M. Maqsood
Research Subjects
M. Maqsood has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
A Usman
National Institute of Vacuum Science & Technology, NCP Complex, Shahdara Road, PO Box # 3125, Islamabad – Pakistan
1 shared publicationA. Usman
National Institute of Vacuum Science and Technology, Shahdara Road, NCP-Complex, Islamabad, Pakistan
1 shared publicationJ Ali
Department of Physics, Garden Campus, Hazara University, Mansehra, Pakistan
1 shared publicationJ. Ali
National Institute of Vacuum Science and Technology, Shahdara Road, NCP-Complex, Islamabad, Pakistan
1 shared publicationM Farooq
Department of Physics, Garden Campus, Hazara University, Mansehra, Pakistan
1 shared publicationM. F. Bodla
National Institute of Vacuum Science and Technology, Shahdara Road, NCP-Complex, Islamabad, Pakistan
1 shared publication
Latest Publications
- Open Access
- 1 August 2016
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 146 (1) , 012047
Evaluation of performance parameters of indigenously developed roots pumping system
Roots pumping systems are widely used in industries to generate vacuum with high pumping speed. In the present work, the performance parameters of indigenously developed Roots pumping system have been studied. The performance parameters being studied are the ultimate pressure, working temperature, compression ratio and pumping speed. Ultimate pressure of the Roots pump after continuous running of eight hours is found to be 1.1x10-3 mbar. The most important parameter of the roots pump is the zero-gas flow compression Ratio (Ko) which is found to be 18 for the pumping system under study. Efficiency of Roots pump is found to be 76% which is in good agreement as reported in the literature.
- 1 August 2016
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 146 (1) , 012047
Open AccessEvaluation of performance parameters of indigenously developed roots pumping system
Roots pumping systems are widely used in industries to generate vacuum with high pumping speed. In the present work, the performance parameters of indigenously developed Roots pumping system have been studied. The performance parameters being studied are the ultimate pressure, working temperature, compression ratio and pumping speed. Ultimate pressure of the Roots pump after continuous running of eight hours is found to be 1.1x10-3 mbar. The most important parameter of the roots pump is the zero-gas flow compression Ratio (Ko) which is found to be 18 for the pumping system under study. Efficiency of Roots pump is found to be 76% which is in good agreement as reported in the literature.
- Open Access
- 10 June 2013
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 439 (1) , 012035
Design and development of primary orifice plate flowmeter
Accurate and stable gas flows are very important in different applications like, the performance study of vacuum pumps, gauge calibration, leak detection and advance research in low pressure physics. Primary Orifice Plate Flowmeter (OPF) has been designed and developed indigenously. This flowmeter consists of two orifice plates. Orifice-1 (O1) acts as a flow restriction, while orifice-2 (O2) enables continuous pumping mode. By varying upstream pressure P1, a change in downstream pressure P2 is recorded, and the flow-rate is calculated from the conductance "C" of the orifice O1 and pressure difference by the relation Q = C(P1 − P2). Main feature of this primary OPF is that it is very simple and compact. A stable and reproducible flow-rate has been achieved in the range of 10−5 to 10−6 mbar.l/s. A variation in Q has been observed with a change in temperature of orifice and orifice diameter.
- 10 June 2013
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 439 (1) , 012035
Open AccessDesign and development of primary orifice plate flowmeter
Accurate and stable gas flows are very important in different applications like, the performance study of vacuum pumps, gauge calibration, leak detection and advance research in low pressure physics. Primary Orifice Plate Flowmeter (OPF) has been designed and developed indigenously. This flowmeter consists of two orifice plates. Orifice-1 (O1) acts as a flow restriction, while orifice-2 (O2) enables continuous pumping mode. By varying upstream pressure P1, a change in downstream pressure P2 is recorded, and the flow-rate is calculated from the conductance "C" of the orifice O1 and pressure difference by the relation Q = C(P1 − P2). Main feature of this primary OPF is that it is very simple and compact. A stable and reproducible flow-rate has been achieved in the range of 10−5 to 10−6 mbar.l/s. A variation in Q has been observed with a change in temperature of orifice and orifice diameter.
- Open Access
- 10 June 2013
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 439 (1) , 012046
Wireless electricity (Power) transmission using solar based power satellite technology
In the near future due to extensive use of energy, limited supply of resources and the pollution in environment from present resources e.g. (wood, coal, fossil fuel) etc, alternative sources of energy and new ways to generate energy which are efficient, cost effective and produce minimum losses are of great concern. Wireless electricity (Power) transmission (WET) has become a focal point as research point of view and nowadays lies at top 10 future hot burning technologies that are under research these days. In this paper, we present the concept of transmitting power wirelessly to reduce transmission and distribution losses. The wired distribution losses are 70 – 75% efficient. We cannot imagine the world without electric power which is efficient, cost effective and produce minimum losses is of great concern. This paper tells us the benefits of using WET technology specially by using Solar based Power satellites (SBPS) and also focuses that how we make electric system cost effective, optimized and well organized. Moreover, attempts are made to highlight future issues so as to index some emerging solutions.
- 10 June 2013
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 439 (1) , 012046
Open AccessWireless electricity (Power) transmission using solar based power satellite technology
In the near future due to extensive use of energy, limited supply of resources and the pollution in environment from present resources e.g. (wood, coal, fossil fuel) etc, alternative sources of energy and new ways to generate energy which are efficient, cost effective and produce minimum losses are of great concern. Wireless electricity (Power) transmission (WET) has become a focal point as research point of view and nowadays lies at top 10 future hot burning technologies that are under research these days. In this paper, we present the concept of transmitting power wirelessly to reduce transmission and distribution losses. The wired distribution losses are 70 – 75% efficient. We cannot imagine the world without electric power which is efficient, cost effective and produce minimum losses is of great concern. This paper tells us the benefits of using WET technology specially by using Solar based Power satellites (SBPS) and also focuses that how we make electric system cost effective, optimized and well organized. Moreover, attempts are made to highlight future issues so as to index some emerging solutions.