Kalehiwot Nega Manahiloh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Kalehiwot Nega Manahiloh has a total of 44 co-authors. Here are the top co-authors by number of shared publications:
Mohammad Motalleb Nejad
University of Delaware, Civil and Environmental Engineering, 301 DuPont Hall, Newark, DE 19711, United States
5 shared publications- Victor N. Kaliakin
Department of Civil, Construction, and Environmental Engineering, University of Delaware, Newark, USA
5 shared publications - Harry W. Shenton
Department of Civil and Environmental Engineering, University of Delaware, Newark, DE, USA
4 shared publications - Mohammad Motalleb Nejad
Univ. of Delaware
4 shared publications - Balasingam Muhunthan
Professor and Chair, Dept. of Civil and Environmental Engineering, Washington State Univ., Spokane St., Sloan Hall 30, Pullman, WA 99164
3 shared publications - Christopher L. Meehan
Department of Civil, Construction, and Environmental Engineering, University of Delaware, Newark, USA
3 shared publications
Latest Publications
- Open Access
- 1 October 2026
- Published by MDPI AG in Geosciences
- Vol. 16 (10) , 401
Parametric Evaluation of Key Constitutive Components in a Bounding Surface Model for Unsaturated Soils
The lack of consensus on appropriate formulations for effective stress, the soil-water characteristic curve (SWCC), and the critical-state void ratio has plagued the constitutive modeling of unsaturated soils. This paper presents a numerical parametric investigation of the aforementioned modeling components using a rate-independent hyperelastic bounding surface plasticity model for unsaturated granular soils. The constitutive model was calibrated against experimental results for a mid-Atlantic silty sand, and stress–strain and volumetric response simulations were conducted using alternative formulations for Bishop’s effective stress parameter, SWCC, and critical-state void ratio. The study indicated that the choice of SWCC has the greatest influence on model accuracy, particularly in predicting volumetric behavior, with formulations that employ more parameters providing greater fidelity. It was observed that variations in the definition of effective stress have a comparatively limited impact, whereas accurate representations of the critical-state void ratio improve overall predictive capability. The findings are based on a single silty sand, an SWCC estimated from grain size distribution data, monotonic loading conditions, and a limited critical-state database. Accordingly, the conclusions should be interpreted within the context of the investigated material, constitutive framework, and stress range considered. The findings highlight the relative importance of key modeling components and guide the selection and calibration of constitutive models for unsaturated soils.
- 1 October 2026
- Published by MDPI AG in Geosciences
- Vol. 16 (10) , 401
Open AccessParametric Evaluation of Key Constitutive Components in a Bounding Surface Model for Unsaturated Soils
The lack of consensus on appropriate formulations for effective stress, the soil-water characteristic curve (SWCC), and the critical-state void ratio has plagued the constitutive modeling of unsaturated soils. This paper presents a numerical parametric investigation of the aforementioned modeling components using a rate-independent hyperelastic bounding surface plasticity model for unsaturated granular soils. The constitutive model was calibrated against experimental results for a mid-Atlantic silty sand, and stress–strain and volumetric response simulations were conducted using alternative formulations for Bishop’s effective stress parameter, SWCC, and critical-state void ratio. The study indicated that the choice of SWCC has the greatest influence on model accuracy, particularly in predicting volumetric behavior, with formulations that employ more parameters providing greater fidelity. It was observed that variations in the definition of effective stress have a comparatively limited impact, whereas accurate representations of the critical-state void ratio improve overall predictive capability. The findings are based on a single silty sand, an SWCC estimated from grain size distribution data, monotonic loading conditions, and a limited critical-state database. Accordingly, the conclusions should be interpreted within the context of the investigated material, constitutive framework, and stress range considered. The findings highlight the relative importance of key modeling components and guide the selection and calibration of constitutive models for unsaturated soils.
