YCYantao Cui

Yantao Cui

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Yantao Cui has a total of 56 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Case study: Diagnosing China's prevailing urban flooding—Causes, challenges, and solutions

    by Yang Ma, Yantao Cui, Huagao Tan, Hongyu Wang

    Accompanying its rapid urban development, prevalent urban flooding incidents have been occurring in China in the past two decades with increasing frequency. Through a comparison with generally accepted urban flooding management practices, we (the authors) identified that a lack of surface water runoff management considerations (i.e., missing a major drainage system in urban stormwater system) and inadequate local mitigation are the primary causes of urban flooding problems in China, which in turn is rooted in the planning stage of a city's development. Following identification of the primary causes for the problems, we propose the development of master drainage plans (MDPs) for the concerned cities or regions as the first effective step to mitigate the serious urban flooding problems facing many cities today. An MDP would provide necessary elements to develop a major drainage system for the city's stormwater system and allow for an accurate calculation of parameters necessary for installation of adequate local mitigations. Lessons learned in this study should be useful for China's administrative agencies and professionals while they try to find solutions to their urban flooding problems and beneficial to other nations facing rapid urban development in the future or with existing urban flooding threats.


  • Comparing 1-D sediment transport modeling with field observations: Simkins Dam removal case study

    by Yantao Cui, Mathias J. Collins, Mary Andrews, Graham C. Boardman, John K. Wooster, Marty Melchior, Serena McClain

    We present a sediment transport modelling study for the 2010 removal of the 3.3-m tall Simkins Dam on the Patapsco River, MD that released more than 56,000 m3 of sediment downstream. Our objectives are to validate the pre-removal model forecasts with detailed post-removal monitoring data, and through hindcast modelling, examine the effects of using approximate channel geometry data or more accurate data on model results. Comparisons of DREAM-1 model predictions using approximate data and field observations indicate that reach-scale model predictions were generally accurate, but some discrepancies between predicted and observed magnitudes of sediment deposition at specific locations occurred. A refined model, developed post-dam removal with more accurate channel geometry as model input, produced slightly improved results in reaches where input data were significantly improved. However, more accurate input data did not change the general conclusions nor substantially improve the model performance for the entire study reach. In conjunction with two previous studies, our results support a simplified data collection approach that enables timely predictions for decision making and minimizes study costs.


  • Gravel‐bed river evolution in earthquake‐prone regions subject to cycled hydrographs and repeated sediment pulses

    by Chenge An, Yantao Cui, Xudong Fu, Gary Parker

    Sediment often enters rivers in the form of sediment pulses associated with landslides and debris flows. This is particularly so in gravel‐bed rivers in earthquake‐prone mountain regions, such as Southwest China. Under such circumstances, sediment pulses can rapidly change river topography and leave the river in repeated states of gradual recovery. In this paper, we implement a one‐dimensional morphodynamic model of river response to pulsed sediment supply. The model is validated using data from flume experiments, so demonstrating that it can successfully reproduce the overall morphodynamics of experimental pulses. The model is then used to explore the evolution of a gravel‐bed river subject to cycled hydrographs and repeated sediment pulses. These pulses are fed into the channel in a fixed region centered at a point halfway down the calculational domain. The pulsed sediment supply is in addition to a constant sediment supply at the upstream end. Results indicate that the river can reach a mobile‐bed equilibrium in which two regions exist within which bed elevation and surface grain size distribution vary periodically in time. One of these is at the upstream end, where a periodic discharge hydrograph and constant sediment supply are imposed, and the other is in a region about halfway down the channel where periodic sediment pulses are introduced. Outside these two regions, bed elevation and surface grain size distribution reach a mobile‐bed equilibrium that is invariant in time. The zone of fluctuation‐free mobile‐bed equilibrium upstream of the pulse region is not affected by repeated sediment pulses under the scenarios tested, but downstream of the pulse region, the channel reaches different fluctuation‐free mobile‐bed equilibriums under different sediment pulse scenarios. The vertical bed structure predicted by the simulations indicates that the cyclic variation associated with the hydrograph and sediment pulses can affect the substrate stratigraphy to some depth. Copyright © 2017 John Wiley & Sons, Ltd.


