François Lapicque
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
François Lapicque has a total of 72 co-authors. Here are the top co-authors by number of shared publications:
- Caroline Bonnet5 shared publications
- Stéphane Raël
Universit de Lorraine, GREEN, Nancy, France
5 shared publications Anantrao Vijay Shirsath
3 shared publications- Eric Meux
University of Lorraine, CNRS, IJL, F-57000, Metz, France
3 shared publications - Sophie Legeai
CNRS, IJL, University of Lorraine, Metz, France
3 shared publications Marie-Noëlle Pons
LRGP, UMR 7274, CNRS - Université de Lorraine, 1 rue Grandville, 54000, Nancy, France
2 shared publications
Latest Publications
- Open Access
- 9 October 2026
- Published by Elsevier in Electrochimica Acta
- Vol. 581
Development and status of electrochemical engineering
- 9 October 2026
- Published by Elsevier in Electrochimica Acta
- Vol. 581
Open AccessDevelopment and status of electrochemical engineering
- 3 September 2025
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 55 (10) , 2645-2658
Thick silver electrodeposits from ethaline and propeline deep eutectic solvents toward recovery of precious metals from waste
- 3 September 2025
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 55 (10) , 2645-2658
Thick silver electrodeposits from ethaline and propeline deep eutectic solvents toward recovery of precious metals from waste
- 21 July 2025
- Published by Elsevier in Journal of Power Sources
- Vol. 654
Physical-based reduced model of lithium-ion batteries dedicated to observer design for embedded applications
- 21 July 2025
- Published by Elsevier in Journal of Power Sources
- Vol. 654
Physical-based reduced model of lithium-ion batteries dedicated to observer design for embedded applications
- Open Access
- 8 May 2024
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Advances
- Vol. 3 (6) , 875-884
Electroleaching and electrodeposition of silver in ethaline 1 : 2 and propeline 1 : 3: transport properties and electrode phenomena
In view of selectively recovering precious contents in electronic waste by combined electrochemical leaching and deposition step in the same cell, this study presents electrochemical investigations of the two reactions conducted in green deep eutectic solvents (DESs) for the case of silver. In addition to ethaline 1 : 2 formed from choline chloride and ethylene glycol, propeline 1 : 3 with less nocive propylene glycol was tested. Determination of the density, viscosity and conductivity of the two DES depending on temperature and their water content could lead to ionicity values from 0.70 to 0.90, with a negative effect of these operating parameters. Pure silver can be leached at 1 mA cm−2 with faradaic yield near 100% from the two DES, provided sufficient temperature and water content below 5 wt%. Electrodeposition was thoroughly examined by cyclic voltammetry and amperometry at transient or steady state at a rotating electrode, leading to Ag(I) diffusivity values in the two DES. Kinetic parameters of the electrodeposition reaction, modelled as irreversible, were also estimated from cyclic voltammograms. Thick silver deposits were produced in 24 h-long tests at 60 °C and 0.25 mA cm−2 in a dry atmosphere with nearly 100% current efficiency. The deposits were formed by little coalesced regular grains of size 15–20 μm and exhibiting fair adherence.
- 8 May 2024
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Advances
- Vol. 3 (6) , 875-884
Open AccessElectroleaching and electrodeposition of silver in ethaline 1 : 2 and propeline 1 : 3: transport properties and electrode phenomena
In view of selectively recovering precious contents in electronic waste by combined electrochemical leaching and deposition step in the same cell, this study presents electrochemical investigations of the two reactions conducted in green deep eutectic solvents (DESs) for the case of silver. In addition to ethaline 1 : 2 formed from choline chloride and ethylene glycol, propeline 1 : 3 with less nocive propylene glycol was tested. Determination of the density, viscosity and conductivity of the two DES depending on temperature and their water content could lead to ionicity values from 0.70 to 0.90, with a negative effect of these operating parameters. Pure silver can be leached at 1 mA cm−2 with faradaic yield near 100% from the two DES, provided sufficient temperature and water content below 5 wt%. Electrodeposition was thoroughly examined by cyclic voltammetry and amperometry at transient or steady state at a rotating electrode, leading to Ag(I) diffusivity values in the two DES. Kinetic parameters of the electrodeposition reaction, modelled as irreversible, were also estimated from cyclic voltammograms. Thick silver deposits were produced in 24 h-long tests at 60 °C and 0.25 mA cm−2 in a dry atmosphere with nearly 100% current efficiency. The deposits were formed by little coalesced regular grains of size 15–20 μm and exhibiting fair adherence.
