Mark R. Nardi

Reliable estimates of the magnitude of peak flows in streams are required for the economical and safe design of transportation and water conveyance structures. In addition, reliable estimates of the magnitude of low flows at defined frequencies and durations are needed for meeting regulatory requirements, quantifying base flows in streams and rivers, and evaluating time of travel and dilution of toxic spills. This report, in cooperation with the Delaware Department of Transportation and the Delaware Geological Survey, presents methods for estimating the magnitude of peak flows and low flows at defined frequencies and durations on nontidal streams in Delaware, at locations both monitored by streamflow-gage sites and ungaged. Methods are presented for estimating (1) the magnitude of peak flows for return periods ranging from 2 to 500 years (50-percent to 0.2-percent annual-exceedance probability), and (2) the magnitude of low flows as applied to 7-, 14-, and 30-consecutive day low-flow periods with recurrence intervals of 2, 10, and 20 years (50-, 10-, and 5-percent annual non-exceedance probabilities). These methods are applicable to watersheds that exhibit a full range of development conditions in Delaware. The report also describes StreamStats, a web application that allows users to easily obtain peak-flow and low-flow magnitude estimates for user-selected locations in Delaware.Peak-flow and low-flow magnitude estimates for ungaged sites are obtained using statistical regression analysis through a process known as regionalization, where information from a group of streamflow-gage sites within a region forms the basis for estimates for ungaged sites within the same region. Ninety-four streamflow-gage sites in and near Delaware with at least 10 years of nonregulated annual peak-flow data were used for the peak-flow regression analysis, a subset of the 121 sites for which peak-flow estimates were computed. These sites included both continuous-record streamflow-gage sites as well as partial record sites. Forty-five streamflow-gage sites with at least 10 years of nonregulated low-flow data available were used for the low-flow regression analyses, a subset of the 68 sites for which low-flow estimates were computed. Estimates for gaged sites are obtained by combining (1) the station peak-flow statistics (mean, standard deviation, and skew) and peak-flow estimates using the recent Bulletin 17C guidelines that incorporate the Expected Moments Algorithm with (2) regional estimates of peak-flow magnitude derived from regional regression equations and regional skew derived from sites with records greater than or equal to 35 years. Example peak-flow estimate calculations using the methods presented in the report are given for (1) ungaged sites, (2) gaged sites, (3) sites upstream or downstream from a gaged location, and (4) sites between gaged locations. Estimates for low-flow gaged sites are obtained by combining (1) the station low-flow statistics (mean, standard deviation, and skew) and low-flow estimates with (2) regional estimates of low-flow magnitude derived from regional regression equations. Example low-flow estimate calculations using the methods presented in the report are given for (1) ungaged sites, (2) gaged sites, (3) sites upstream or downstream from a gaged location, and (4) sites between gaged locations. A total of 54 sites in the Coastal Plain region were used to develop peak-flow regressions for the region and 40 sites were used for the Piedmont region. Similarly, 24 sites were used for low-flow regression equation development in the Coastal Plain, with 21 in the Piedmont. Peak and low-flow site inclusion in the Coastal Plain tended to be more restricted with tidal influence and ranges of basin characteristics, including drainage area, limiting regression equation development and application.Regional regression equations for peak flows and low flows, as applicable to ungaged sites in the Piedmont and Coastal Plain Physiographic Provinces in Delaware, are presented. Peak-flow regression equations used variables that quantified drainage area, basin slope, percent area with well-drained soils, percent area with poorly drained soils, impervious area, and percent area of surface water storage in estimating peak-flow estimates, whereas low-flow regression equations used only drainage area and percent poorly drained soils in the estimation of low flows. Average standard errors for peak-flow regressions tended to be lower than those for low- flow regressions, with lower errors in the Piedmont region for both peak- and low-flow regressions. For peak-flow estimates, a sensitivity analysis of Piedmont regression equation estimates to changes in impervious area is also presented.Additional topics associated with the analyses performed during the study are discussed, including (1) the availability and description of 32 basin and climatic characteristics considered during the development of the regional regression equations; (2) the treatment of increasing trends in the annual peak-flow series identified at 18 gaged sites and inclusion in or exclusion from the regional analysis; (3) regional skew analysis and determination of regression regions; (4) sample adjustments and removal of sites owing to regulation and redundancy; and (5) a brief comparison of peak- and low-flow estimates at gages used in previous studies.

