Pattarasiri Fagkaew
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Pattarasiri Fagkaew has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Duksoo Jang
Department of Civil and Environmental Engineering, Korea Advanced Institute of Science and Technology, 291 Daehak-ro, Yuseong-gu, Daejeon, 305-701, Republic of Korea; Graduate School of Water Resources, Sungkyunkwan University (SKKU), 2066, Seobu-ro, Jangan-gu, Suwon-si, Gyeonggi-do, 16419, Republic of Korea
1 shared publication - Kaiwit Ruengruehan
Department of Civil Engineering, Kyung Hee University, Yongin-si, Gyeonggi-do 446-701, Korea, Tel. +82 31 201 2999; Fax: +82 31 202 8854
1 shared publication Nattawin Chawaloesphonsiya
Center of Excellence on Treatment Technology and Management of Petroleum Contaminants and Environmental Pollution, Chulalongkorn University, Bangkok, Thailand
1 shared publication- Nattawin Chawaloesphonsiya
Research Unit on Technology for Oil Spill and Contamination Management, Chulalongkorn University, Bangkok 10330, Thailand
1 shared publication Pisut Painmanakul
Department of Environmental Engineering, Faculty of Engineering, Chulalongkorn University, Bangkok, Thailand
1 shared publication- Pisut Painmanakul
Chulalongkorn University
1 shared publication
Latest Publications
- 15 January 2025
- Published by Springer Nature in Journal of Material Cycles and Waste Management
- Vol. 27 (2) , 1008-1018
Comparative analysis of flotation agents for enhanced separation of acrylonitrile butadiene styrene and polystyrene mixtures
- 15 January 2025
- Published by Springer Nature in Journal of Material Cycles and Waste Management
- Vol. 27 (2) , 1008-1018
Comparative analysis of flotation agents for enhanced separation of acrylonitrile butadiene styrene and polystyrene mixtures
- Open Access
Improving the Separation of PS and ABS Plastics Using Modified Induced Air Flotation with a Mixing Device
A dramatic increase in plastic waste has resulted in a strong need to increase plastic recycling accordingly. A selective flotation has been highlighted due to its outstanding efficiency for the separation of mixed plastics with analogous physicochemical characteristics. In this study, the effects of design and operational factors on the bubble’s hydrodynamic and mixing parameters in induced air flotation (IAF) with a mixing device were investigated through a design of experiment method (DOE) analysis for improving the plastic separation efficiency (i.e., PS and ABS). As a result of DOE analysis, the increase in the induced air tube diameter together with the rotational speed could generate a smaller bubble size. This led to the enhancement of the ratio of interfacial area to velocity gradient (a/G), which was interestingly found to be a significant factor affecting plastic recovery apart from the chemical agents. It demonstrates that operating IAF with a mixing device at a greater a/G ratio improved the plastic separation performance. These findings suggest that operating an IAF process with a mixing device at suitable a/G conditions could be a promising technique for separating plastic wastes, which have similar physicochemical characteristics as PS and ABS.
Open AccessImproving the Separation of PS and ABS Plastics Using Modified Induced Air Flotation with a Mixing Device
A dramatic increase in plastic waste has resulted in a strong need to increase plastic recycling accordingly. A selective flotation has been highlighted due to its outstanding efficiency for the separation of mixed plastics with analogous physicochemical characteristics. In this study, the effects of design and operational factors on the bubble’s hydrodynamic and mixing parameters in induced air flotation (IAF) with a mixing device were investigated through a design of experiment method (DOE) analysis for improving the plastic separation efficiency (i.e., PS and ABS). As a result of DOE analysis, the increase in the induced air tube diameter together with the rotational speed could generate a smaller bubble size. This led to the enhancement of the ratio of interfacial area to velocity gradient (a/G), which was interestingly found to be a significant factor affecting plastic recovery apart from the chemical agents. It demonstrates that operating IAF with a mixing device at a greater a/G ratio improved the plastic separation performance. These findings suggest that operating an IAF process with a mixing device at suitable a/G conditions could be a promising technique for separating plastic wastes, which have similar physicochemical characteristics as PS and ABS.
- Open Access
- 2 March 2016
- Published by Elsevier in Desalination and Water Treatment
- Vol. 57 (51) , 24551-24556
Impact of feed ionic concentration on colloidal and organic fouling of osmotically driven membrane process
The impact of feed ionic concentration in the presence of organic and colloidal foulant on osmotically driven membrane processes (ODMPs) was demonstrated. The normalized flux of ODMPs was significantly decresed in both DI and 10 mM NaCl feed solution when the feed solution contained colloidal particles as foulants due to the deposition of colloidal particles on the membrane surface. The deposited colloidal particles strongly promoted cake-enhanced osmotic pressure near the surface of the membrane. In contrast, the normalized flux of ODMPs was slightly increased when humic acids (HA) were added as the organic foulant into the feed solution. The attachment of HA molecules changed the membrane surface conducting it more hydrophilic, and induced a stronger diffusion of water molecules into the membrane active layer. As a result, both the increased feed ionic strength and deposited colloidal fouling did not significantly alter the reversal salt selectivity of the ODMPs, while the reversal salt selectivity was significantly incresed after the addition of HA molecules to the feed solution because the HA molecules changed the properties of the membrane surface.
- 2 March 2016
- Published by Elsevier in Desalination and Water Treatment
- Vol. 57 (51) , 24551-24556
Open AccessImpact of feed ionic concentration on colloidal and organic fouling of osmotically driven membrane process
The impact of feed ionic concentration in the presence of organic and colloidal foulant on osmotically driven membrane processes (ODMPs) was demonstrated. The normalized flux of ODMPs was significantly decresed in both DI and 10 mM NaCl feed solution when the feed solution contained colloidal particles as foulants due to the deposition of colloidal particles on the membrane surface. The deposited colloidal particles strongly promoted cake-enhanced osmotic pressure near the surface of the membrane. In contrast, the normalized flux of ODMPs was slightly increased when humic acids (HA) were added as the organic foulant into the feed solution. The attachment of HA molecules changed the membrane surface conducting it more hydrophilic, and induced a stronger diffusion of water molecules into the membrane active layer. As a result, both the increased feed ionic strength and deposited colloidal fouling did not significantly alter the reversal salt selectivity of the ODMPs, while the reversal salt selectivity was significantly incresed after the addition of HA molecules to the feed solution because the HA molecules changed the properties of the membrane surface.