Zhengning Gao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Zhengning Gao has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Parag Banerjee
Department of Materials Science and Engineering, University of Central Florida 1 , Orlando, Florida 32816
5 shared publications Corbin Feit
Department of Materials Science and Engineering University of Central Florida Orlando FL 32816 USA
2 shared publications- Geoffrey Gregory
Department of Materials Science and Engineering University of Central Florida Orlando FL 32816 USA
2 shared publications - Kristopher Olan Davis
University of Central Florida
2 shared publications - Mallik M. R. Hussain
Department of Electro-Optics and Photonics, University of Dayton, Dayton, Ohio 45469, USA
2 shared publications - Maria Antonietta Vincenti
Department of Information Engineering, University of Brescia, Brescia, Italy
2 shared publications
Latest Publications
- Open Access
- 7 August 2020
- Published by Wiley in Physica Status Solidi (a)
- Vol. 217 (15)
Improving the Passivation of Molybdenum Oxide Hole‐Selective Contacts with 1 nm Hydrogenated Aluminum Oxide Films for Silicon Solar Cells
- 7 August 2020
- Published by Wiley in Physica Status Solidi (a)
- Vol. 217 (15)
Open AccessImproving the Passivation of Molybdenum Oxide Hole‐Selective Contacts with 1 nm Hydrogenated Aluminum Oxide Films for Silicon Solar Cells
- 27 May 2020
- Published by Wiley in Physica Status Solidi (a)
- Vol. 217 (15) , 2000093
Improving the Passivation of Molybdenum Oxide Hole‐Selective Contacts with 1 nm Hydrogenated Aluminum Oxide Films for Silicon Solar Cells
The intrinsic and doped amorphous silicon layers in silicon heterojunction solar cells parasitically absorb light in the short wavelength region of the solar spectrum, lowering the generation current available to the device. Herein, a promising alternative to the hole‐selective amorphous silicon contact layers using only wide bandgap, transparent oxide materials is presented. Using thermal atomic layer deposition, a 1 nm hydrogenated aluminum oxide layer is deposited followed by a 4 nm molybdenum oxide layer on n‐type crystalline silicon. This contact stack provides an effective carrier lifetime of 1.14 ms. It is shown that the molybdenum oxide layer is successfully deposited with a high work function, which facilitates efficient hole extraction and repels majority carriers from the c‐Si surface. Then the implied open‐circuit voltage, saturation current density, and contact resistivity are recorded as a function of contact annealing temperature and show that they are relatively stable up to 200 °C.
- 27 May 2020
- Published by Wiley in Physica Status Solidi (a)
- Vol. 217 (15) , 2000093
Improving the Passivation of Molybdenum Oxide Hole‐Selective Contacts with 1 nm Hydrogenated Aluminum Oxide Films for Silicon Solar Cells
The intrinsic and doped amorphous silicon layers in silicon heterojunction solar cells parasitically absorb light in the short wavelength region of the solar spectrum, lowering the generation current available to the device. Herein, a promising alternative to the hole‐selective amorphous silicon contact layers using only wide bandgap, transparent oxide materials is presented. Using thermal atomic layer deposition, a 1 nm hydrogenated aluminum oxide layer is deposited followed by a 4 nm molybdenum oxide layer on n‐type crystalline silicon. This contact stack provides an effective carrier lifetime of 1.14 ms. It is shown that the molybdenum oxide layer is successfully deposited with a high work function, which facilitates efficient hole extraction and repels majority carriers from the c‐Si surface. Then the implied open‐circuit voltage, saturation current density, and contact resistivity are recorded as a function of contact annealing temperature and show that they are relatively stable up to 200 °C.
- 11 March 2019
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 125 (10) , 105302
Harmonic generation in metal-insulator and metal-insulator-metal nanostructures
Large reduction in second and third harmonic signals is measured when a sub-nanometer-to-nanometer thick insulator film is deposited over a gold substrate. Such reduction in signal reveals the spilled-out electronic states in the insulator region at the vicinity of the metal-insulator (MI) interface, which are dubbed metal insulator gap states. For metal-insulator-metal (MIM) structures, we observe electric-field enhancement saturation and quenching of the third harmonic efficiencies well above the efficiencies for MI samples. The measured harmonics of incident light scattered from the MI and MIM systems are compared with detailed simulations that account for the nonlinear interactions of free electrons spilled out into the insulator and the nonlocality and electron quantum tunneling effects. Two insulator materials (ZnO and Al2O3) are used in the experiments, and atomic layer deposition is used to cover the gold substrate with variable thickness of the insulator films. On the basis of our simulations, we conclude that the observed MIM third-harmonic signal enhancement (and quenching) effects are primarily due to the nonlocal phenomena in an electron gas. As a consequence of our findings, second- and third-harmonic scattering signals can be analyzed to extract the spill-out electron density in the insulator.
