ABAleksandar Boricic

Aleksandar Boricic

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Aleksandar Boricic has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Thermal drift in an inclined viscous fluid flow

    by Miloš M. Jovanović, Saša M. Milanović, Aleksandar Boricic, Živan T. Spasić

    This paper considers viscous fluid flow in a slot between two parallel plates which start inclining with respect to the horizontal line. The lower plate was heated and had non-homogeneous temperature distribution while the upper plate was cooled and with homogeneous temperature distribution. The spatially periodic temperature distribution was gradually applied at the lower plate, after which the plates were slowly inclined in the positive-counterclockwise direction, and the fields of vorticity, stream function, and temperature are presented for different values of the angle of inclination. We used the vorticity-stream function formulation of Navier-Stokes equations, Fourier-Galerkin, and Chebyshev collocation method for numerical simulation of 2-D viscous fluid flow. We carried out numerical simulation using our in-house MATLAB code for subcritical uniform Rayleigh number, Rauni, and periodic Rayleigh number, Rap, on the lower plate. An accurate numerical scheme was developed to capture the full time-dependent behavior here. The interest lied in how the intensities of the vortexes and convection rolls changed as the inclination angle was increased with respect to time. Convection rolls rotating in the clockwise direction expanded and the rolls rotating in the counterclockwise direction shrank and their centers moved closer to the lower wall. Thermal drift appeared between them when the inclination angle started increasing.


  • Open Access

    New method for calculating heat transfer in unsteady MHD mixed boundary-layers with radiative and generation heat over a cylinder

    by Aleksandar Z. Boričić, Mirjana S. Laković, Miloš M. Jovanović

    This paper is devoted to the analysis of an unsteady 2-D MHD dynamic and thermal boundary-layer over a horizontal cylinder in mixed convection, in the presence of suction/injection, heat source/sink, and heat radiation fluid electrical conductivity is constant. The system of MHD equations of dynamic and temperature boundary-layer, which describe complex non-auto model problems, has been solved by a new approach. New variables and sets of parameters were introduced and transformed equations were obtained, in which the influence of the magnitude Z was explicitly retained. In order to close the system of equations, to the equations of the boundary-layers momentum equation was added. The solution of the obtained system of non-linear differential equations was performed numerically using the finite difference method, with the simultaneous application of the iteration method. By replacing the derivatives in the system of equations with the corresponding relations of finite differences, a system of linear derivative algebraic equations is obtained, which is solved by the three-diagonal method. As a concrete example of the introduced method, the effects of heat transfer in the MHD boundary-layers were considered, in the case of mixed convention, over a horizontal circular cylinder. The boundary conditions for temperature are defined by linear functions of longitudinal co-ordinates and time. Numerical results for different Eckart, Schmidt, and expanded Prandtl numbers and values: magnetic, dynamic, thermal parameters, temperature, and buoyancy parameters were obtained and presented. The obtained results were analyzed through the diagrams of changes in velocity and temperature and the diagrams of integral and differential characteristics of boundary-layers and the corresponding conclusions were given.


  • Open Access

    Unsteady magnetohydrodynamic thermal and diffusion boundary layer from a horizontal circular cylinder

    by Aleksandar Boricic, Milos Jovanovic, Branko Boricic

    The unsteady 2-D dynamic, thermal, and diffusion magnetohydrodynamic laminar boundary layer flow over a horizontal cylinder of incompressible and electrical conductivity fluid, in mixed convection in the presence of heat source or sink and chemical reactions. The present magnetic field is homogenous and perpendicular to the body surface. It is assumed that induction of outer magnetic field is a function of longitudinal co-ordinate outer electric field is neglected and magnetic Reynolds number is significantly lower than one, i. e. considered the problem is in approximation without induction. Fluid electrical conductivity is constant. Free stream velocity, temperature, and concentration on the body are functions of longitudinal co-ordinate. The developed governing boundary layer equations and associated boundary conditions are made dimensionless using a suitable similarity transformation and similarity parameters. System of non-dimensionless equations is solved using the implicit finite difference three-diagonal and iteration method. Numerical results are obtained and presented for different Prandtl, Eckart, and Schmidt numbers, and values: magnetic parameter, temperature, and diffusion parameters, buoyancy temperature parameters, thermal parameter, and chemical reaction parameter. Variation of velocity profiles, temperature and diffusion distributions, and many integral and differential characteristics, boundary layer, are evaluated numerically for different values of the magnetic field. Transient effects of velocity, temperature and diffusion are analyzed. A part of obtained results is given in the form of figures and corresponding conclusions.


