SASudarshan Adhikari

Sudarshan Adhikari

*This is an algorithmically generated author record based on publicly available information.

Sudarshan Adhikari has a total of 5 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Development of deformation criteria for predictive monitoring system for levees

    by Chung R. Song, Sudarshan Adhikari, Ahmed Al-Ostaz, Alexander H.-D. Cheng

    Performance monitoring and real-time data analysis are essential tools to evaluate the integrity of infrastructure. Among other techniques, non-contact deformation measurement techniques such as satellite or drone-based methods are usually low-cost options, not requiring expensive sensors to be installed on target structures. The techniques are particularly economic for large structures such as levees, major slopes or dams. This study introduces lower bound and upper bound deformation concepts for levees. These two bounds are the deformation at which local failure is about to initiate and at which general failure is about to initiate, respectively. This study compared numerically computed lower and upper bounds deformation to field data from a full-scale loading test for a section of the levee at London Canal Avenue, New Orleans, and it showed that the two deformation criteria could be used to monitor and evaluate the integrity of levees.

  • Self-sealing bentonite strip: an effective method to prevent gap development for floodwalls in New Orleans

    by Chung R. Song, Sudarshan Adhikari, James T. Kidd

    Many sections of floodwalls in New Orleans, LA were damaged or suffered catastrophic failure as a result of Hurricane Katrina. One of the key triggering mechanisms of failure reported is the gap development between the floodwall and soil. This study developed an effective retrofitting technique to prevent this gap development by introducing a buried layer of self-sealing sand and bentonite mixture. This self-sealing layer was expected to swell fast enough so that it could seal the gap without any time delay and to exert insignificant swelling pressure to the levee so that it did not affect the stability of the levee. Among several mixtures of sand and bentonite, the mixture of 70% sand and 30% bentonite (by dry weight) proved to be a more effective one among laboratory and large scale model tests conducted in this study by swelling fast enough to seal the gap (approximately 10% swelling strain in 2 days), but exerting insignificant swelling pressure (162.03 kPa in 2 days) to the levee. From the numerical analysis using FLAC3D, it was confirmed that the stability of the levee was actually increased by sealing the gap even with the minor swelling pressure from the self-sealing layer. From 1/64th scale centrifuge tests, the wall with the self-sealing layer did not fail at 64 g, while the one without the self-sealing layer failed at 25 g acceleration.

  • Anisotropic Analysis of I-Walls in New Orleans

    by Sudarshan Adhikari, Chung R. Song, Alexander H.-D. Cheng

    Many numerical analyses of New Orleans levee and floodwall sections adopted mostly isotropic soil models partly due to the inherent simplicity of isotropic models. However, the isotropic models may not be sufficient to properly address the anisotropic behavior of soils. To overcome this imperfection, this study incorporated an anisotropic Modified Cam Clay model in a commercially available finite difference code, FLAC3D, and analyzed a floodwall and levee section in the 17th St. Canal in New Orleans. The analysis showed that the anisotropic model resulted in a similar overall deformation to the Mohr-Coulomb isotropic model. However, the anisotropic model showed more widely spread yielded elements and higher shear strain gradient in the Lacustrine clay layer, reconfirming that the Lacustrine clay layer played a major role for the failure in the 17th St. Canal. This result also signified that the isotropic Mohr-Coulomb model might be good for evaluating overall behavior in moderate deformation problems, while the anisotropic Modified Cam Clay model was good even for large strain problems where more accurate evaluation of yielding is needed.