- Open Access
- 12 November 2025
- Published by MDPI AG in Geosciences
- Vol. 15 (11) , 430
Effect of Wood-Based Biochar on the Engineering Properties of Medium Plasticity Clay
This research investigates the impact of wood-based biochar on the engineering properties of medium plasticity clay obtained from Perryville, Maryland. The clay was amended with biochar at volumetric contents of 3%, 6%, 9%, 12%, and 15% and subjected to a comprehensive suite of index and classification, compression, and shear strength laboratory tests. Results indicate that increasing biochar content leads to higher liquid limits and plasticity indices, a decrease in dry unit weight, and a higher optimum moisture content. Compression tests revealed increased compressibility and final void ratio with higher biochar content, likely due to biochar’s porous structure. Direct shear tests showed consistent improvements in shear strength parameters, including increases in both the internal friction angle and cohesion. Unconfined compression tests also demonstrated higher strength and ductility in biochar-amended samples. These findings support the potential of wood-based biochar as a sustainable and effective soil amendment for improving the geotechnical performance of clayey soils.
- 12 November 2025
- Published by MDPI AG in Geosciences
- Vol. 15 (11) , 430
Open AccessEffect of Wood-Based Biochar on the Engineering Properties of Medium Plasticity Clay
This research investigates the impact of wood-based biochar on the engineering properties of medium plasticity clay obtained from Perryville, Maryland. The clay was amended with biochar at volumetric contents of 3%, 6%, 9%, 12%, and 15% and subjected to a comprehensive suite of index and classification, compression, and shear strength laboratory tests. Results indicate that increasing biochar content leads to higher liquid limits and plasticity indices, a decrease in dry unit weight, and a higher optimum moisture content. Compression tests revealed increased compressibility and final void ratio with higher biochar content, likely due to biochar’s porous structure. Direct shear tests showed consistent improvements in shear strength parameters, including increases in both the internal friction angle and cohesion. Unconfined compression tests also demonstrated higher strength and ductility in biochar-amended samples. These findings support the potential of wood-based biochar as a sustainable and effective soil amendment for improving the geotechnical performance of clayey soils.
- Open Access
- 4 September 2025
- Published by MDPI AG in Preprints.org
Effect of Wood-Based Biochar on the Engineering Properties of Medium Plasticity Clay
This research investigates the impact of wood-based biochar on the engineering properties of medium plasticity clay obtained from Perryville, Maryland. The clay was amended with biochar at volumetric contents of 0%, 3%, 6%, 9%, 12%, and 15%, and subjected to a comprehensive suite of laboratory tests, including Atterberg limits, Proctor compaction, consolidation, direct shear, and unconfined compression. Results indicate that increasing biochar content leads to higher liquid limits and plasticity indices, a decrease in dry unit weight, and a higher optimum moisture content. Consolidation tests revealed increased compressibility and final void ratio with higher biochar content, likely due to biochar’s porous structure. Direct shear tests showed consistent improvements in shear strength parameters, including increases in both the internal friction angle and cohesion. Unconfined compression tests also demonstrated higher strength and ductility in biochar-amended samples. These findings support the potential of wood-based biochar as a sustainable and effective soil amendment for improving the geotechnical performance of clayey soils.
- 4 September 2025
- Published by MDPI AG in Preprints.org
Open AccessEffect of Wood-Based Biochar on the Engineering Properties of Medium Plasticity Clay
This research investigates the impact of wood-based biochar on the engineering properties of medium plasticity clay obtained from Perryville, Maryland. The clay was amended with biochar at volumetric contents of 0%, 3%, 6%, 9%, 12%, and 15%, and subjected to a comprehensive suite of laboratory tests, including Atterberg limits, Proctor compaction, consolidation, direct shear, and unconfined compression. Results indicate that increasing biochar content leads to higher liquid limits and plasticity indices, a decrease in dry unit weight, and a higher optimum moisture content. Consolidation tests revealed increased compressibility and final void ratio with higher biochar content, likely due to biochar’s porous structure. Direct shear tests showed consistent improvements in shear strength parameters, including increases in both the internal friction angle and cohesion. Unconfined compression tests also demonstrated higher strength and ductility in biochar-amended samples. These findings support the potential of wood-based biochar as a sustainable and effective soil amendment for improving the geotechnical performance of clayey soils.
- Open Access
- 30 May 2024
- Published by MDPI AG in Geosciences
- Vol. 14 (6) , 148
A Hyperelastic Bounding Surface Plasticity Model for Unsaturated Granular Soils
In this paper, a state-dependent, bounding surface plasticity model that simulates the behavior of unsaturated granular soils is presented. An unsaturated, soil mechanics-compatible elastoplastic response is adopted in which no part of the response occurs in a purely elastic fashion. To create an appropriate hydro-mechanical coupling, a newer generation stress framework, consisting of the Bishop-type effective stress and a second stress variable, is used in conjunction with a soil-water characteristic curve function. Details regarding the model development, parameter estimation, and assessment of the model’s predictive capabilities are outlined. With a single set of parameter values, the model realistically simulates the main features that characterize the shear and volumetric behavior of unsaturated granular soils over a wide range of matric suction, density, and net confining pressure.