The U.S. Geological Survey, in cooperation with the Delaware Department of Agriculture, developed a network of wells to monitor groundwater quality in the surficial aquifer of the Delaware Coastal Plain. Well-drained soils, a flat landscape, and accessible water in the Delaware Coastal Plain make for a productive agricultural setting. As such, agriculture is one of the largest industries in the State of Delaware. This setting enables the transport of chemicals from agriculture and other land uses to shallow groundwater. Efforts to mitigate nutrient transport to groundwater by the implementation of agricultural best management practices (BMPs) have been ongoing for several decades. To measure the effectiveness of BMPs on a regional scale, a network of 48 wells was designed to measure shallow groundwater quality (particularly nitrate) over time near agricultural land in the Delaware Coastal Plain. Water characteristics, major ions, nutrients, and dissolved gases were measured in groundwater samples collected from network wells during fall 2014. Wells were organized into three groups based on their geochemical similarity and these groups were used to describe nitrate and chloride concentrations and factors that affect the variability among the groups. The results from this study are intended to establish waterquality conditions in 2014 to enable comparison of future conditions and evaluate the effectiveness of agricultural BMPs on a regional scale.

After Hurricane Sandy made landfall along the northeastern Atlantic coast of the United States on October 29, 2012, the U.S. Geological Survey (USGS) carried out scientific investigations to assist with protecting coastal communities and resources from future flooding. The work included development and implementation of the Surge, Wave, and Tide Hydrodynamics (SWaTH) network consisting of more than 900 monitoring stations. The SWaTH network was designed to greatly improve the collection and timely dissemination of information related to storm surge and coastal flooding. The network provides a significant enhancement to USGS data-collection capabilities in the region impacted by Hurricane Sandy and represents a new strategy for observing and monitoring coastal storms, which should result in improved understanding, prediction, and warning of storm-surge impacts and lead to more resilient coastal communities.As innovative as it is, SWaTH evolved from previous USGS efforts to collect storm-surge data needed by others to improve storm-surge modeling, warning, and mitigation. This report discusses the development and implementation of the SWaTH network, and some of the regional stories associated with the landfall of Hurricane Sandy, as well as some previous events that informed the SWaTH development effort. Additional discussions on the mechanics of inundation and how the USGS is working with partners to help protect coastal communities from future storm impacts are also included.

The U.S. Geological Survey developed a groundwater flow model for the Northern Atlantic Coastal Plain aquifer system from Long Island, New York, to northeastern North Carolina as part of a detailed assessment of the groundwater availability of the area and included an evaluation of how these resources have changed over time from stresses related to human uses and climate trends. The assessment was necessary because of the substantial dependency on groundwater for agricultural, industrial, and municipal needs in this area. The three-dimensional, groundwater flow model developed for this investigation used the numerical code MODFLOW–NWT to represent changes in groundwater pumping and aquifer recharge from predevelopment (before 1900) to future conditions, from 1900 to 2058. The model was constructed using existing hydrogeologic and geospatial information to represent the aquifer system geometry, boundaries, and hydraulic properties of the 19 separate regional aquifers and confining units within the Northern Atlantic Coastal Plain aquifer system and was calibrated using an inverse modeling parameter-estimation (PEST) technique. The parameter estimation process was achieved through history matching, using observations of heads and flows for both steady-state and transient conditions. A total of 8,868 annual water-level observations from 644 wells for the 1986 to 2008 period were combined into 29 water-level observation groups that were chosen to focus the history matching on specific hydrogeologic units in geographic areas in which distinct geologic and hydrologic conditions were observed. In addition to absolute water-level elevations, the water-level differences between individual measurements were also included in the parameter estimation process to remove the systematic bias caused by missing hydrologic stresses prior to 1986. The total average residual of –1.7 feet was normally distributed for all head groups, indicating minimal bias. The average absolute residual value of 12.3 feet is about 3 percent of the total observed water-level range throughout the aquifer system. Streamflow observation data of base flow conditions were derived for 153 sites from the U.S. Geological Survey National Hydrography Dataset Plus and National Water Information System. An average residual of about –8 cubic feet per second and an average absolute residual of about 21 cubic feet per second for a range of computed base flows of about 417 cubic feet per second were calculated for the 122 sites from the National Hydrography Dataset Plus. An average residual of about 10 cubic feet per second and an average absolute residual of about 34 cubic feet per second were calculated for the 568 flow measurements in the 31 sites obtained from the National Water Information System for a range in computed base flows of about 1,141 cubic feet per second. The numerical representation of the hydrogeologic information used in the development of this regional flow model was dependent upon how the aquifer system and simulated hydrologic stresses were discretized in space and time. Lumping hydraulic parameters in space and hydrologic stresses and time-varying observational data in time can limit the capabilities of this tool to simulate how the groundwater flow system responds to changes in hydrologic stresses, particularly at the local scale.

