Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Alaa Ghanem has a total of 21 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Evaluation of ionic liquids based imidazolium salts as an environmentally friendly corrosion inhibitors for carbon steel in HCl solutions

    by Raghda A. El-Nagar, N. A. Khalil, Y. Atef, Maher I. Nessim, Alaa Ghanem

    The features of this work on corrosion inhibition have been investigated based on the ecological awareness and according to the strict environmental legislations. This was done by studying how different imidazolium derivatives ionic liquids containing different alkyl chains R8, R10 and R12 affected the corrosion reaction of carbon steel specimen immersed in 1 M hydrochloric acid at various temperatures. Weight loss, potentiodynamic polarization and electrochemical impedance spectroscopy were utilized to examine the corrosion inhibition behavior on carbon steel. In addition, FT-IR spectroscopy was used to analyze the coated film that has been formed on the metal surface. The prepared ionic liquids showed effective inhibition efficiency, where the corrosion rate after the using of 100 ppm of R8-IL, R10-IL and R12-IL was decreased from 5.95 (µg cm−2 min−1) to 0.66, 0.56, and 0.44 (µg cm−2 min−1), respectively at 20 °C. In the polarization curves, the corrosion current, Icorr, decreases by ILs addition and suggest that ILs act as mixed type inhibitors. From EIS findings, the increase in Rct and decrease in Cdl values proves the adherence of inhibitor molecules on carbon steel surface. The temperature effect was also studied on the film formed, where increasing the temperature from 20 to 50 °C, the corrosion rate increased and the inhibitors efficacy decreased. The increasing in the length of the attached alkyl chain, the efficacies of the prepared inhibitors increases. Various thermodynamic parameters such as the reaction activation free energy (ΔG*), the entropy of activation (ΔS*), and the enthalpy of activation (ΔH*), as well as the adsorption isotherm were investigated in order to interpret the mechanism and obtain the most accurate perception.


  • Open Access

    Imidazolium-based ionic liquids as dispersants to improve the stability of asphaltene in Egyptian heavy crude oil

    by Alaa Ghanem, Maher I. Nessim, N. A. Khalil, Raghda A. El-Nagar

    Deposition of asphaltene aggregates can easily depress the oil production, because it may clog the wellbores, annulus, pipelines, and surface facilities. Moreover, asphaltene molecules have a negative effect on the catalytic reactions in the refinery process. Therefore, in this work, three different ionic liquids (IL-H, IL-CH3, and IL-NO2) were synthesized, and characterized using FT-IR and NMR spectroscopy to evaluate their efficiency as asphaltene dispersants. The thermal gravimetric analysis of the prepared ILs showed that IL-H, IL-NO2, and IL-CH3 were thermally stable up to 280 °C. The ILs showed good dispersion activity of the petroleum asphaltenes, where the asphaltene onset precipitation (AOP) was changed from 7.5 to 10.5, 11, and 13.5 ml added n-heptane after the use of IL-H, IL-NO2, and IL-CH3, respectively. Moreover, the colloidal instability index of crude oil was changed from 0.92 (unstable asphaltene) to 0.69 (stable asphaltene). It is noted during the experiments that the presence of an alkyl chain attached to the ionic liquid moiety increases the efficiency of the dispersant. This may be owing to the formation of π–π* with asphaltene molecules due to the presence of electron donating group. Quantum chemical parameters were calculated for the prepared ILs, and the theoretical data confirmed the experimental results.


  • Open Access

    Self-Standing Pd-Based Nanostructures for Electrocatalytic CO Oxidation: Do Nanocatalyst Shape and Electrolyte pH Matter?

    by Belal Salah, Adewale K. Ipadeola, Aboubakr M. Abdullah, Alaa Ghanem, Kamel Eid

