Centrifugal Compressor Design for Near-Critical Point Applications
- 5 October 2018
- journal article
- research article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 141 (3)
Abstract
The supercritical CO2 (sCO2) Brayton cycle has been attracting much attention to produce the electricity power, chiefly due to its higher thermal efficiency with the relatively lower temperature at the turbine inlet compared to other common energy conversion cycles. Centrifugal compressor operating conditions in the supercritical Brayton cycle are commonly set in vicinity of the critical point, owing to smaller compressibility factor and eventually lower compressor work. This paper investigates and compares different centrifugal compressor design methodologies in close proximity to the critical point and suggests the most accurate design procedure based on the findings. An in-house mean-line design code, which is based on the individual enthalpy loss models, is compared to stage efficiency correlation design methods. Moreover, modifications are introduced to the skin friction loss calculation to establish an accurate one-dimensional design methodology. Moreover, compressor performance is compared to the experimental measurements.Keywords
This publication has 19 references indexed in Scilit:
- Supercritical Carbon Dioxide turbomachinery design for water-cooled Small Modular Reactor applicationNuclear Engineering and Design, 2014
- CFD investigation of a centrifugal compressor derived from pump technology for supercritical carbon dioxide as a working fluidThe Journal of Supercritical Fluids, 2014
- Low-Flow-Coefficient Centrifugal Compressor Design for Supercritical CO2Journal of Turbomachinery, 2014
- Real gas Brayton cycles for organic working fluidsProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2001
- Development of a High-Specific-Speed Centrifugal CompressorJournal of Turbomachinery, 1997
- An optimum set of loss models for performance prediction of centrifugal compressorsProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 1997
- A New Equation of State for Carbon Dioxide Covering the Fluid Region from the Triple-Point Temperature to 1100 K at Pressures up to 800 MPaJournal of Physical and Chemical Reference Data, 1996
- Two-equation eddy-viscosity turbulence models for engineering applicationsAIAA Journal, 1994
- Effect of Geometry on the Performance of Radial Vaneless DiffusersJournal of Turbomachinery, 1987
- Chamber Dimension Effects on Induced Flow and Frictional Resistance of Enclosed Rotating DisksJournal of Basic Engineering, 1960