The U.S. Geological Survey began a multiyear regional assessment of groundwater availability in the Northern Atlantic Coastal Plain (NACP) aquifer system in 2010 as part of its ongoing regional assessments of groundwater availability of the principal aquifers of the Nation. The goals of this national assessment are to document effects of human activities on water levels and groundwater storage, explore climate variability effects on the regional water budget, and provide consistent and integrated information that is useful to those who use and manage the groundwater resource. As part of this nationwide assessment, the USGS evaluated available groundwater resources within the NACP aquifer system from Long Island, New York, to northeastern North Carolina.The northern Atlantic Coastal Plain physiographic province depends heavily on groundwater to meet agricultural, industrial, and municipal needs. The groundwater assessment of the NACP aquifer system included an evaluation of how water use has changed over time; this evaluation primarily used groundwater budgets and development of a numerical modeling tool to assess system responses to stresses from future human uses and climate trends.This assessment focused on multiple spatial and temporal scales to examine changes in groundwater pumping, storage, and water levels. The regional scale provides a broad view of the sources and demands on the system with time. The sub-regional scale provides an evaluation of the differing response of the aquifer system across geographic areas allowing for closer examination of the interaction between different aquifers and confining units and the changes in these interactions under pumping and recharge conditions in 2013 and hydrologic stresses as much as 45 years in the future. By focusing on multiple scales, water-resource managers may utilize this study to understand system response to changes as they affect the system as a whole.The NACP aquifer system extends from Long Island to northeastern North Carolina, and includes aquifers primarily within New York, New Jersey, Delaware, Maryland, Virginia, and North Carolina. The seaward-dipping sedimentary wedge that underlies the northern Atlantic Coastal Plain physiographic province forms a complex groundwater system. Although the NACP aquifer system is recognized by the U.S. Geological Survey as one of the smallest of the 66 principal aquifer systems in the Nation, it ranks 13th overall in terms of total groundwater withdrawals and is 7th in population served. Despite abundant precipitation [about 45 inches per year (in/yr)], the supply of fresh surface water in this region is limited because many of the surface waters in this area are brackish estuaries, contributing to why many communities in the northern Atlantic Coastal Plain physiographic province rely heavily on groundwater to meet their water needs.Increases in population and changes in land use during the past 100 years have resulted in diverse increased demands for freshwater throughout the northern Atlantic Coastal Plain physiographic province with groundwater serving as a vital source of drinking water for the nearly 20 million people who live in the region. Total groundwater withdrawal in 2013 was estimated to be about 1,300 million gallons per day (Mgal/d) and accounts for about 40 percent of the drinking water supply with the densely populated areas tending to have the highest rates of withdrawals and, therefore, being most susceptible to effects from these withdrawals over time.Water levels in many of the confined aquifers are decreasing by as much as 2 feet per year (ft/yr) in response to extensive development and subsequent increased withdrawals throughout the region. Total water-level decreases (drawdowns) are more than 100 feet (ft) in some aquifers from their predevelopment (before 1900) levels. These drawdowns extend across state lines and under the Chesapeake and Delaware Bays, creating the potential for interstate aquifer management issues. Regional water-resources managers in the northern Atlantic Coastal Plain physiographic province face challenges beyond competing local domestic, industrial, agricultural, and environmental demands for water. Large changes in regional water use have made the State-level management of aquifer resources more difficult because of hydrologic effects that extend beyond State boundaries.The northern Atlantic Coastal Plain physiographic province is underlain by a wedge of unconsolidated to partially consolidated sediments that are typically thousands of feet thick along the coastline with a maximum thickness of about 10,000 ft near the edge of the continental shelf. The NACP aquifer system consists of nine confined aquifers and nine confining units capped by an unconfined surficial aquifer that is bounded laterally from the west by the contact between Coastal Plain sediments and the upland Piedmont bedrock. This aquifer system extends to the east to the limit of the Continental Shelf, however, the boundary between fresh and saline groundwater is considered to be much closer to the shoreline and varies vertically by aquifer.Precipitation over the region for average conditions from 2005 to 2009 is about 61,800 Mgal/d, but about 70 percent of it is lost to evapotranspiration resulting in an inflow of about 19,600 Mgal/d entering the groundwater system as aquifer recharge. Most of this recharge enters the aquifer system and flows through the shallow unconfined aquifer and either discharges to streams or directly to coastal waters without reaching the deep, confined aquifer system. In addition to recharge from precipitation, other sources of water include the return of wastewater from domestic septic systems of about 240 Mgal/d, about 60 Mgal/d of water released from storage in the confined system, and about 30 Mgal/d of lateral inflow at the boundary between freshwater and saltwater in response to pumping for conditions in 2013.The outflow needed to balance...