Anastasia I. Kovrova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Anastasia I. Kovrova has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
V. P. Gorelov
Institute of High-Temperature Electrochemistry, Ural Branch, Russian Academy of Sciences, 620137, Yekaterinburg, Russia
4 shared publications- Denis A. Osinkin
Laboratory of Kinetics, Institute of High-Temperature Electrochemistry, Ural Branch of the Russian Academy of Sciences, Yekaterinburg 620066, Russia
3 shared publications - Anton Valerievich Kuzmin
Vyatka State University, Kirov, Russia
2 shared publications - Evgeniy S. Tropin
Institute of Solid State Chemistry and Mechanochemistry of SB RAS, Novosibirsk, Russia
2 shared publications A. V. Kuz’MIn
Russian Academy of Sciences
1 shared publication- Alyona S. Lesnichyova
Institute of High-Temperature Electrochemistry UB RAS, Yekaterinburg 620137, Russia
1 shared publication
Latest Publications
- 14 April 2021
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 25 (6) , 1789-1796
Influence of Ce0.8R0.2O2–a (R = Y, Sm, Tb) submicron barrier layers at the La2NiO4+δ/YSZ boundary on the electrochemical performance of a cathode
- 14 April 2021
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 25 (6) , 1789-1796
Influence of Ce0.8R0.2O2–a (R = Y, Sm, Tb) submicron barrier layers at the La2NiO4+δ/YSZ boundary on the electrochemical performance of a cathode
- 1 June 2020
- Published by Pleiades Publishing Ltd in Russian Journal of Electrochemistry
- Vol. 56 (6) , 477-484
Impregnation of Pt|YSZ Oxygen Electrodes with Microquantities of Praseodymium Oxide
The method of electrochemical impedance is used to study the polarization conductivity of porous platinum electrodes in the Pt|YSZ|Pt cells over the temperature range from 500 to 700°C in air. Electrodes are impregnated with microquantities of praseodymium oxide PrOx (from 10–4 to 0.1 mg/cm2) by the impregnating them with praseodymium nitrate solution, with further thermal treatment: slow heating (50°С/h) up to 850°C. This processing resulted in the formation of the praseodymium oxide nanofilm on the electrolyte surface. The introducing of PrOx, even in an amount of 10–4 mg/cm2, is found to significantly increase the electrode polarization conductivity. Analysis of the electrochemical impedance spectra was performed by DRT (distribution of relaxation times) method, which revealed a change of the rate-determining stage of the electrode process in the concentration range of praseodymium oxide from 1 × 10–3 to 3.3 × 10–3 mg/cm2. The studied electrodes are discussed in terms of the island model of dense-oxide-PrOx-electrodes in which platinum plays the role of the current collector.
- 1 June 2020
- Published by Pleiades Publishing Ltd in Russian Journal of Electrochemistry
- Vol. 56 (6) , 477-484
Impregnation of Pt|YSZ Oxygen Electrodes with Microquantities of Praseodymium Oxide
The method of electrochemical impedance is used to study the polarization conductivity of porous platinum electrodes in the Pt|YSZ|Pt cells over the temperature range from 500 to 700°C in air. Electrodes are impregnated with microquantities of praseodymium oxide PrOx (from 10–4 to 0.1 mg/cm2) by the impregnating them with praseodymium nitrate solution, with further thermal treatment: slow heating (50°С/h) up to 850°C. This processing resulted in the formation of the praseodymium oxide nanofilm on the electrolyte surface. The introducing of PrOx, even in an amount of 10–4 mg/cm2, is found to significantly increase the electrode polarization conductivity. Analysis of the electrochemical impedance spectra was performed by DRT (distribution of relaxation times) method, which revealed a change of the rate-determining stage of the electrode process in the concentration range of praseodymium oxide from 1 × 10–3 to 3.3 × 10–3 mg/cm2. The studied electrodes are discussed in terms of the island model of dense-oxide-PrOx-electrodes in which platinum plays the role of the current collector.
- Open Access
Application of Promising Electrode Materials in Contact with a Thin-Layer ZrO2-Based Supporting Electrolyte for Solid Oxide Fuel Cells
The paper presents the results of an investigation into thin single- and triple-layer ZrO2-Sc2O3-based electrolytes prepared using the tape-casting technique in combination with promising electrodes based on La2NiO4+δ and Ni-Ce0.8Sm0.2O2-δ materials. It is shown that pressing and joint sintering of single electrolyte layers allows multilayer structures to be obtained that are free of defects at the layer interface. Electrical conductivity measurements of a triple-layer electrolyte carried out in longitudinal and transverse directions with both direct and alternating current showed resistance of the interface between the layers on the total resistance of the electrolyte to be minimal. Long-term tests have shown that the greatest degradation in resistance over time occurs in the case of an electrolyte with a tetragonal structure. Symmetrical electrochemical cells with electrodes fabricated using a screen-printing method were examined by means of electrochemical impedance spectroscopy. The polarization resistance of the electrodes was 0.45 and 0.16 Ohm∙cm2 at 800 °C for the fuel and oxygen electrodes, respectively. The distribution of relaxation times method was applied for impedance data analysis. During tests of a single solid oxide fuel cell comprising a supporting triple-layer electrolyte having a thickness of 300 microns, a power density of about 160 mW/cm2 at 850 °C was obtained using wet hydrogen as fuel and air as an oxidizing gas.