    Tailoring the shape of Pd nanocrystals is one of the main ways to enhance catalytic activity; however, the effect of shapes and electrolyte pH on carbon monoxide oxidation (COOxid) is not highlighted enough. This article presents the controlled fabrication of Pd nanocrystals in different morphologies, including Pd nanosponge via the ice-cooling reduction of the Pd precursor using NaBH4 solution and Pd nanocube via ascorbic acid reduction at 25 °C. Both Pd nanosponge and Pd nanocube are self-standing and have a high surface area, uniform distribution, and clean surface. The electrocatalytic CO oxidation activity and durability of the Pd nanocube were significantly superior to those of Pd nanosponge and commercial Pd/C in only acidic (H2SO4) medium and the best among the three media, due to the multiple adsorption active sites, uniform distribution, and high surface area of the nanocube structure. However, Pd nanosponge had enhanced COOxid activity and stability in both alkaline (KOH) and neutral (NaHCO3) electrolytes than Pd nanocube and Pd/C, attributable to its low Pd-Pd interatomic distance and cleaner surface. The self-standing Pd nanosponge and Pd nanocube were more active than Pd/C in all electrolytes. Mainly, the COOxid current density of Pd nanocube in H2SO4 (5.92 mA/cm2) was nearly 3.6 times that in KOH (1.63 mA/cm2) and 10.3 times that in NaHCO3 (0.578 mA/cm2), owing to the greater charge mobility and better electrolyte–electrode interaction, as evidenced by electrochemical impedance spectroscopy (EIS) analysis. Notably, this study confirmed that acidic electrolytes and Pd nanocube are highly preferred for promoting COOxid and may open new avenues for precluding CO poisoning in alcohol-based fuel cells.


  • Open Access

    Unveiling the effect of shapes and electrolytes on the electrocatalytic ethanol oxidation activity of self-standing Pd nanostructures

    by Adewale K. Ipadeola, Belal Salah, Alaa Ghanem, Doniyorbek Ahmadaliev, Mohammed A. Sharaf, Aboubakr M. Abdullah, Kamel Eid


  • Self-standing foam-like Pd-based alloys nanostructures for efficient electrocatalytic ethanol oxidation

    by Adewale K. Ipadeola, Ahmed Abdelgawad, Belal Salah, Alaa Ghanem, Mira Chitt, Aboubakr M. Abdullah, Kamel Eid


  • Open Access

    Investigation the effect of different ionic liquids based-aryl imidazole on the onset precipitation of asphaltene

    by Raghda A. El-Nagar, Maher I. Nessim, Dina A. Ismail, Manal G. Mohamed, Alaa Ghanem

    Precipitation and deposition of asphaltene are considered as catastrophic issues facing the petroleum industry. Asphaltene deposition mainly occurs at variety places such as formation pore spaces, pumps, pipelines, wellbore, wellhead, tubing, surface facilities and safety valves causing operational problems, production deficiencies and enormous economic losses. This work aims to study the effect of series of synthesized aryl ionic liquids (ILs) containing different alkyl chains, named as R8-IL, R10-IL, R12-IL, and R14-IL, on the onset precipitation point of asphaltene in crude oil. R8-IL, R10-IL, R12-IL, and R14-IL were synthesized with high yields (the yield varied between 82 and 88%) and characterized via different tools of analysis (FTIR, 1H NMR, and Elemental Analysis). Their Thermal Gravimetric Analysis (TGA) was investigated and showed a reasonable degree of stability. It was found that R8-IL (short alkyl chain) has the highest stability, while R14-IL (long alkyl chain) is the lowest one. Quantum chemical calculations were conducted to study the reactivity and geometry of their electronic structures. Moreover, surface and interfacial tension of them were studied. It was found that the efficiency of the surface active parameters increased by increasing the length of the alkyl chain. The ILs were evaluated to delay the onset precipitation point of asphaltene using to different methods; the kinematic viscosity and the refractive index. Results from the two methods showed delaying of onset precipitation after the addition of the prepared ILs. The asphaltene aggregates was dispersed due to the π–π* interactions and hydrogen bonds formation with the ILs.


  • Open Access

    Laboratory Experiments on the In Situ Upgrading of Heavy Crude Oil Using Catalytic Aquathermolysis by Acidic Ionic Liquid

    by Rima D. Alharthy, Raghda A. El-Nagar, Alaa Ghanem

    Heavy and extra heavy oil exploitation has attracted attention in the last few years because of the decline in the production of conventional crude oil. The high viscosity of heavy crude oil is the main challenge that obstructs its extraction. Consequently, catalytic aquathermolysis may be an effective solution to upgrade heavy crude oil to decrease its viscosity in reservoir conditions. In this regard, a series of acidic ionic liquids, 1-butyl-1H-imidazol-3-ium 4-dodecylbenzenesulfonate (IL-4), 1-decyl-1H-imidazol-3-ium 4-dodecylbenzenesulfonate (IL-10), and 1-hexadecyl-1H-imidazol-3-ium 4-dodecylbenzenesulfonate (IL-16), were utilized in the aquathermolysis of heavy crude oil. Of each IL, 0.09 wt % reduced the viscosity of the crude oil by 89%, 93.7%, and 94.3%, respectively, after the addition of 30% water at 175 °C. ILs with alkyl chains equal to 10 carbon atoms or more displayed greater activity in viscosity reduction than that of ILs with alkyl chains lower than 10 carbon atoms. The molecular weight and asphaltene content of the crude oil were decreased after catalytic aquathermolysis. The compositional analysis of the crude oil before and after catalytic aquathermolysis showed that the molar percentage of lighter molecules from tridecanes to isosanes was increased by 26–45%, while heavier molecules such as heptatriacontanes, octatriacontanes, nonatriacontanes, and tetracontanes disappeared. The rheological behavior of the crude oil before and after the catalytic aquathermolytic process was studied, and the viscosity of the crude oil sample was reduced strongly from 678, 29.7, and 23.4 cp to 71.8, 16.9, and 2.7 cp at 25, 50, and 75 °C, respectively. The used ILs upgraded the heavy crude oil at a relatively low temperature.


