Eunjoo Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Eunjoo Kim has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
Makoto Akashi
National Institute of Radiological Sciences, 4-9-1 Anagawa, Inage-ku, Chiba-city, Chiba, Japan
3 shared publications- Osamu Kurihara
Radiation Protection Department, Nuclear Fuel Cycle Engineering Laboratories, Tokai Research and Development Center, Japan Atomic Energy Agency, 4-33, Muramatsu, Tokai-mura, Naka-gun, Ibaraki 319-1194, Japan
3 shared publications Kazuo Sakai
National Institute of Radiological Sciences, 4-9-1 Anagawa, Inage-ku, Chiba-city, Chiba, Japan
2 shared publicationsYuji Yamada
National Institute of Radiological Sciences
2 shared publications- Fumihiro Saito
Administrative Services Department, Kansai Photon Science Institute , Japan Atomic Energy Agency , Umemidai, Kyoto 619-0215 , Japan
1 shared publication Hidenori Yonehara
1 shared publication
Latest Publications
- 1 November 2016
- Published by Oxford University Press (OUP) in Radiation Protection Dosimetry
- Vol. 171 (3) , 398-404
ESTIMATION OF EARLY INTERNAL DOSES TO FUKUSHIMA RESIDENTS AFTER THE NUCLEAR DISASTER BASED ON THE ATMOSPHERIC DISPERSION SIMULATION
Estimating the early internal doses to residents in the Fukushima Daiichi Nuclear Power Station accident is a difficult task because limited human/environmental measurement data are available. Hence, the feasibility of using atmospheric dispersion simulations created by the Worldwide version of System for Prediction of Environmental Emergency Dose Information 2nd Version (WSPEEDI-II) in the estimation was examined in the present study. This examination was done by comparing the internal doses evaluated based on the human measurements with those calculated using time series air concentration maps (131I and 137Cs) generated by WSPEEDI-II. The results showed that the latter doses were several times higher than the former doses. However, this discrepancy could be minimised by taking into account personal behaviour data that will be available soon. This article also presents the development of a prototype system for estimating the internal dose based on the simulations.
- 1 November 2016
- Published by Oxford University Press (OUP) in Radiation Protection Dosimetry
- Vol. 171 (3) , 398-404
ESTIMATION OF EARLY INTERNAL DOSES TO FUKUSHIMA RESIDENTS AFTER THE NUCLEAR DISASTER BASED ON THE ATMOSPHERIC DISPERSION SIMULATION
Estimating the early internal doses to residents in the Fukushima Daiichi Nuclear Power Station accident is a difficult task because limited human/environmental measurement data are available. Hence, the feasibility of using atmospheric dispersion simulations created by the Worldwide version of System for Prediction of Environmental Emergency Dose Information 2nd Version (WSPEEDI-II) in the estimation was examined in the present study. This examination was done by comparing the internal doses evaluated based on the human measurements with those calculated using time series air concentration maps (131I and 137Cs) generated by WSPEEDI-II. The results showed that the latter doses were several times higher than the former doses. However, this discrepancy could be minimised by taking into account personal behaviour data that will be available soon. This article also presents the development of a prototype system for estimating the internal dose based on the simulations.
- 1 August 2015
- Published by Wolters Kluwer Health in Health Physics
- Vol. 109 (2) , 122-133
Estimating Annual Individual Doses for Evacuees Returning Home to Areas Affected by the Fukushima Nuclear Accident
To contribute to the reconstruction and revitalization of Fukushima Prefecture following the 2011 nuclear power disaster, annual individual doses were estimated for evacuees who will return home to Tamura City, Kawauchi Village, and Iitate Village in Fukushima. Ambient external dose rates and individual doses obtained with personal dosimeters were measured at many residential and occupational sites throughout the study areas to obtain fundamental data needed for the estimation. The measurement results indicated that the ratio of individual dose based on a personal dosimeter to the ambient external dose measurement was 0.7 with 10% uncertainty. Multiplying the ambient external dose by 0.7 may be an appropriate measure of the effective dose to an individual in the investigated area. Annual individual doses were estimated for representative lifestyles and occupations based on the ambient external dose rates at the measurement sites, taking into account the relationship between the ambient external dose and individual dose. The results were as follows: 0.6-2.3 mSv y in Tamura, 1.1-5.5 mSv y in Kawauchi, and 3.8-17 mSv y in Iitate. For all areas investigated, the estimated dose to outdoor workers was higher than that to indoor workers. Identifying ways to reduce the amount of time that an outdoor worker spends outdoors would provide an effective measure to reduce dose.