- 30 May 2024
- Published by MDPI AG in Geosciences
- Vol. 14 (6) , 148
Open AccessA Hyperelastic Bounding Surface Plasticity Model for Unsaturated Granular Soils
In this paper, a state-dependent, bounding surface plasticity model that simulates the behavior of unsaturated granular soils is presented. An unsaturated, soil mechanics-compatible elastoplastic response is adopted in which no part of the response occurs in a purely elastic fashion. To create an appropriate hydro-mechanical coupling, a newer generation stress framework, consisting of the Bishop-type effective stress and a second stress variable, is used in conjunction with a soil-water characteristic curve function. Details regarding the model development, parameter estimation, and assessment of the model’s predictive capabilities are outlined. With a single set of parameter values, the model realistically simulates the main features that characterize the shear and volumetric behavior of unsaturated granular soils over a wide range of matric suction, density, and net confining pressure.
- 1 October 2021
- Published by Elsevier in Journal of Environmental Management
- Vol. 295, 113143
Predicting the impact of biochar on the saturated hydraulic conductivity of natural and engineered media
- 1 October 2021
- Published by Elsevier in Journal of Environmental Management
- Vol. 295, 113143
Predicting the impact of biochar on the saturated hydraulic conductivity of natural and engineered media
- 6 February 2020
- Published by Springer Nature in Transportation Infrastructure Geotechnology
- Vol. 7 (2) , 268
Publisher Correction: Dynamic Amplification Factor in Culverts: a Parametric Study Using Three-Dimensional Finite Element Analysis
- 6 February 2020
- Published by Springer Nature in Transportation Infrastructure Geotechnology
- Vol. 7 (2) , 268
Publisher Correction: Dynamic Amplification Factor in Culverts: a Parametric Study Using Three-Dimensional Finite Element Analysis
- 6 January 2020
- Published by Springer Nature in Transportation Infrastructure Geotechnology
- Vol. 7 (2) , 243-267
Dynamic Amplification Factor in Culverts: a Parametric Study using Three-Dimensional Finite Element Analysis
- 6 January 2020
- Published by Springer Nature in Transportation Infrastructure Geotechnology
- Vol. 7 (2) , 243-267
Dynamic Amplification Factor in Culverts: a Parametric Study using Three-Dimensional Finite Element Analysis
- 1 July 2019
- Published by Elsevier in Cold Regions Science and Technology
- Vol. 163, 34-43
Revisiting parameters that dictate the mechanical behavior of frozen soils
- 1 July 2019
- Published by Elsevier in Cold Regions Science and Technology
- Vol. 163, 34-43
Revisiting parameters that dictate the mechanical behavior of frozen soils
- 1 December 2018
- Published by Elsevier in Soil Dynamics and Earthquake Engineering
- Vol. 115, 938-940
Reply of authors to the discussion of H. Gullu [Soil Dyn Earthq Eng 108 (2018) 203–4] on their article “Shear wave velocity and soil type micro-zonation using neural networks and geographic information system” [Soil Dyn Earthq Eng 104 (2018) 54–63]
- 1 December 2018
- Published by Elsevier in Soil Dynamics and Earthquake Engineering
- Vol. 115, 938-940
Reply of authors to the discussion of H. Gullu [Soil Dyn Earthq Eng 108 (2018) 203–4] on their article “Shear wave velocity and soil type micro-zonation using neural networks and geographic information system” [Soil Dyn Earthq Eng 104 (2018) 54–63]
- 10 July 2018
- Published by Springer Nature in Journal of Nondestructive Evaluation
- Vol. 37 (3) , 54
A Refined Global Segmentation of X-Ray CT Images for Multi-phase Geomaterials
- 10 July 2018
- Published by Springer Nature in Journal of Nondestructive Evaluation
- Vol. 37 (3) , 54
A Refined Global Segmentation of X-Ray CT Images for Multi-phase Geomaterials