  • Open Access

    Unsteady magnetohydrodynamic mixed convection flow with heat and mass transfer over a horizontal circular cylinder embedded in a porous medium

    by Branko Boricic, Aleksandar Boricic

    The objective of the present study is to investigate the effect of flow parameters on the mixed convection heat and mass transfer of an unsteady magnetohydrodynamic flow of an electrically conducting, viscous, and incompressible fluid over a horizontal circular cylinder embedded in porous medium, considering effects of chemical reaction and heat source/sink, by taking into account viscous dissipation. The present magnetic field is homogenous and perpendicular to the body surface. Magnetic Reynolds number is significantly lower than one i. e. considered the problem is in approximation without induction. The governing non-linear partial differential equations and associated boundary conditions are made dimensionless using a suitable similarity transformation and similarity parameters. System of non-dimensionless equations are solved numerically by implicit finite difference three-diagonal and iteration method. Numerical results obtained for different values of porous medium, magnetic, diffusion and temperature parameters, buoyancy diffusion parameter and thermal parameter and for different values Prandtl, Echart, and Schmidt numbers. Variation of velocity, temperature and concentration and many integral and differential characteristics boundary layer are discussed and shown graphically.


  • Open Access

    MHD effects on unstedy dynamic, thermal and diffusion boundary layer flow over a horizontal circular cylinder

    by Aleksandar Boricic, Milos Jovanovic, Branko Boricic

    This paper is devoted to the analysis of unsteady two-dimensional dynamic, thermal and diffusion magnetohydrodynamic laminar boundary layer flow over a horizontal circular cylinder of incompressible and electrical conductivity fluid, in a porous medium, in the presence of a heat source or sink, and chemical reactions. The present magnetic field is homogenous and perpendicular to the body surface. It is assumed that the induction of the outer magnetic field is the function of the longitudinal coordinate and time. Fluid electrical conductivity is constant. The outer electric field is neglected and the magnetic Reynolds number is significantly lower than one i. e. the considered the problem is in induction-less approximation. Free stream velocity, temperature and concentration on the body are arbitrary differentiable functions. The developed governing boundary layer equations and associated boundary conditions are converted into a nondimensional form using a suitable similarity transformation and similarity parameters. The system of dimensionless equations is solved using the finite difference method and iteration method. Numerical results are obtained and presented for incompressible fluid for different numbers, such as Sc, Pr, Ec and magnetic number, and the parameter of the porous medium, temperature parameters, thermal parameter, diffusion parameters and chemical reaction parameter. The solutions for the flow, temperature and diffusion transfer and other integral characteristics, boundary layer, are evaluated numerically for different values of the magnetic field. Transient effects of velocity, temperature and diffusion are analyzed. A part of obtained results is given in the form of figures and corresponding conclusions.


  • Open Access

    Active control of flow and heat transfer in boundary layer on the porous body of arbitrary shape

    by Dragisa Nikodijevic, Zivojin Stamenkovic, Dragan Zivkovic, Aleksandar Boricic, Milos Kocic

    The paper discusses the possibility of active control of flow and heat transfer using a magnetic field and suction in a generalized form. The unsteady temperature two-dimensional laminar magnetohydrodynamic boundary layer of incompressible fluid on a porous body of arbitrary shape is analyzed. Outer electric filed is neglected, magnetic Reynolds number is significantly lower than one i. e. the considered problem is in inductionless approximation. Characteristic properties of fluid are constant and it is assumed that a uniform suction or injection of a fluid, same as the fluid in primary flow, can take place through the body surface. The boundary-layer equations are generalized such that the equations and the boundary conditions are independent of the particular conditions of the problem, and this form is considered as universal. Obtained universal equations are numerically solved using the ?progonka? method. Numerical results for the dimensionless velocity, temperature, shear stress and heat transfer as functions of introduced sets of parameters are obtained, displayed graphically and used to carry out general conclusions about the development of temperature magnetohydrodynamic boundary layer.