Zakary Wilde
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Zakary Wilde has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Alexandra C. Burch
Los Alamos National Laboratory
1 shared publication - Christopher L. Muhich
Arizona State University
1 shared publication Christopher Trujillo
W-10, Los Alamos National Laboratory, Los Alamos, New Mexico 87545, USA
1 shared publicationDalton Smith
Q-6, Los Alamos National Laboratory, Los Alamos, New Mexico 87545, USA
1 shared publication- David F. Bahr
School of Materials Engineering, Purdue University, West Lafayette, USA
1 shared publication - Douglas George Tasker
Los Alamos National Lab. (LANL), Los Alamos, NM (United States)
1 shared publication
Latest Publications
- 19 May 2021
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 129 (19) , 195106
Predicting Hugoniot equation of state in erythritol with ab initio and reactive molecular dynamics
Erythritol has been proposed as an inert surrogate for developing theoretical and computational models to study aging in energetic materials. In this work, we present a comparison of mechanical and shock properties of erythritol computed using the ReaxFF reactive force field and from ab initio calculations employing density functional theory (DFT). We screened eight different ReaxFF parameterizations, of which the CHO parameters developed for hydrocarbon oxidation provide the most accurate predictions of mechanical properties and the crystal structure of erythritol. Further validation of the applicability of this ReaxFF parameterization for modeling erythritol is demonstrated by comparing predictions of the elastic constants, crystal structure, vibrational density of states, and Hugoniot curves against DFT calculations. The ReaxFF predictions are in close agreement with the DFT simulations for the elastic constants and shock Hugoniot when the crystal is loaded along its axis but show as much as 30% disagreement in the elastic constants in the plane and 12% difference in shock pressures when shocked along the or crystal axes. Last, we compare thermomechanical properties predicted from classical molecular dynamics with those calculated using the quasi-harmonic approximation and show that quantum mechanical effects produce large discrepancies in the computed values of heat capacity and thermal expansion coefficients compared with classical assumptions. Combining classical molecular dynamics predictions of mechanical behavior with phonon-based calculations of thermal behaviors, we show that predicted shock-induced temperatures for pressures up to 6.5 GPa do not exceed the pressure-dependent melting point of erythritol.- 19 May 2021
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 129 (19) , 195106
Predicting Hugoniot equation of state in erythritol with ab initio and reactive molecular dynamics
Erythritol has been proposed as an inert surrogate for developing theoretical and computational models to study aging in energetic materials. In this work, we present a comparison of mechanical and shock properties of erythritol computed using the ReaxFF reactive force field and from ab initio calculations employing density functional theory (DFT). We screened eight different ReaxFF parameterizations, of which the CHO parameters developed for hydrocarbon oxidation provide the most accurate predictions of mechanical properties and the crystal structure of erythritol. Further validation of the applicability of this ReaxFF parameterization for modeling erythritol is demonstrated by comparing predictions of the elastic constants, crystal structure, vibrational density of states, and Hugoniot curves against DFT calculations. The ReaxFF predictions are in close agreement with the DFT simulations for the elastic constants and shock Hugoniot when the crystal is loaded along its axis but show as much as 30% disagreement in the elastic constants in the plane and 12% difference in shock pressures when shocked along the or crystal axes. Last, we compare thermomechanical properties predicted from classical molecular dynamics with those calculated using the quasi-harmonic approximation and show that quantum mechanical effects produce large discrepancies in the computed values of heat capacity and thermal expansion coefficients compared with classical assumptions. Combining classical molecular dynamics predictions of mechanical behavior with phonon-based calculations of thermal behaviors, we show that predicted shock-induced temperatures for pressures up to 6.5 GPa do not exceed the pressure-dependent melting point of erythritol.- Open Access
A Thermal and Nanomechanical Study of Molecular Crystals as Versatile Mocks for Pentaerythritol Tetranitrate
Pentaerythritol tetranitrate (PETN) is a commonly used high explosive (HE) in detonators. Often, surrogate or “mock” materials are used in place of HE for mechanical tests, proofing out equipment, or developing new diagnostics. However, there is no commonly accepted mock for PETN. A good mock should match at least one physical property of the target material, and ideally mimic multiple thermal and mechanical properties. Here, we investigate several molecular crystals to evaluate their efficacy in mocking PETN density, melting point, elastic modulus, hardness, plastic deformation, and fracture behavior. Materials were tested with a combination of calorimetry and nanoindentation. Two materials, 2,4,6-trifluorobenzoic acid (246 TFBA) and mesoerythritol, were downselected for detailed indentation study after the initial round of screening experiments, both were found to mimic PETN mechanical behavior quite well, 246 TFBA closer to PETN in most properties (hardness, modulus, and density) than erythritol, but erythritol having advantages in relative cost and matching the onset of yield. Depending on the desired implementation of the mock, one material may be preferred over the other, but both have potential as generic mocks for PETN. Nanoindentation is demonstrated as a versatile tool to provide rapid screening of these materials’ mechanical properties.
Open AccessA Thermal and Nanomechanical Study of Molecular Crystals as Versatile Mocks for Pentaerythritol Tetranitrate
Pentaerythritol tetranitrate (PETN) is a commonly used high explosive (HE) in detonators. Often, surrogate or “mock” materials are used in place of HE for mechanical tests, proofing out equipment, or developing new diagnostics. However, there is no commonly accepted mock for PETN. A good mock should match at least one physical property of the target material, and ideally mimic multiple thermal and mechanical properties. Here, we investigate several molecular crystals to evaluate their efficacy in mocking PETN density, melting point, elastic modulus, hardness, plastic deformation, and fracture behavior. Materials were tested with a combination of calorimetry and nanoindentation. Two materials, 2,4,6-trifluorobenzoic acid (246 TFBA) and mesoerythritol, were downselected for detailed indentation study after the initial round of screening experiments, both were found to mimic PETN mechanical behavior quite well, 246 TFBA closer to PETN in most properties (hardness, modulus, and density) than erythritol, but erythritol having advantages in relative cost and matching the onset of yield. Depending on the desired implementation of the mock, one material may be preferred over the other, but both have potential as generic mocks for PETN. Nanoindentation is demonstrated as a versatile tool to provide rapid screening of these materials’ mechanical properties.
- 3 July 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1979 (1) , 160028
Rogowski coils for studies of detonator initiation and other diagnostics
Detonators are fundamental to most explosive systems, yet the detonators themselves are rarely diagnosed to determine how well they function or why they fail. To remedy this, various electrical diagnostics were explored, including: Rogowski coils for high fidelity detection of changes in electrical current in explosive bridgewires and how they relate to detonator performance; and radio frequency (RF) antennas to detect any electromagnetic emissions associated with reaction and growth in the explosives. A new type of Rogowski coil is described and some interesting phenomena were detected with the radio frequency antenna.
- 3 July 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1979 (1) , 160028
Rogowski coils for studies of detonator initiation and other diagnostics
Detonators are fundamental to most explosive systems, yet the detonators themselves are rarely diagnosed to determine how well they function or why they fail. To remedy this, various electrical diagnostics were explored, including: Rogowski coils for high fidelity detection of changes in electrical current in explosive bridgewires and how they relate to detonator performance; and radio frequency (RF) antennas to detect any electromagnetic emissions associated with reaction and growth in the explosives. A new type of Rogowski coil is described and some interesting phenomena were detected with the radio frequency antenna.