Satoshi Maruyama
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Satoshi Maruyama has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Kazuaki Sawada
Department of Electrical and Electronic Information Engineering, Toyohashi University of Technology, Toyohashi, Aichi 441-8580, Japan
2 shared publications - Kazuhiro Takahashi
Toyohashi University of Technology
2 shared publications - Takeshi Hizawa
Office for Technical Support Services, Toyohashi University of Technology, Toyohashi 441-8580, Japan
1 shared publication - Yong-Joon Choi
Toyohashi University of Technology
1 shared publication
Latest Publications
- Open Access
- 20 September 2019
- Published by MYU K.K. in Sensors and Materials
- Vol. 31 (9) , 2895-2906
Improvement of Detection Limit of Nanomechanical Deflection Using Optical Interferometry for Label-free Molecular Detection
- 20 September 2019
- Published by MYU K.K. in Sensors and Materials
- Vol. 31 (9) , 2895-2906
Open AccessImprovement of Detection Limit of Nanomechanical Deflection Using Optical Interferometry for Label-free Molecular Detection
- Open Access
Optical-Interferometry-Based CMOS-MEMS Sensor Transduced by Stress-Induced Nanomechanical Deflection
We developed a Fabry–Perot interferometer sensor with a metal-oxide-semiconductor field-effect transistor (MOSFET) circuit for chemical sensing. The novel signal transducing technique was performed in three steps: mechanical deflection, transmittance change, and photocurrent change. A small readout photocurrent was processed by an integrated source follower circuit. The movable film of the sensor was a 350-nm-thick polychloro-para-xylylene membrane with a diameter of 100 µm and an air gap of 300 nm. The linearity of the integrated source follower circuit was obtained. We demonstrated a gas response using 80-ppm ethanol detected by small membrane deformation of 50 nm, which resulted in an output-voltage change with the proposed high-efficiency transduction.
Open AccessOptical-Interferometry-Based CMOS-MEMS Sensor Transduced by Stress-Induced Nanomechanical Deflection
We developed a Fabry–Perot interferometer sensor with a metal-oxide-semiconductor field-effect transistor (MOSFET) circuit for chemical sensing. The novel signal transducing technique was performed in three steps: mechanical deflection, transmittance change, and photocurrent change. A small readout photocurrent was processed by an integrated source follower circuit. The movable film of the sensor was a 350-nm-thick polychloro-para-xylylene membrane with a diameter of 100 µm and an air gap of 300 nm. The linearity of the integrated source follower circuit was obtained. We demonstrated a gas response using 80-ppm ethanol detected by small membrane deformation of 50 nm, which resulted in an output-voltage change with the proposed high-efficiency transduction.