Jinghong Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Jinghong Chen has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Yuxuan Tang
Dept. of Electrical and Computer Engineering University of Houston N308 Engineering Bldg 1 4726 Calhoun Road 77204-4005 Houston TX USA
3 shared publications - Todd Townsend
Dept. of Electrical and Computer Engineering University of Houston N308 Engineering Bldg 1 4726 Calhoun Road 77204-4005 Houston TX USA
2 shared publications B. Vosooghi
Department of Electrical and Computer Engineering, University of Houston, Houston, TX 77004, U.S.A.
1 shared publication- Cheng Fang
Department of Electrical and Computer Engineering, Texas A&M University, College Station, TX 77843, USA
1 shared publication D. Gong
Department of Physics, Southern Methodist University, Dallas, TX 75275, U.S.A.
1 shared publication- Hao Deng
Department of Electrical and Computer Engineering, University of Houston, Houston, TX, USA
1 shared publication
Latest Publications
- Open Access
A Wideband Noise and Harmonic Distortion Canceling Low-Noise Amplifier for High-Frequency Ultrasound Transducers
This paper presents a wideband low-noise amplifier (LNA) front-end with noise and distortion cancellation for high-frequency ultrasound transducers. The LNA employs a resistive shunt-feedback structure with a feedforward noise-canceling technique to accomplish both wideband impedance matching and low noise performance. A complementary CMOS topology was also developed to cancel out the second-order harmonic distortion and enhance the amplifier linearity. A high-frequency ultrasound (HFUS) and photoacoustic (PA) imaging front-end, including the proposed LNA and a variable gain amplifier (VGA), was designed and fabricated in a 180 nm CMOS process. At 80 MHz, the front-end achieves an input-referred noise density of 1.36 nV/sqrt (Hz), an input return loss (S11) of better than −16 dB, a voltage gain of 37 dB, and a total harmonic distortion (THD) of −55 dBc while dissipating a power of 37 mW, leading to a noise efficiency factor (NEF) of 2.66.
Open AccessA Wideband Noise and Harmonic Distortion Canceling Low-Noise Amplifier for High-Frequency Ultrasound Transducers
This paper presents a wideband low-noise amplifier (LNA) front-end with noise and distortion cancellation for high-frequency ultrasound transducers. The LNA employs a resistive shunt-feedback structure with a feedforward noise-canceling technique to accomplish both wideband impedance matching and low noise performance. A complementary CMOS topology was also developed to cancel out the second-order harmonic distortion and enhance the amplifier linearity. A high-frequency ultrasound (HFUS) and photoacoustic (PA) imaging front-end, including the proposed LNA and a variable gain amplifier (VGA), was designed and fabricated in a 180 nm CMOS process. At 80 MHz, the front-end achieves an input-referred noise density of 1.36 nV/sqrt (Hz), an input return loss (S11) of better than −16 dB, a voltage gain of 37 dB, and a total harmonic distortion (THD) of −55 dBc while dissipating a power of 37 mW, leading to a noise efficiency factor (NEF) of 2.66.
- Open Access
- 20 April 2020
- Published by Sissa Medialab Srl
- Vol. 370, 016
A SiPM Readout Front-end with Fast Pulse Generation and Successive-Approximation Register ADC
A low-power front-end with on-chip fast pulse generation and customized 10-bit single-ended SAR ADC is developed for SiPM readout design. The on-chip fast pulse generation improves the timing resolution without the need of extra I/O pins. The proposed SAR ADC, reusing the SiPM charge integrator and eliminating the power-hungry charging sensitive amplifier, consumes significantly less power compared with conventional solutions. Designed in a 0.18 μm 1P6M bulk CMOS technology, the front-end contains 16 channels of SiPM readouts, and each channel consumes a power of 3.8 mW. With on-chip HPF to shape input signals, the fast pulse generation approach reduces the long-tailed SPE pulses width from 50 ns to 3 ns. At 16 MS/s, the SAR ADC consumes 743 μW from a 1.8 V supply and achieves a SNDR of 57.53 dB and a SFDR of 66.31 dB, respectively.