  • Analyses of the erosion of fine sediment deposit for a large dam-removal project: an empirical approach

    by Yantao Cui, Derek B. Booth, Joel Monschke, Seth Gentzler, John Roadifer, Blair Greimann, Brian Cluer

    Large quantities of fine sediment can be accumulated in reservoirs, and the potential impact of their downstream release is often a great concern if the dams are to be removed. Currently, there are no reliable numerical models to simulate the dynamics of the release of these fine sediments, mostly because their release following dam removal is often driven by a rapid erosional process not addressed by traditional sediment transport theory. However, precise quantification of fine sediment transport is rarely necessary to evaluate potential environmental impacts of alternative scenarios. Using the removal of Matilija Dam in southern California, USA, as an example, we quantify the likely magnitude of suspended sediment concentration and the duration of associated downstream impacts, two necessary (and most likely adequate) parameters for assessing alternatives. The analyses first estimate the general magnitude of suspended sediment concentration and duration of impacts based on field and experimental data; they then quantify the duration of impacts under both worst-case and reasonable assumptions according to the underlying physics and common sense. For rapid sediment release with fine-grained impoundment deposits, initial suspended sediment concentrations are likely to approach 106 mg/L, persisting for a few hours to no more than a couple of days. Suspended sediment concentrations are expected to decline approximately exponentially after the initial peak, reaching background levels within a few hours to a few days, provided that sufficient flow is available. The general method presented in the paper should be useful for stakeholders choosing amongst dam-removal alternatives for implementation under similar conditions.


  • Determining appropriate instream flows for anadromous fish passage on an intermittent mainstem river, coastal southern California, USA

    by Derek B. Booth, Yantao Cui, Zooey Diggory, Dirk Pedersen, Jordan Kear, Michael Bowen


  • Open Access

    Practical Considerations for Modeling Sediment Transport Dynamics in Rivers

    by Yantao Cui, Scott R. Dusterhoff, John K. Wooster, Peter W. Downs


  • Open Access

    Managing reservoir sediment release in dam removal projects: An approach informed by physical and numerical modelling of non‐cohesive sediment

    by Peter W. Downs, Yantao Cui, John K. Wooster, Scott R. Dusterhoff, Derek B. Booth, William E. Dietrich, Leonard S. Sklar

    Sediment management is frequently the most challenging concern in dam removal but there is as yet little guidance available to resource managers. For those rivers with beds composed primarily of non‐cohesive sediments, we document recent numerical and physical modelling of two processes critical to evaluating the effects of dam removal: the morphologic response to a sediment pulse, and the infiltration of fine sediment into coarser bed material. We demonstrate that (1) one‐dimensional numerical modelling of sediment pulses can simulate reach‐averaged transport and deposition over tens of kilometres, with sufficient certainty for managers to make informed decisions; (2) physical modelling of a coarse sediment pulse moving through an armoured pool‐bar complex shows deposition in pool tails and along bar margins while maintaining channel complexity and pool depth similar to pre‐pulse conditions; (3) physical modelling and theoretical analysis show that fine sediment will infiltrate into an immobile coarse channel bed to only a few median bed material particle diameters. We develop a generic approach to sediment management during dam removal using our experimental understanding to guide baseline data requirements, likely environmental constraints, and alternative removal strategies. In uncontaminated, non‐cohesive reservoir sediments we conclude that the management impacts of rapid sediment release may be of limited magnitude in many situations, and so the choice of dam removal strategy merits site‐specific evaluation of the environmental impacts associated with a full range of alternatives.


  • Translation and dispersion of sediment pulses in flume experiments simulating gravel augmentation below dams

    by Leonard S. Sklar, Jessica Fadde, Jeremy G. Venditti, Peter Nelson, M. Aleksandra Wydzga, Yantao Cui, William E. Dietrich

    The effectiveness of gravel augmentation as a river restoration strategy depends on the extent and duration of the topographic and bed texture changes created by the pulse of added sediment. Previous work has emphasized the strong tendency for natural sediment waves to propagate primarily by dispersion; however, pulse translation may occur for gravel additions to armored channels downstream of dams where added sediments are finer than the preexisting bed material. Here we report results of a laboratory investigation in which we created an immobile, armored bed and documented the spatial and temporal evolution of the bed topography and bed texture in response to gravel pulses of various volumes and grain sizes. The introduced sediment waves evolved by a combination of translation and dispersion, with a significant translational component. Pulse translation and dispersion can be readily discerned on a graph of the time evolution of the downstream cumulative distribution of elevation differences from the preexisting bed topography. Translation was most evident for smaller volumes of added sediment. Pulses of finer‐grained gravel moved through the flume more rapidly, resulting in a larger magnitude but shorter duration of bed fining. More work is needed to understand the influence of bar‐pool topography and flow magnitude and duration before the grain size and volume of gravel additions can be selected to achieve optimal patterns of pulse propagation.