  • Open Access

    Predicting the Compressibility Factor of Natural Gas by Using Statistical Modeling and Neural Network

    by Alaa Ghanem, Mohammed F. Gouda, Rima D. Alharthy, Saad M. Desouky

    Simulating the phase behavior of a reservoir fluid requires the determination of many parameters, such as gas–oil ratio and formation volume factor. The determination of such parameters requires knowledge of the critical properties and compressibility factor (Z factor). There are many techniques to determine the compressibility factor, such as experimental pressure, volume, and temperature (PVT) tests, empirical correlations, and artificial intelligence approaches. In this work, two different models based on statistical regression and multi-layer-feedforward neural network (MLFN) were developed to predict the Z factor of natural gas by utilizing the experimental data of 1079 samples with a wide range of pseudo-reduced pressure (0.12–25.8) and pseudo reduced temperature (1.3–2.4). The statistical regression model was proposed and trained in R using the “rjags” package and Markov chain Monte Carlo simulation, while the multi-layer-feedforward neural network model was postulated and trained using the “neural net” package. The neural network consists of one input layer with two anodes, three hidden layers, and one output layer. The input parameters are the ratio of pseudo-reduced pressure and the pseudo-reduced temperature of the natural hydrocarbon gas, while the output is the Z factor. The proposed statistical and MLFN models showed a positive correlation between the actual and predicted values of the Z factor, with a correlation coefficient of 0.967 and 0.979, respectively. The results from the present study show that the MLFN can lead to accurate and reliable prediction of the natural gas compressibility factor.


  • Open Access

    Synthesis and Characterization of Imidazolium-Based Ionic Liquids and Evaluating Their Performance as Asphaltene Dispersants

    by Alaa Ghanem, Rima D. Alharthy, Saad M. Desouky, Raghda A. El-Nagar

    With the projected increase in the production of heavy oil due to the energy crisis, asphaltene-related issues are likely to come to the forefront. This leads to operational problems, safety hazards, and oil production deficiencies, resulting in huge economic losses for the petroleum industry. Therefore, in this work, we aimed to inhibit asphaltene precipitation using ionic liquid (IL) compounds. ILs with long alkyl chains can inhibit the precipitation of asphaltene molecules due to the π–π* interactions between them and the formation of hydrogen bonds. A series of imidazolium-based ionic liquids, IL-0, IL-4, IL-10, and IL-16, were synthesized with yield percents of 79, 81, 80, and 83%, respectively. The prepared materials were characterized well using FTIR, 1H-NMR, and Elemental Analysis. The surface tension, interfacial tension (IFT), and different surface parameters were investigated at different temperatures to simulate the reservoir temperature. IL-0, IL-4, IL-10, and IL-16 displayed their γcmc values at 35, 34, 31, and 32 mN/m at 303 °K, respectively. It was found that the prepared ILs are good surfactants with low values of interfacial tension. Quantum structure–activity relationships using Density Functional Theory (DFT) were used to investigate the geometry optimization electronic structures, the energy gap (ΔE), and the reactivity of the cations of the prepared ILs. The synthesized ILs were evaluated as asphaltene dispersants using two different techniques. The viscometric technique showed that the asphaltene onset precipitation was 28.5 vol.%. This percent was postponed to 42.8, 50, 78.5, and 64.3 vol.%, after adding IL-0, IL-4, IL-10, and IL-16, respectively, and the spectroscopic technique confirmed the results.


  • Open Access

    Capture of CO2 from Natural Gas Using Ionic Liquids

    by Raghda Ahmed El-Nagar, Alaa Ali Ghanem, Maher Ibrahim Nessim

    This chapter will be divided into three parts; introduction, experimental and result and discussion.