BSBoonchai Stitmannaithum

Boonchai Stitmannaithum

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Boonchai Stitmannaithum has a total of 15 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Coal Bottom Ash as a Fine Aggregate in Concrete: A Bibliometric Review Integrating Experimental Synthesis with Identified Research Gaps

    by May Myat Mon Kyaw, Lapyote Prasittisopin, Boonchai Stitmannaithum

    Integrates bibliometric mapping with experimental evidence on Coal bottom ash fine-aggregate concrete, highlighting inconsistent results, research trends, and need for standardized methods.


  • Open Access

    Finite Element Analysis on Shear Responses of Reinforced Concrete Beams Strengthened with ETS-FRP Bars

    by Linh Van Hong Bui, Boonchai Stitmannaithum

    This study conducts a numerical analysis on the shear performance of reinforced concrete beams retrofitted with fiber-reinforced polymer (FRP) bars with embedded through-section (ETS) technique. The study uses 3D nonlinear finite element method (FEM) and evaluates the shear features of ETS-FRP-strengthened beams in failure modes, shear capacity, stiffness, and ductility. The FE analyses consider the effects of key design parameters, including transverse steel stiffness (Eswρsw), ETS-FRP bar stiffness (Efρf), compressive strength of concrete (f’c), beam geometry, and the values of shear span-to-effective depth (a/d) ratio. Consequently, ETS-strengthened beams with higher concrete strength (f’c) or greater total rigidity of ETS and transverse reinforcement (Efρf + Eswρsw) showed notable improvements in stiffness and load-carrying capacity, with average increases exceeding 20%. The enhancement in shear strength from increased shear reinforcement stiffness is less pronounced in specimens with high concrete strength than in those with lower strength. ETS-strengthened beams with T-shaped sections exhibit more effective performance and safer failure modes. An enhancement in the a/d ratio reduces the stress in ETS bars but results in more ductile failures. This study also proposes a new analytical formulation for determining the maximum shear resistance of ETS-intervened beams, accounting for all failure modes. The model achieved an average predicted-to-tested shear maximum force ratio of 0.93 along with a coefficient of variation of 26%, demonstrating improved accuracy compared to existing models.


  • Open Access

    Effect of Elevated Temperatures on Mechanical Properties of Spliced and Non-Spliced Steel Reinforcements: Experimental Study

    by Chanachai Thongchom, Suphanut Kongwat, Jongchai Jaitrong, Suraparb Keawsawasvong, Linh Van Hong Bui, Boonchai Stitmannaithum, Saeed Mousa

    Steel reinforcement is an essential part of reinforced concrete, providing structural strength. In case of fire, the steel reinforcement severely loses its mechanical properties, leading to structural collapse in some elevated temperatures. Thus, this work mainly investigates the mechanical properties of spliced and non-spliced steel reinforcements after being exposed to 500 °C, 700 °C, and 900 °C. The results show that the mechanical properties of steel reinforcements significantly change after exposure to temperatures exceeding 500 °C, and the diameter of steel reinforcements does not considerably affect post-fire properties. The proposed equations from previous work were also compared to the testing results in terms of post-fire stress–strain curves and mechanical properties, resulting in overestimation at temperatures of 700 °C and 900 °C. The study finds that using a mechanical coupler has the potential to increase the residual yield strength at a temperature of 500 °C, but it lacks post-fire elongation at a temperature of 700 °C due to observed failure behavior after testing. Furthermore, the failure occurred at the mechanical couplers when the exposure temperature reached 700 °C. The modulus of elasticity of non-splices was the most critical parameter, which was maximally different by 23.9% compared to non-spliced steel reinforcements.


  • Open Access

    Green transportation system to promote sustainable lifestyle in Chulalongkorn University

    by Jirarat Pinthong, Korb Limsuwan, Boonchai Stitmannaithum

    Chulalongkorn University (CU) is located at the heart of Bangkok, which is one of the most traffic congested cities in the world. It is very crucial for the university to develop a green and clean transportation system that is good for both the CU community and the whole society. To reduce on-campus traffic, the university provides four parking buildings on the edge of four corners of the campus to serve visitors, students, faculties and staffs who travel by private cars. While providing added convenience, these parking garages reduce traffic congestion on campus and, thus, pollutions from harmful emissions and traffic noises. To promote eco-friendly transportation in the campus, the university provides “CU Shuttle Bus” - an electric shuttle bus service that cover not only campus area, but also reach out to public sky train and subway stations around the campus. The CU Shuttle Bus’s mobile application, developed by engineering students, helps improve user experience by showing all useful information including campus map, bus routing, and real-time locations of all buses. To encourage walking and cycling within the campus and to promote good health and fitness, the university has been constructing covered walkways and bike lanes throughout the campus. In addition, “CU Bike” - a bike sharing program, was first introduced in 2014 and has quickly grown in popularity among CU students since. A new “CU Toyota Hamo”, an electric vehicle rental program, is another great option of green transportations for those who cannot ride a bicycle and for older people of the aging society. All these projects help promote the development of innovations and practices that are both sustainable and protective of the environment of Chulalongkorn University, as well as the surrounding community, the country and planet as a whole.


  • Open Access

    Bond Behavior between Embedded Through-Section Bars and Concrete

    by Linh Van, Hong Bui, Boonchai Stitmannaithum, Tamon Ueda, Pitcha Jongvivatsakul

    Bond Behavior between Embedded Through-Section Bars and Concrete