Michele Nehemy Berteli
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Interests
Michele Nehemy Berteli has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Antonio Marsaioli Junior
Universidade Estadual de Campinas, Campinas, Brasil
1 shared publication - Elisabeth Rodier
École des Mines d’Albi-Carmaux, RAPSODEE Research Centre-UMR CNRS 2392, 81013, Albi, France
1 shared publication - Elza Iouko Ida
Department of Food Science and Technology, State University of Londrina, Londrina, Brazil
1 shared publication - Louise Emy Kurozawa
Departamento de Engenharia e Tecnologia de Alimentos, Faculdade de Engenharia de Alimentos, Universidade Estadual de Campinas (UNICAMP)
1 shared publication - Mariah Benine Ramos Silva
State University of Londrina, Londrina, Brazil
1 shared publication - Renan Alex Lazarin
School of Food Engineering, University of Campinas, Campinas, Brazil
1 shared publication
Latest Publications
- 30 November 2022
- Published by Springer Nature in Food and Bioprocess Technology
- Vol. 16 (3) , 565-575
Drying Kinetic and Bioactive Compounds of Okara Dried in Microwave-Assisted Rotating-Pulsed Fluidized Bed Dryer
- 30 November 2022
- Published by Springer Nature in Food and Bioprocess Technology
- Vol. 16 (3) , 565-575
Drying Kinetic and Bioactive Compounds of Okara Dried in Microwave-Assisted Rotating-Pulsed Fluidized Bed Dryer
- 1 January 2005
- Published by Taylor & Francis in Journal of Microwave Power and Electromagnetic Energy
- Vol. 40 (4) , 241-250
Study of a Microwave Assisted Vacuum Drying Process Applied to the Granulated Pharmaceutical Drug Hydrochlorthiazide (HCT)
Drying processes have evolved considerably over the years, aiming at the best conditions to shorten the processing time, but maintaining the highest final product quality. The application of vacuums to the microwave drying process might be interesting, especially for thermally sensitive products because the reduced boiling point of the solvent allows a lower temperature processing. The objective of the present work is to study and evaluate the process of drying a granulated product that is the basis of the drug hydrochlorthiazide, with an initial moisture content of 21% in dry basis. This study monitored the drying kinetics, product temperature and power absorbed by the sample using a bench scale vacuum microwave dryer. The equipment consisted of a cylindrical pressure vessel crossed by a wave guide, setting up a system whereby the vacuum pressure, the sample weight and the incident, reflected and residual microwave powers could be measured and evaluated, throughout the entire process. The experimental runs were established with an approximate incident microwave power at 20 W for absolute pressure levels of 50 and 75 mbar, working with samples of about 1.4 g. It was observed that the vacuum microwave process kinetics at both pressure levels showed little difference. The processes were carried out almost entirely in a regime of water evaporation, the product’s temperature remaining below the solvent boiling temperature. The drying times were similar for both processes, whereas the absorbed power was slightly higher at the pressure of 75 mbar.
- 1 January 2005
- Published by Taylor & Francis in Journal of Microwave Power and Electromagnetic Energy
- Vol. 40 (4) , 241-250
Study of a Microwave Assisted Vacuum Drying Process Applied to the Granulated Pharmaceutical Drug Hydrochlorthiazide (HCT)
Drying processes have evolved considerably over the years, aiming at the best conditions to shorten the processing time, but maintaining the highest final product quality. The application of vacuums to the microwave drying process might be interesting, especially for thermally sensitive products because the reduced boiling point of the solvent allows a lower temperature processing. The objective of the present work is to study and evaluate the process of drying a granulated product that is the basis of the drug hydrochlorthiazide, with an initial moisture content of 21% in dry basis. This study monitored the drying kinetics, product temperature and power absorbed by the sample using a bench scale vacuum microwave dryer. The equipment consisted of a cylindrical pressure vessel crossed by a wave guide, setting up a system whereby the vacuum pressure, the sample weight and the incident, reflected and residual microwave powers could be measured and evaluated, throughout the entire process. The experimental runs were established with an approximate incident microwave power at 20 W for absolute pressure levels of 50 and 75 mbar, working with samples of about 1.4 g. It was observed that the vacuum microwave process kinetics at both pressure levels showed little difference. The processes were carried out almost entirely in a regime of water evaporation, the product’s temperature remaining below the solvent boiling temperature. The drying times were similar for both processes, whereas the absorbed power was slightly higher at the pressure of 75 mbar.