Ali Afzalifar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ali Afzalifar has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Alireza Ameli
Mem. ASME Laboratory of Fluid Dynamics, School of Energy Systems, Lappeenranta University of Technology, Lappeenranta 53850, Finland
1 shared publication - Jari Backman
Lappeenranta University of Technology, Lappeenranta, Finland
1 shared publication - Teemu Turunen-Saaresti
Laboratory of Fluid Dynamics, School of Energy Systems, Lappeenranta University of Technology, Lappeenranta 53850, Finland
1 shared publication
Latest Publications
- 5 October 2018
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 141 (3)
Centrifugal Compressor Design for Near-Critical Point Applications
The supercritical CO2 (sCO2) Brayton cycle has been attracting much attention to produce the electricity power, chiefly due to its higher thermal efficiency with the relatively lower temperature at the turbine inlet compared to other common energy conversion cycles. Centrifugal compressor operating conditions in the supercritical Brayton cycle are commonly set in vicinity of the critical point, owing to smaller compressibility factor and eventually lower compressor work. This paper investigates and compares different centrifugal compressor design methodologies in close proximity to the critical point and suggests the most accurate design procedure based on the findings. An in-house mean-line design code, which is based on the individual enthalpy loss models, is compared to stage efficiency correlation design methods. Moreover, modifications are introduced to the skin friction loss calculation to establish an accurate one-dimensional design methodology. Moreover, compressor performance is compared to the experimental measurements.
- 5 October 2018
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 141 (3)
Centrifugal Compressor Design for Near-Critical Point Applications
The supercritical CO2 (sCO2) Brayton cycle has been attracting much attention to produce the electricity power, chiefly due to its higher thermal efficiency with the relatively lower temperature at the turbine inlet compared to other common energy conversion cycles. Centrifugal compressor operating conditions in the supercritical Brayton cycle are commonly set in vicinity of the critical point, owing to smaller compressibility factor and eventually lower compressor work. This paper investigates and compares different centrifugal compressor design methodologies in close proximity to the critical point and suggests the most accurate design procedure based on the findings. An in-house mean-line design code, which is based on the individual enthalpy loss models, is compared to stage efficiency correlation design methods. Moreover, modifications are introduced to the skin friction loss calculation to establish an accurate one-dimensional design methodology. Moreover, compressor performance is compared to the experimental measurements.