Hui Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hui Li has a total of 72 co-authors. Here are the top co-authors by number of shared publications:
- Muk Chen Ong
Department of Mechanical and Structural Engineering and Materials Science, University of Stavanger, 4036 Stavanger, Norway
8 shared publications - Lin Lu
School of Naval Architecture & Ocean Engineering, Jiangsu University of Science and Technology, Zhenjiang, Jiangsu 212001, P. R. China
6 shared publications - Ruixiang Liu
Harbin Engn Univ, Coll Shipbldg Engn, Harbin 150001, Peoples R China
6 shared publications - Jian Zou
Harbin Engn Univ, Coll Shipbldg Engn, Harbin 150001, Peoples R China
5 shared publications - Zhiyong Sun5 shared publications
Huilong Ren
4 shared publications
Latest Publications
- 3 February 2026
- Published by Elsevier in Ocean Engineering
- Vol. 351
Study on water entry of curved elastic wedge using fully nonlinear boundary element method
- 3 February 2026
- Published by Elsevier in Ocean Engineering
- Vol. 351
Study on water entry of curved elastic wedge using fully nonlinear boundary element method
- 12 January 2026
- Published by Elsevier in Ocean Engineering
- Vol. 350
Numerical simulation of dissolved oxygen transport under jet–roll coupled hydrodynamics in an aquaculture vessel tank
- 12 January 2026
- Published by Elsevier in Ocean Engineering
- Vol. 350
Numerical simulation of dissolved oxygen transport under jet–roll coupled hydrodynamics in an aquaculture vessel tank
- 28 October 2025
- Published by Elsevier in Ocean Engineering
- Vol. 343
Numerical investigation of Jet–Roll coupled flow characteristics in an aquaculture vessel tank
- 28 October 2025
- Published by Elsevier in Ocean Engineering
- Vol. 343
Numerical investigation of Jet–Roll coupled flow characteristics in an aquaculture vessel tank
- 6 September 2025
- Published by Elsevier in Ocean Engineering
- Vol. 341
Experimental and numerical study on the ultimate strength of the CFRP hat-stiffened plate under the longitudinal compression
- 6 September 2025
- Published by Elsevier in Ocean Engineering
- Vol. 341
Experimental and numerical study on the ultimate strength of the CFRP hat-stiffened plate under the longitudinal compression
- 6 April 2025
- Published by Elsevier in Ocean Engineering
- Vol. 329
Numerical study on whipping response in irregular waves with asymmetric slamming for ultra large container ships
- 6 April 2025
- Published by Elsevier in Ocean Engineering
- Vol. 329
Numerical study on whipping response in irregular waves with asymmetric slamming for ultra large container ships
- 1 October 2024
- Published by ASME International in Journal of Offshore Mechanics and Arctic Engineering
- p. 1-16
Retracted: “Slamming characteristics of a rigid wedge during symmetric and asymmetric water entry”
The slamming behavior of structures entering water is crucial for understanding wave loads on marine structures. To investigate the spatiotemporal evolution characteristics of vertical symmetric and asymmetric water slamming loads on wedges, a series of tests were conducted on rigid wedges with deadrises of 20° and 30°. During asymmetric water entry, the wedge was heeled by 5° and 10° along the Z-axis. The experimental results indicate that velocity loss and the pressure error is less than 5%. Furthermore, the peak pressure decreases with the effective deadrise increase. The analysis is discussed in the paper. The slamming behavior of structures entering water is crucial for understanding wave loads on marine structures. To investigate the spatiotemporal evolution characteristics of ver-tical symmetric and asymmetric water slamming loads on wedges, a series of tests were conducted on rigid wedges with deadrises of 20° and 30°. During asymmetric water entry, the wedge was heeled by 5° and 10° along the Z-axis. The experimental results indicate that velocity loss and the pressure error is less than 5%. Furthermore, the peak pressure decreases with the effective deadrise increase. Relevant quantitative analysis is discussed in the article.
- 1 October 2024
- Published by ASME International in Journal of Offshore Mechanics and Arctic Engineering
- p. 1-16
Retracted: “Slamming characteristics of a rigid wedge during symmetric and asymmetric water entry”
The slamming behavior of structures entering water is crucial for understanding wave loads on marine structures. To investigate the spatiotemporal evolution characteristics of vertical symmetric and asymmetric water slamming loads on wedges, a series of tests were conducted on rigid wedges with deadrises of 20° and 30°. During asymmetric water entry, the wedge was heeled by 5° and 10° along the Z-axis. The experimental results indicate that velocity loss and the pressure error is less than 5%. Furthermore, the peak pressure decreases with the effective deadrise increase. The analysis is discussed in the paper. The slamming behavior of structures entering water is crucial for understanding wave loads on marine structures. To investigate the spatiotemporal evolution characteristics of ver-tical symmetric and asymmetric water slamming loads on wedges, a series of tests were conducted on rigid wedges with deadrises of 20° and 30°. During asymmetric water entry, the wedge was heeled by 5° and 10° along the Z-axis. The experimental results indicate that velocity loss and the pressure error is less than 5%. Furthermore, the peak pressure decreases with the effective deadrise increase. Relevant quantitative analysis is discussed in the article.
- 3 September 2024
- Published by Taylor & Francis in Ships and Offshore Structures
- Vol. 20 (11) , 1676-1696
Hydrodynamic performance of a high-Speed ship in waves using a fully nonlinear wave separation method
- 3 September 2024
- Published by Taylor & Francis in Ships and Offshore Structures
- Vol. 20 (11) , 1676-1696
Hydrodynamic performance of a high-Speed ship in waves using a fully nonlinear wave separation method
- 24 August 2024
- Published by Elsevier in Ocean Engineering
- Vol. 312
Experimental investigation of slamming pressure on 3D bow flare
- 24 August 2024
- Published by Elsevier in Ocean Engineering
- Vol. 312
Experimental investigation of slamming pressure on 3D bow flare