- 20 April 2020
- Published by Sissa Medialab Srl
- Vol. 370, 016
Open AccessA SiPM Readout Front-end with Fast Pulse Generation and Successive-Approximation Register ADC
A low-power front-end with on-chip fast pulse generation and customized 10-bit single-ended SAR ADC is developed for SiPM readout design. The on-chip fast pulse generation improves the timing resolution without the need of extra I/O pins. The proposed SAR ADC, reusing the SiPM charge integrator and eliminating the power-hungry charging sensitive amplifier, consumes significantly less power compared with conventional solutions. Designed in a 0.18 μm 1P6M bulk CMOS technology, the front-end contains 16 channels of SiPM readouts, and each channel consumes a power of 3.8 mW. With on-chip HPF to shape input signals, the fast pulse generation approach reduces the long-tailed SPE pulses width from 50 ns to 3 ns. At 16 MS/s, the SAR ADC consumes 743 μW from a 1.8 V supply and achieves a SNDR of 57.53 dB and a SFDR of 66.31 dB, respectively.
- Open Access
- 9 March 2020
- Published by Sissa Medialab Srl
- Vol. 370, 094
Highly-linear FPGA-based Data Acquisition System for Multi-channel SiPM Readout
A 32-channel, 15 ps resolution, Kintex 7 FPGA-based data acquisition (DAQ) system for time-of-flight (TOF) and time-over-threshold (TOT) SiPM readout is demonstrated along with a comparison to previous works. Focusing on modern FPGA concerns such as clock skew and bin realignment, the implementation difficulties of FPGA-based TDCs are discussed including bubble error, zero length bins, inter-clock region nonlinearity, and chain overflow. Linearity of the TDC is improved by multichain averaging with comparison of 1, 2, and 4 chains pre and post-calibration. Measurement results of the proposed TDC include 11 ps mean bin size, a differential nonlinearity (DNL) of less than 4 ps, and an integral nonlinearity (INL) of less than 10 ps.
- 9 March 2020
- Published by Sissa Medialab Srl
- Vol. 370, 094
Open AccessHighly-linear FPGA-based Data Acquisition System for Multi-channel SiPM Readout
A 32-channel, 15 ps resolution, Kintex 7 FPGA-based data acquisition (DAQ) system for time-of-flight (TOF) and time-over-threshold (TOT) SiPM readout is demonstrated along with a comparison to previous works. Focusing on modern FPGA concerns such as clock skew and bin realignment, the implementation difficulties of FPGA-based TDCs are discussed including bubble error, zero length bins, inter-clock region nonlinearity, and chain overflow. Linearity of the TDC is improved by multichain averaging with comparison of 1, 2, and 4 chains pre and post-calibration. Measurement results of the proposed TDC include 11 ps mean bin size, a differential nonlinearity (DNL) of less than 4 ps, and an integral nonlinearity (INL) of less than 10 ps.
- 1 January 2016
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 11 (01) , C01010
A 12-bit 60-MS/s 36-mW SHA-less opamp-sharing pipeline ADC in 130 nm CMOS
This paper presents a 12-bit 60-MS/s SHA-less opamp-sharing pipeline analog-to-digital converter (ADC) implemented in a 0.13-μ m CMOS technology. A switch-embedded dual-input current-reused operational transconductance amplifier (OTA) with an overlapping two-phase clocking scheme is proposed to achieve low power consumption and eliminate the non-resetting and memory effects observed in conventional opamp-sharing techniques. To further reduce the power consumption, the ADC also incorporates a SHA-less multi-bit structure. The ADC achieves a signal-to-noise and distortion ratio of 64.9 dB and a spurious-free dynamic range of 77.1 dB at 60 MS/s. It occupies 2.3 mm 2 of area and consumes 36 mW of power under a 1.2-V supply.
- 1 January 2016
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 11 (01) , C01010
A 12-bit 60-MS/s 36-mW SHA-less opamp-sharing pipeline ADC in 130 nm CMOS
This paper presents a 12-bit 60-MS/s SHA-less opamp-sharing pipeline analog-to-digital converter (ADC) implemented in a 0.13-μ m CMOS technology. A switch-embedded dual-input current-reused operational transconductance amplifier (OTA) with an overlapping two-phase clocking scheme is proposed to achieve low power consumption and eliminate the non-resetting and memory effects observed in conventional opamp-sharing techniques. To further reduce the power consumption, the ADC also incorporates a SHA-less multi-bit structure. The ADC achieves a signal-to-noise and distortion ratio of 64.9 dB and a spurious-free dynamic range of 77.1 dB at 60 MS/s. It occupies 2.3 mm 2 of area and consumes 36 mW of power under a 1.2-V supply.