Radovan Nečas
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Radovan Nečas has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Martin Boháč
Research Institute of Building Materials
5 shared publications - Dana Kubátová
Research Institute for Building Materials, Brno, Czech Republic
4 shared publications - Anežka Zezulová
Research Institute of Building Materials
3 shared publications - Alexandra Rybová
Research Institute of Building Materials
2 shared publications - Theodor Staněk
Research Institute for Building Materials, Brno, Czech Republic
2 shared publications Alexandra Masárová
1 shared publication
Latest Publications
- Open Access
- 1 June 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 379 (1) , 012007
Setting, rheology and packing density of biomass fly ash/Portland cement mixtures
Paper deals with rheological properties and packing density of fresh mixtures of Portland cement and biomass fly ash. Water demand of paste of normal consistency increases with increase of replacement level of biomass fly ash for Portland cement. Up to 5 wt. % contents of biomass fly ash yield stress and plastic viscosity values decrease, while at contents higher than 5 wt. %, the opposite trend was revealed. Biomass fly ash compared to Portland cement has proportionally lower content of particles with size of tens and first single digit numbers of microns. Deficiency in this region at higher contents of biomass fly ash in cement mixtures results in deflection from ideal packing density curve.
- 1 June 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 379 (1) , 012007
Open AccessSetting, rheology and packing density of biomass fly ash/Portland cement mixtures
Paper deals with rheological properties and packing density of fresh mixtures of Portland cement and biomass fly ash. Water demand of paste of normal consistency increases with increase of replacement level of biomass fly ash for Portland cement. Up to 5 wt. % contents of biomass fly ash yield stress and plastic viscosity values decrease, while at contents higher than 5 wt. %, the opposite trend was revealed. Biomass fly ash compared to Portland cement has proportionally lower content of particles with size of tens and first single digit numbers of microns. Deficiency in this region at higher contents of biomass fly ash in cement mixtures results in deflection from ideal packing density curve.
- Open Access
- 1 June 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 379 (1) , 012010
Properties of mixtures of cement with various raw materials
This paper presents possibility of utilization of selected Czech and Slovak industrial and natural raw materials in blended cement production. The cement blends were prepared using 75 wt. % of cement and 25 wt. % of a substituent. The paper is focused only on test results of the laboratory-prepared blended cements. The influence of admixture on hydration process was observed by calorimetric measurement of heat evolution during hydration process within 24 hours. The hydration products of water-cured samples for 28 days were determined by thermal analysis. Further properties, such as short and long-term compressive strengths and setting period, were determined.
- 1 June 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 379 (1) , 012010
Open AccessProperties of mixtures of cement with various raw materials
This paper presents possibility of utilization of selected Czech and Slovak industrial and natural raw materials in blended cement production. The cement blends were prepared using 75 wt. % of cement and 25 wt. % of a substituent. The paper is focused only on test results of the laboratory-prepared blended cements. The influence of admixture on hydration process was observed by calorimetric measurement of heat evolution during hydration process within 24 hours. The hydration products of water-cured samples for 28 days were determined by thermal analysis. Further properties, such as short and long-term compressive strengths and setting period, were determined.
- Open Access
- 1 June 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 379 (1) , 012009
Mechanical activation of frozen lime putties
The lime putty used for mortar preparation loses its desired properties, especially the plasticity and other rheological parameters, when it freezes. Two kinds of lime putty with 30 wt. % of solid content underwent 5 freeze/thaw cycles and their properties were investigated. Their consistency worsened dramatically after freezing. Mechanical activation was carried out by high-speed mixing of lime putty. This procedure led to a significant improvement in the lime putty plasticity and viscosity. The rheological parameters reached the original values that were determined before freezing. Rheological tests of lime putties were determined by rotational rheometer with the solids characterized by laser particle size analyzer.
- 1 June 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 379 (1) , 012009
Open AccessMechanical activation of frozen lime putties
The lime putty used for mortar preparation loses its desired properties, especially the plasticity and other rheological parameters, when it freezes. Two kinds of lime putty with 30 wt. % of solid content underwent 5 freeze/thaw cycles and their properties were investigated. Their consistency worsened dramatically after freezing. Mechanical activation was carried out by high-speed mixing of lime putty. This procedure led to a significant improvement in the lime putty plasticity and viscosity. The rheological parameters reached the original values that were determined before freezing. Rheological tests of lime putties were determined by rotational rheometer with the solids characterized by laser particle size analyzer.
- 11 December 2017
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 133 (1) , 399-404
Application of dilatometric analysis to the study of autoclaved calcium silicate materials
- 11 December 2017
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 133 (1) , 399-404
Application of dilatometric analysis to the study of autoclaved calcium silicate materials
- Open Access
- 1 January 2016
- Published by Elsevier in Procedia Engineering
- Vol. 151, 114-118
Ultramarine – Not Just a Pigment of Traditional Folk Architecture Plasters
- 1 January 2016
- Published by Elsevier in Procedia Engineering
- Vol. 151, 114-118
Open AccessUltramarine – Not Just a Pigment of Traditional Folk Architecture Plasters
- Open Access
- 1 January 2016
- Published by Elsevier in Procedia Engineering
- Vol. 151, 18-25
The Effect of Mechanical Activation of Lime Putty on Properties of the Autoclaved Calcium Hydrosilicate Materials
- 1 January 2016
- Published by Elsevier in Procedia Engineering
- Vol. 151, 18-25
Open AccessThe Effect of Mechanical Activation of Lime Putty on Properties of the Autoclaved Calcium Hydrosilicate Materials
- Open Access
- 1 January 2016
- Published by Elsevier in Procedia Engineering
- Vol. 151, 34-41
The Role of Aging on Rheological Properties of Lime Putty
- 1 January 2016
- Published by Elsevier in Procedia Engineering
- Vol. 151, 34-41
Open AccessThe Role of Aging on Rheological Properties of Lime Putty
- Open Access
- 1 January 2016
- Published by Elsevier in Procedia Engineering
- Vol. 151, 2-9
Properties of Cement Pastes with Zeolite During Early Stage of Hydration
- 1 January 2016
- Published by Elsevier in Procedia Engineering
- Vol. 151, 2-9
Open AccessProperties of Cement Pastes with Zeolite During Early Stage of Hydration