- 25 March 2022
- Published by Elsevier in Journal of Power Sources
- Vol. 531
Analysis of gas transport phenomena in a polymer electrolyte fuel cell by electrochemical pressure impedance spectroscopy
- 25 March 2022
- Published by Elsevier in Journal of Power Sources
- Vol. 531
Analysis of gas transport phenomena in a polymer electrolyte fuel cell by electrochemical pressure impedance spectroscopy
- Open Access
- 1 March 2022
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 169 (3) , 034503
Electrochemical Pressure Impedance Spectroscopy for Polymer Electrolyte Membrane Fuel Cells: A Combined Modeling and Experimental Analysis
Electrochemical pressure impedance spectroscopy (EPIS) has recently been developed as a potential diagnosis tool for polymer electrolyte membrane fuel cells (PEMFC). It is based on analyzing the frequency response of the cell voltage with respect to an excitation of the gas-phase pressure. We present here a combined modeling and experimental study of EPIS. A pseudo-two-dimensional PEMFC model was parameterized to a 100 cm2 laboratory cell installed in its test bench, and used to reproduce steady-state cell polarization and electrochemical impedance spectra (EIS). Pressure impedance spectra were obtained both in experiment and simulation by applying a harmonic pressure excitation at the cathode outlet. The model shows good agreement with experimental data for current densities ≤ 0.4 A cm−2. Here it allows a further simulative analysis of observed EPIS features, including the magnitude and shape of spectra. Key findings include a strong influence of the humidifier gas volume on EPIS and a substantial increase in oxygen partial pressure oscillations towards the channel outlet at the resonance frequency. At current densities ≥ 0.8 A cm−2 the experimental EIS and EPIS data cannot be fully reproduced. This deviation might be associated with the formation and transport of liquid water, which is not included in the model.
- 1 March 2022
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 169 (3) , 034503
Open AccessElectrochemical Pressure Impedance Spectroscopy for Polymer Electrolyte Membrane Fuel Cells: A Combined Modeling and Experimental Analysis
Electrochemical pressure impedance spectroscopy (EPIS) has recently been developed as a potential diagnosis tool for polymer electrolyte membrane fuel cells (PEMFC). It is based on analyzing the frequency response of the cell voltage with respect to an excitation of the gas-phase pressure. We present here a combined modeling and experimental study of EPIS. A pseudo-two-dimensional PEMFC model was parameterized to a 100 cm2 laboratory cell installed in its test bench, and used to reproduce steady-state cell polarization and electrochemical impedance spectra (EIS). Pressure impedance spectra were obtained both in experiment and simulation by applying a harmonic pressure excitation at the cathode outlet. The model shows good agreement with experimental data for current densities ≤ 0.4 A cm−2. Here it allows a further simulative analysis of observed EPIS features, including the magnitude and shape of spectra. Key findings include a strong influence of the humidifier gas volume on EPIS and a substantial increase in oxygen partial pressure oscillations towards the channel outlet at the resonance frequency. At current densities ≥ 0.8 A cm−2 the experimental EIS and EPIS data cannot be fully reproduced. This deviation might be associated with the formation and transport of liquid water, which is not included in the model.
- 14 February 2021
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 51 (5) , 727-738
Metal-free nitrogen-doped graphenic materials as cathode catalysts for the oxygen reduction reaction in polymer electrolyte membrane fuel cells
- 14 February 2021
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 51 (5) , 727-738
Metal-free nitrogen-doped graphenic materials as cathode catalysts for the oxygen reduction reaction in polymer electrolyte membrane fuel cells