Patrick L. Chapman
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Patrick L. Chapman has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Ali Davoudi
University of Illinois at Urbana-Champaign, Urbana, IL 61081 USA
3 shared publications - Juri Jatskevich
Electrical and Computer Engineering Department, University of British Columbia, Vancouver, BC, Canada
3 shared publications - Alireza Khaligh
Grainger Center for Electric Machinery and Electromechanics, University of Illinois at Urbana-Champaign, 1406 W. Green, Urbana, IL 61801
2 shared publications - Ali Davoudi
Graduate Student Member, IEEE, Senior Member, IEEE, University of Illinois at Urbana-Champaign, Grainger Center for Electric Machines and Electromechanics, 1406 West Green St., Urbana, IL 61801
1 shared publication
Latest Publications
- 12 November 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 22 (6) , 2410-2415
Averaged-Switch Modeling of Fourth-Order PWM DC–DC Converters Considering Conduction Losses in Discontinuous Mode
This manuscript addresses dynamic average-value modeling for fourth-order pulse-width modulation (PWM) DC-DC converters in discontinuous capacitor-voltage mode. Although significant literature is devoted to analysis of the inductor-based switching stage of second-order DC-DC converters in discontinuous current mode, much less has been published regarding the discontinuous voltage mode in the capacitor-based switching stage in fourth-order converters. Accurate average-value models are further complicated by the presence of non-ideality in the switching stage components. This manuscript presents a full-order average-value model for the capacitor-based switching stage, taking into account conduction losses according to the energy conservation principle. The proposed model is validated with a hardware prototype and detailed simulation and is shown to accurately predict large-signal time-domain transients as well as small-signal frequency-domain characteristics.
- 12 November 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 22 (6) , 2410-2415
Averaged-Switch Modeling of Fourth-Order PWM DC–DC Converters Considering Conduction Losses in Discontinuous Mode
This manuscript addresses dynamic average-value modeling for fourth-order pulse-width modulation (PWM) DC-DC converters in discontinuous capacitor-voltage mode. Although significant literature is devoted to analysis of the inductor-based switching stage of second-order DC-DC converters in discontinuous current mode, much less has been published regarding the discontinuous voltage mode in the capacitor-based switching stage in fourth-order converters. Accurate average-value models are further complicated by the presence of non-ideality in the switching stage components. This manuscript presents a full-order average-value model for the capacitor-based switching stage, taking into account conduction losses according to the energy conservation principle. The proposed model is validated with a hardware prototype and detailed simulation and is shown to accurately predict large-signal time-domain transients as well as small-signal frequency-domain characteristics.
- 1 September 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19388756,p. 31-35
Realization of Parasitics in the Stability of Dc-Dc Converters Loaded by Constant-Power Loads in Discontinuous Conduction Mode
Constant power load (CPL) characteristics of tightly regulated dc-dc converters in multi-converter distributed power systems is equivalent to the dynamic negative impedance, destabilizing the dc bus and consequently the system. Various techniques have been developed to control ideal/lossless converters loaded by CPLs. Neglecting loss components simplifies the modeling and analysis. Loss components significantly enhance the stability of the cascaded converters. In this paper, effects of parasitics in behavior of dc-dc converters operating in discontinuous conduction mode (DCM) and loaded by CPLs are investigated. Design criteria are presented, which gives recommendations on the design of multi- converter dc power systems to avoid negative impedance instability. The proposed stable operation criteria are validated with hardware measurements and detailed simulation analyses.
- 1 September 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19388756,p. 31-35
Realization of Parasitics in the Stability of Dc-Dc Converters Loaded by Constant-Power Loads in Discontinuous Conduction Mode
Constant power load (CPL) characteristics of tightly regulated dc-dc converters in multi-converter distributed power systems is equivalent to the dynamic negative impedance, destabilizing the dc bus and consequently the system. Various techniques have been developed to control ideal/lossless converters loaded by CPLs. Neglecting loss components simplifies the modeling and analysis. Loss components significantly enhance the stability of the cascaded converters. In this paper, effects of parasitics in behavior of dc-dc converters operating in discontinuous conduction mode (DCM) and loaded by CPLs are investigated. Design criteria are presented, which gives recommendations on the design of multi- converter dc power systems to avoid negative impedance instability. The proposed stable operation criteria are validated with hardware measurements and detailed simulation analyses.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 02714302,p. 793-796
Computer-Aided Average-Value Modeling of Fourth-Order PWM DC-DC Converters
Average-value modeling of dc-dc converters has been an area of active research for many years. Developing accurate average-value models of higher-order converters is further complicated by the presence of parasitics and waveform nonlinearity. A recently proposed numerical approach has been shown to be effective in including the effect of parasitics for second-order inductor-based dc-dc converters. This paper extends the numerical state-space averaging to the fourth-order capacitor-based switching stages. The proposed model takes into account conduction losses associated with switching stage components and is seamlessly functional in all operational modes. The proposed model is validated with a hardware prototype and detailed simulation and is shown to accurately predict large-signal time-domain transients as well as small-signal frequency-domain characteristics.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 02714302,p. 793-796
Computer-Aided Average-Value Modeling of Fourth-Order PWM DC-DC Converters
Average-value modeling of dc-dc converters has been an area of active research for many years. Developing accurate average-value models of higher-order converters is further complicated by the presence of parasitics and waveform nonlinearity. A recently proposed numerical approach has been shown to be effective in including the effect of parasitics for second-order inductor-based dc-dc converters. This paper extends the numerical state-space averaging to the fourth-order capacitor-based switching stages. The proposed model takes into account conduction losses associated with switching stage components and is seamlessly functional in all operational modes. The proposed model is validated with a hardware prototype and detailed simulation and is shown to accurately predict large-signal time-domain transients as well as small-signal frequency-domain characteristics.
- 1 January 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 02759306,p. 2069-2074
Eddy Current Modeling with Order-Reduction in Magnetic Equivalent Circuits
High fidelity magnetic equivalent circuits are considered as a compromise between detailed finite element models and simplified magnetic equivalent circuits. A very detailed magnetic equivalent circuit is set forth that avoid conventional geometrical simplifications. A long R-L ladder structure in magnetic domain justifies uniform flux density distribution. The proposed model accurately grasps the high frequency dynamics, corner effect, and 3-D effects. The resulted high-order model is rigorously simplified using linear model- order reduction techniques while preserving essential dynamic characteristics. The resulted reduced-order model is verified with the original full-order model in both time- and frequency- domains.
- 1 January 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 02759306,p. 2069-2074
Eddy Current Modeling with Order-Reduction in Magnetic Equivalent Circuits
High fidelity magnetic equivalent circuits are considered as a compromise between detailed finite element models and simplified magnetic equivalent circuits. A very detailed magnetic equivalent circuit is set forth that avoid conventional geometrical simplifications. A long R-L ladder structure in magnetic domain justifies uniform flux density distribution. The proposed model accurately grasps the high frequency dynamics, corner effect, and 3-D effects. The resulted high-order model is rigorously simplified using linear model- order reduction techniques while preserving essential dynamic characteristics. The resulted reduced-order model is verified with the original full-order model in both time- and frequency- domains.