Sebastian Koziołek
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Sebastian Koziołek has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Marek Mysior
Wroclaw University of Science and Technology
5 shared publications - Damian Derlukiewicz
Department of Machine, Vehicle Design and Research, Faculty of Mechanical Engineering, Wrocław University of Science and Technology, Łukasiewicza 7/9, 50-370 Wrocław, Poland
2 shared publications - Mariusz Ptak
Faculty of Mechanical Engineering, Wroclaw University of Science and Technology, Lukasiewicza 7/9, 50-371 Wroclaw, Poland
2 shared publications Mateusz Słupiński
Centre for Systems Solutions, CRS
2 shared publications- Adrian Borek
HONEYtech Sp. Z O.O., Lututów, Poland
1 shared publication - Paweł Stępień
Faculty of Life Sciences and Technology, Institute of Agricultural Engineering, Wrocław University of Environmental and Life Sciences, 37/41 Chełmońskiego Str., 51-630 Wrocław, Poland
1 shared publication
Latest Publications
- 17 April 2025
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 138 (2) , 417-430
Comparative examination of the modular honeycomb trailer platform in operational conditions
- 17 April 2025
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 138 (2) , 417-430
Comparative examination of the modular honeycomb trailer platform in operational conditions
- 30 August 2023
- Published by Springer Nature
- p. 317-327
Use of Function Analysis in the Design of Multi-Functional Products
- 30 August 2023
- Published by Springer Nature
- p. 317-327
Use of Function Analysis in the Design of Multi-Functional Products
- 24 September 2022
- Published by Springer Nature
- p. 154-162
Hypotheses Analysis as a Development of the System Operator Method Used in TRIZ
- 24 September 2022
- Published by Springer Nature
- p. 154-162
Hypotheses Analysis as a Development of the System Operator Method Used in TRIZ
- Open Access
Modeling and Experimental Validation of Compression and Storage of Raw Biogas
A significant challenge in sustainability and development of energy systems is connected with limited diversity and availability of fuels, especially in rural areas. A potential solution to this problem is compression, transport, and storage of raw biogas, that would increase diversity and availability of energy sources in remote areas. The aim of this study was to perform experimental research on raw biogas compression concerning biogas volume that can be stored in a cylinder under the pressure of 20 MPa and to compare obtained results with numerical models used to describe the state of gas at given conditions. Results were used to determine the theoretical energy content of raw biogas, assuming its usage in CHP systems. In the study, six compression test runs were conducted on-site in an agricultural biogas plant. Compression time, pressure as well as gas volume, and temperature rise were measured for raw biogas supplied directly from the digester. Obtained results were used to evaluate raw biogas compressibility factor Z and were compared with several equations of state and numerical methods for calculating the Z-factor. For experimental compression cycles, a theoretical energy balance was calculated based on experimental results published elsewhere. As a result, gas compressibility factor Z for storage pressure of 20 MPa and a temperature of 319.9 K was obtained and compared with 6 numerical models used for similar gases. It was shown that widely known numerical models can predict the volume of compressed gas with AARE% as low as 4.81%. It was shown that raw biogas supplied directly from the digester can be successfully compressed and stored in composite cylinders under pressure up to 20 MPa. This proposes a new method to utilize raw biogas in remote areas, increasing the diversity of energy sources and increasing the share of renewable fuels worldwide.
Open AccessModeling and Experimental Validation of Compression and Storage of Raw Biogas
A significant challenge in sustainability and development of energy systems is connected with limited diversity and availability of fuels, especially in rural areas. A potential solution to this problem is compression, transport, and storage of raw biogas, that would increase diversity and availability of energy sources in remote areas. The aim of this study was to perform experimental research on raw biogas compression concerning biogas volume that can be stored in a cylinder under the pressure of 20 MPa and to compare obtained results with numerical models used to describe the state of gas at given conditions. Results were used to determine the theoretical energy content of raw biogas, assuming its usage in CHP systems. In the study, six compression test runs were conducted on-site in an agricultural biogas plant. Compression time, pressure as well as gas volume, and temperature rise were measured for raw biogas supplied directly from the digester. Obtained results were used to evaluate raw biogas compressibility factor Z and were compared with several equations of state and numerical methods for calculating the Z-factor. For experimental compression cycles, a theoretical energy balance was calculated based on experimental results published elsewhere. As a result, gas compressibility factor Z for storage pressure of 20 MPa and a temperature of 319.9 K was obtained and compared with 6 numerical models used for similar gases. It was shown that widely known numerical models can predict the volume of compressed gas with AARE% as low as 4.81%. It was shown that raw biogas supplied directly from the digester can be successfully compressed and stored in composite cylinders under pressure up to 20 MPa. This proposes a new method to utilize raw biogas in remote areas, increasing the diversity of energy sources and increasing the share of renewable fuels worldwide.
- 30 November 2018
- Published by Springer Nature
- p. 203-216
TRIZ Based Problem Solving of Tile Manufacturing System
- 30 November 2018
- Published by Springer Nature
- p. 203-216
TRIZ Based Problem Solving of Tile Manufacturing System
- 2 November 2018
- Published by Springer Nature
- p. 17-26
Design for Change: Disaggregation of Functions in System Architecture by TRIZ-Based Design
- 2 November 2018
- Published by Springer Nature
- p. 17-26
Design for Change: Disaggregation of Functions in System Architecture by TRIZ-Based Design
- 29 March 2017
- Published by Springer Nature
- p. 441-450
Analysis of the Use of Biogas as Fuel for Internal Combustion Engines
- 29 March 2017
- Published by Springer Nature
- p. 441-450
Analysis of the Use of Biogas as Fuel for Internal Combustion Engines
- 29 March 2017
- Published by Springer Nature
- p. 259-273
Design by Analogy: Synectics and Knowledge Acquisition Network
- 29 March 2017
- Published by Springer Nature
- p. 259-273
Design by Analogy: Synectics and Knowledge Acquisition Network
- 3 March 2016
- Published by Springer Nature
- p. 711-720
Proactive Failure Prevention by Human-Machine Interface in Remote-Controlled Demolition Robots
- 3 March 2016
- Published by Springer Nature
- p. 711-720
Proactive Failure Prevention by Human-Machine Interface in Remote-Controlled Demolition Robots