears, which is more intense at small incident angles, and overlaps with the SPP modes. For grating with isolated grooves (nanowires), mostly LP resonance is observed. After additional deposition of gold onto grating with isolated grooves, the intensity of the SPP mode increases again, and the LP band maximum shifts to longer wavelengths.
- Open Access
- 1 December 2016
- Published by Springer Nature in Discover Nano
- Vol. 11 (1) , 535
Enhancing Surface Plasmon Resonance Detection Using Nanostructured Au Chips
The increase of the sensitivity of surface plasmon resonance (SPR) refractometers was studied experimentally by forming a periodic relief in the form of a grating with submicron period on the surface of the Au-coated chip. Periodic reliefs of different depths and spatial frequency were formed on the Au film surface using interference lithography and vacuum chalcogenide photoresists. Spatial frequencies of the grating were selected close to the conditions of Bragg reflection of plasmons for the working wavelength of the SPR refractometer and the used environment (solution of glycerol in water). It was found that the degree of refractometer sensitivity enhancement and the value of the interval of environment refractive index variation, Δn, in which this enhancement is observed, depend on the depth of the grating relief. By increasing the depth of relief from 13.5 ± 2 nm to 21.0 ± 2 nm, Δn decreased from 0.009 to 0.0031, whereas sensitivity increased from 110 deg./RIU (refractive index unit) for a standard chip up to 264 and 484 deg./RIU for the nanostructured chips, respectively. Finally, it was shown that the working range of the sensor can be adjusted to the refractive index of the studied environment by changing the spatial frequency of the grating, by modification of the chip surface or by rotation of the chip.
- 1 December 2016
- Published by Springer Nature in Discover Nano
- Vol. 11 (1) , 535
Open AccessEnhancing Surface Plasmon Resonance Detection Using Nanostructured Au Chips
The increase of the sensitivity of surface plasmon resonance (SPR) refractometers was studied experimentally by forming a periodic relief in the form of a grating with submicron period on the surface of the Au-coated chip. Periodic reliefs of different depths and spatial frequency were formed on the Au film surface using interference lithography and vacuum chalcogenide photoresists. Spatial frequencies of the grating were selected close to the conditions of Bragg reflection of plasmons for the working wavelength of the SPR refractometer and the used environment (solution of glycerol in water). It was found that the degree of refractometer sensitivity enhancement and the value of the interval of environment refractive index variation, Δn, in which this enhancement is observed, depend on the depth of the grating relief. By increasing the depth of relief from 13.5 ± 2 nm to 21.0 ± 2 nm, Δn decreased from 0.009 to 0.0031, whereas sensitivity increased from 110 deg./RIU (refractive index unit) for a standard chip up to 264 and 484 deg./RIU for the nanostructured chips, respectively. Finally, it was shown that the working range of the sensor can be adjusted to the refractive index of the studied environment by changing the spatial frequency of the grating, by modification of the chip surface or by rotation of the chip.
- 1 January 2016
- Published by Walter de Gruyter GmbH
The nanostructuring of surfaces and films using interference lithography and chalcogenide photoresist
The reversible and transient photostimulated structural changes in annealed chalcogenide glass (ChG) layers were used to form interference periodic structures on semiconductor surfaces and metal films. It was shown that negative-action etchants based on amines dissolve illuminated parts of a chalcogenide film, i.e., act as positive etchants. The diffraction gratings and 2-D interference structures on germanium ChGs - more environmentally acceptable compounds than traditionally used arsenic chalcogenides - were recorded, and their characteristics were studied.
- 1 January 2016
- Published by Walter de Gruyter GmbH
The nanostructuring of surfaces and films using interference lithography and chalcogenide photoresist
The reversible and transient photostimulated structural changes in annealed chalcogenide glass (ChG) layers were used to form interference periodic structures on semiconductor surfaces and metal films. It was shown that negative-action etchants based on amines dissolve illuminated parts of a chalcogenide film, i.e., act as positive etchants. The diffraction gratings and 2-D interference structures on germanium ChGs - more environmentally acceptable compounds than traditionally used arsenic chalcogenides - were recorded, and their characteristics were studied.
- Open Access
- 29 December 2015
- Published by Springer Nature in Discover Nano
- Vol. 10 (1) , 1-8
Fabrication of Periodic Plasmonic Structures Using Interference Lithography and Chalcogenide Photoresist
This study reports on the employment of the interference lithography (IL) technique, using photoresist based on the chalcogenide glass (ChG) films, for fabrication of one-dimensional (gratings) and two-dimensional (arrays) periodic plasmonic structures on the surface of glass plates. The IL technique was optimized for patterning of the Au and Al layers and formation of gratings and arrays with a spatial frequency of 2000 mm−1. Optical properties of obtained structures were studied using measurements of spectral and angular dependence of transmission and reflection of polarized light. It was shown that the spectral and angular position of the surface plasmon polariton and local surface plasmon resonance, which are observed in these samples, can be adjusted over a wide range by selecting the geometric parameters of structures and technological modes of their manufacturing.
- 29 December 2015
- Published by Springer Nature in Discover Nano
- Vol. 10 (1) , 1-8
Open AccessFabrication of Periodic Plasmonic Structures Using Interference Lithography and Chalcogenide Photoresist
This study reports on the employment of the interference lithography (IL) technique, using photoresist based on the chalcogenide glass (ChG) films, for fabrication of one-dimensional (gratings) and two-dimensional (arrays) periodic plasmonic structures on the surface of glass plates. The IL technique was optimized for patterning of the Au and Al layers and formation of gratings and arrays with a spatial frequency of 2000 mm−1. Optical properties of obtained structures were studied using measurements of spectral and angular dependence of transmission and reflection of polarized light. It was shown that the spectral and angular position of the surface plasmon polariton and local surface plasmon resonance, which are observed in these samples, can be adjusted over a wide range by selecting the geometric parameters of structures and technological modes of their manufacturing.
- Open Access
- 27 February 2015
- Published by Springer Nature in Discover Nano
- Vol. 10 (1) , 83
The nanostructuring of surfaces and films using interference lithography and chalcogenide photoresist
The reversible and transient photostimulated structural changes in annealed chalcogenide glass (ChG) layers were used to form interference periodic structures on semiconductor surfaces and metal films. It was shown that negative-action etchants based on amines dissolve illuminated parts of a chalcogenide film, i.e., act as positive etchants. The diffraction gratings and 2-D interference structures on germanium ChGs - more environmentally acceptable compounds than traditionally used arsenic chalcogenides - were recorded, and their characteristics were studied.
- 27 February 2015
- Published by Springer Nature in Discover Nano
- Vol. 10 (1) , 83
Open AccessThe nanostructuring of surfaces and films using interference lithography and chalcogenide photoresist
The reversible and transient photostimulated structural changes in annealed chalcogenide glass (ChG) layers were used to form interference periodic structures on semiconductor surfaces and metal films. It was shown that negative-action etchants based on amines dissolve illuminated parts of a chalcogenide film, i.e., act as positive etchants. The diffraction gratings and 2-D interference structures on germanium ChGs - more environmentally acceptable compounds than traditionally used arsenic chalcogenides - were recorded, and their characteristics were studied.