- 1 August 2015
- Published by Wolters Kluwer Health in Health Physics
- Vol. 109 (2) , 122-133
Estimating Annual Individual Doses for Evacuees Returning Home to Areas Affected by the Fukushima Nuclear Accident
To contribute to the reconstruction and revitalization of Fukushima Prefecture following the 2011 nuclear power disaster, annual individual doses were estimated for evacuees who will return home to Tamura City, Kawauchi Village, and Iitate Village in Fukushima. Ambient external dose rates and individual doses obtained with personal dosimeters were measured at many residential and occupational sites throughout the study areas to obtain fundamental data needed for the estimation. The measurement results indicated that the ratio of individual dose based on a personal dosimeter to the ambient external dose measurement was 0.7 with 10% uncertainty. Multiplying the ambient external dose by 0.7 may be an appropriate measure of the effective dose to an individual in the investigated area. Annual individual doses were estimated for representative lifestyles and occupations based on the ambient external dose rates at the measurement sites, taking into account the relationship between the ambient external dose and individual dose. The results were as follows: 0.6-2.3 mSv y in Tamura, 1.1-5.5 mSv y in Kawauchi, and 3.8-17 mSv y in Iitate. For all areas investigated, the estimated dose to outdoor workers was higher than that to indoor workers. Identifying ways to reduce the amount of time that an outdoor worker spends outdoors would provide an effective measure to reduce dose.
- 25 February 2011
- Published by The Atomic Energy Society of Japan in Progress in Nuclear Science and Technology
- Vol. 1, 248-251
Development of Accurate Radioactivity Assessment System for Radiation Survey with Various Detectors
- 25 February 2011
- Published by The Atomic Energy Society of Japan in Progress in Nuclear Science and Technology
- Vol. 1, 248-251
Development of Accurate Radioactivity Assessment System for Radiation Survey with Various Detectors
- 18 November 2010
- Published by Oxford University Press (OUP) in Radiation Protection Dosimetry
- Vol. 145 (1) , 13-20
Emission rates of alpha particles from supports with different surface conditions in direct deposition sources
Direct deposition is the only method that can be utilised for the standardisation of radioactive solutions because there is no deposition loss on a support. The present study investigated how much the roughness of the support influences the emission rate of alpha particles for direct deposition sources from the practical viewpoint of use of the method. A number of samples were prepared by evaporating a 0.1-ml aliquot of a dilute nitric acid aqueous solution that contained 241Am on stainless steel supports with four different surface conditions; untreated supports were either polished (using metal abrasives available commercially) or not polished, and buffed supports (grid size of #400) were either polished or not polished. Alpha spectrometry of the samples revealed that the detection efficiency was significantly different between the non-polished and polished supports; the former was lower by 3 % than the latter for both the untreated and buffed supports. Microscopic observations clarified that the counting loss was attributed to irregular flaws or polishing lines on the non-polished supports, most of which were found to be in the order of submicron in depth and were diminished on the polished supports. One may usually assume that a direct deposition source offers no counting loss if its entire energy spectrum is seen above a low-energy discrimination limit of the spectrometer. However, this should be experimentally confirmed using a solution with known activity. It was difficult to identify the counting loss for the buffed supports without polishing because their energy spectra showed little degradation.
- 18 November 2010
- Published by Oxford University Press (OUP) in Radiation Protection Dosimetry
- Vol. 145 (1) , 13-20
Emission rates of alpha particles from supports with different surface conditions in direct deposition sources
Direct deposition is the only method that can be utilised for the standardisation of radioactive solutions because there is no deposition loss on a support. The present study investigated how much the roughness of the support influences the emission rate of alpha particles for direct deposition sources from the practical viewpoint of use of the method. A number of samples were prepared by evaporating a 0.1-ml aliquot of a dilute nitric acid aqueous solution that contained 241Am on stainless steel supports with four different surface conditions; untreated supports were either polished (using metal abrasives available commercially) or not polished, and buffed supports (grid size of #400) were either polished or not polished. Alpha spectrometry of the samples revealed that the detection efficiency was significantly different between the non-polished and polished supports; the former was lower by 3 % than the latter for both the untreated and buffed supports. Microscopic observations clarified that the counting loss was attributed to irregular flaws or polishing lines on the non-polished supports, most of which were found to be in the order of submicron in depth and were diminished on the polished supports. One may usually assume that a direct deposition source offers no counting loss if its entire energy spectrum is seen above a low-energy discrimination limit of the spectrometer. However, this should be experimentally confirmed using a solution with known activity. It was difficult to identify the counting loss for the buffed supports without polishing because their energy spectra showed little degradation.