Open AccessApplication of Promising Electrode Materials in Contact with a Thin-Layer ZrO2-Based Supporting Electrolyte for Solid Oxide Fuel Cells
The paper presents the results of an investigation into thin single- and triple-layer ZrO2-Sc2O3-based electrolytes prepared using the tape-casting technique in combination with promising electrodes based on La2NiO4+δ and Ni-Ce0.8Sm0.2O2-δ materials. It is shown that pressing and joint sintering of single electrolyte layers allows multilayer structures to be obtained that are free of defects at the layer interface. Electrical conductivity measurements of a triple-layer electrolyte carried out in longitudinal and transverse directions with both direct and alternating current showed resistance of the interface between the layers on the total resistance of the electrolyte to be minimal. Long-term tests have shown that the greatest degradation in resistance over time occurs in the case of an electrolyte with a tetragonal structure. Symmetrical electrochemical cells with electrodes fabricated using a screen-printing method were examined by means of electrochemical impedance spectroscopy. The polarization resistance of the electrodes was 0.45 and 0.16 Ohm∙cm2 at 800 °C for the fuel and oxygen electrodes, respectively. The distribution of relaxation times method was applied for impedance data analysis. During tests of a single solid oxide fuel cell comprising a supporting triple-layer electrolyte having a thickness of 300 microns, a power density of about 160 mW/cm2 at 850 °C was obtained using wet hydrogen as fuel and air as an oxidizing gas.
- 1 February 2019
- Published by Pleiades Publishing Ltd in Russian Journal of Electrochemistry
- Vol. 55 (2) , 132-136
Characteristics of Pt Electrode Activated by Tb1 − xCexO2 − α Films in Contact with ZrO2 + 10 mol % Y2O3 Electrolyte
Porous platinum electrodes on ZrO2 + 10 mol % Y2O3 solid electrolyte (YSZ) are activated by Tb1 − xCe xO2 − α ( x= 0; 0.15; 0.33; 0.5; 1.0) mixed oxides by impregnation, and their polarization...
- 1 February 2019
- Published by Pleiades Publishing Ltd in Russian Journal of Electrochemistry
- Vol. 55 (2) , 132-136
Characteristics of Pt Electrode Activated by Tb1 − xCexO2 − α Films in Contact with ZrO2 + 10 mol % Y2O3 Electrolyte
Porous platinum electrodes on ZrO2 + 10 mol % Y2O3 solid electrolyte (YSZ) are activated by Tb1 − xCe xO2 − α ( x= 0; 0.15; 0.33; 0.5; 1.0) mixed oxides by impregnation, and their polarization...
- 26 September 2018
- Published by Pleiades Publishing Ltd in Russian Journal of Electrochemistry
- Vol. 54 (9) , 733-740
The Electric Conductivity of Poly- and Singlecrystaline Y2O3 in Oxidative Atmosphere
Comparative impedance measurements of electric conductivity of nominally undoped yttria are carried out for samples with sharply differing morphologies, namely, single crystals and porous ceramics...
- 26 September 2018
- Published by Pleiades Publishing Ltd in Russian Journal of Electrochemistry
- Vol. 54 (9) , 733-740
The Electric Conductivity of Poly- and Singlecrystaline Y2O3 in Oxidative Atmosphere
Comparative impedance measurements of electric conductivity of nominally undoped yttria are carried out for samples with sharply differing morphologies, namely, single crystals and porous ceramics...
- 1 May 2017
- Published by Pleiades Publishing Ltd in Russian Journal of Electrochemistry
- Vol. 53 (5) , 522-530
Films of certain oxides of rare-earth elements as the activators of platinum electrode on ZrO2 + 10 mol % Y2O3 electrolyte
The characteristics of porous Pt/YSZ (ZrO2 + 10 mol % Y2O3) electrodes activated with small amounts of either oxides of rare-earth elements (REE) of the cerium subgroup (CeO2, PrOx, TbOx) or a mixed oxide with the Сe2Tb4O11 composition by the procedure of impregnating the electrodes with ethanol solutions of REE nitrates and subsequent heating at 850°С are studied by the impedance method. The studies are carried out for those cases where the REE oxides after thermal treatment form a film on the electrolyte and also where no activator film is formed. The characteristics of films and activated electrodes are compared. Film-activated Pt/YSZ electrodes are discussed within the framework of the model of compact oxide electrodes.
- 1 May 2017
- Published by Pleiades Publishing Ltd in Russian Journal of Electrochemistry
- Vol. 53 (5) , 522-530
Films of certain oxides of rare-earth elements as the activators of platinum electrode on ZrO2 + 10 mol % Y2O3 electrolyte
The characteristics of porous Pt/YSZ (ZrO2 + 10 mol % Y2O3) electrodes activated with small amounts of either oxides of rare-earth elements (REE) of the cerium subgroup (CeO2, PrOx, TbOx) or a mixed oxide with the Сe2Tb4O11 composition by the procedure of impregnating the electrodes with ethanol solutions of REE nitrates and subsequent heating at 850°С are studied by the impedance method. The studies are carried out for those cases where the REE oxides after thermal treatment form a film on the electrolyte and also where no activator film is formed. The characteristics of films and activated electrodes are compared. Film-activated Pt/YSZ electrodes are discussed within the framework of the model of compact oxide electrodes.