- 11 March 2019
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 125 (10) , 105302
Harmonic generation in metal-insulator and metal-insulator-metal nanostructures
Large reduction in second and third harmonic signals is measured when a sub-nanometer-to-nanometer thick insulator film is deposited over a gold substrate. Such reduction in signal reveals the spilled-out electronic states in the insulator region at the vicinity of the metal-insulator (MI) interface, which are dubbed metal insulator gap states. For metal-insulator-metal (MIM) structures, we observe electric-field enhancement saturation and quenching of the third harmonic efficiencies well above the efficiencies for MI samples. The measured harmonics of incident light scattered from the MI and MIM systems are compared with detailed simulations that account for the nonlinear interactions of free electrons spilled out into the insulator and the nonlocality and electron quantum tunneling effects. Two insulator materials (ZnO and Al2O3) are used in the experiments, and atomic layer deposition is used to cover the gold substrate with variable thickness of the insulator films. On the basis of our simulations, we conclude that the observed MIM third-harmonic signal enhancement (and quenching) effects are primarily due to the nonlocal phenomena in an electron gas. As a consequence of our findings, second- and third-harmonic scattering signals can be analyzed to extract the spill-out electron density in the insulator.
- 29 January 2019
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 31 (4) , 1304-1317
Self-Catalyzed, Low-Temperature Atomic Layer Deposition of Ruthenium Metal Using Zero-Valent Ru(DMBD)(CO)3 and Water
- 29 January 2019
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 31 (4) , 1304-1317
Self-Catalyzed, Low-Temperature Atomic Layer Deposition of Ruthenium Metal Using Zero-Valent Ru(DMBD)(CO)3 and Water
- 31 October 2017
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 5 (47) , 24728-24739
Atmospheric pressure chemical vapor deposition of methylammonium bismuth iodide thin films
We demonstrate the atmospheric pressure chemical vapor deposition of methyl ammonium bismuth iodide ((CH3NH3)3Bi2I9 or MA3Bi2I9) films. MA3Bi2I9 possesses an indirect optical bandgap of 1.80 eV and a room temperature excitonic peak at 511 nm. In contrast to recent reports, the films are n-type semiconductors with a room temperature carrier concentration of 3.36 × 1018 cm−3 and a Hall mobility of 18 cm2 V−1 s−1, which are superior to those of solution-processed, undoped films. The precursors used for the deposition are methylammonium iodide and bismuth iodide which are co-sublimated at 199 °C and 230 °C, respectively, in an Ar flow inside a tube furnace with a variable temperature profile. The substrate temperature is set at 160 °C, and dense polycrystalline films (∼775 nm thick) are deposited. Extensive characterization combined with first-principles density functional theory calculations unravels the synthesis–structure–property relationship in these films. The degradation of properties under ambient conditions results from film oxidation with a characteristic bi-exponential decay in resistivity, signifying a fast surface oxidation followed by a slower oxidation of the bulk.
- 31 October 2017
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 5 (47) , 24728-24739
Atmospheric pressure chemical vapor deposition of methylammonium bismuth iodide thin films
We demonstrate the atmospheric pressure chemical vapor deposition of methyl ammonium bismuth iodide ((CH3NH3)3Bi2I9 or MA3Bi2I9) films. MA3Bi2I9 possesses an indirect optical bandgap of 1.80 eV and a room temperature excitonic peak at 511 nm. In contrast to recent reports, the films are n-type semiconductors with a room temperature carrier concentration of 3.36 × 1018 cm−3 and a Hall mobility of 18 cm2 V−1 s−1, which are superior to those of solution-processed, undoped films. The precursors used for the deposition are methylammonium iodide and bismuth iodide which are co-sublimated at 199 °C and 230 °C, respectively, in an Ar flow inside a tube furnace with a variable temperature profile. The substrate temperature is set at 160 °C, and dense polycrystalline films (∼775 nm thick) are deposited. Extensive characterization combined with first-principles density functional theory calculations unravels the synthesis–structure–property relationship in these films. The degradation of properties under ambient conditions results from film oxidation with a characteristic bi-exponential decay in resistivity, signifying a fast surface oxidation followed by a slower oxidation of the bulk.
- 16 October 2017
- Published by AIP Publishing in Applied Physics Letters
- Vol. 111 (16)
Unraveling delocalized electrons in metal induced gap states from second harmonics
Second harmonic generation from Au-Al2O3 interfaces is analyzed to estimate the density of delocalized electrons occupying metal induced gap states (MIGS). Laser light of wavelength 810 nm is incident on an Au substrate and the second harmonic at 405 nm is monitored, where the area fraction of Al2O3 coverage on Au is precisely controlled via atomic layer deposition—from no coverage to full coverage. Extensive electromagnetic simulations are performed using a phenomenological model containing a dimensionless MIGS factor “α,” to represent the strength of the delocalized electrons in MIGS in attenuating the second harmonic signal. By fitting the model to experimental data, an α = 0.13 is obtained leading to a room temperature, areal density of delocalized electrons of (3.53 ± 0.4) × 1014 cm−2 for the Au-Al2O3 interface and representing a 44% occupancy of MIGS.
- 16 October 2017
- Published by AIP Publishing in Applied Physics Letters
- Vol. 111 (16)
Unraveling delocalized electrons in metal induced gap states from second harmonics
Second harmonic generation from Au-Al2O3 interfaces is analyzed to estimate the density of delocalized electrons occupying metal induced gap states (MIGS). Laser light of wavelength 810 nm is incident on an Au substrate and the second harmonic at 405 nm is monitored, where the area fraction of Al2O3 coverage on Au is precisely controlled via atomic layer deposition—from no coverage to full coverage. Extensive electromagnetic simulations are performed using a phenomenological model containing a dimensionless MIGS factor “α,” to represent the strength of the delocalized electrons in MIGS in attenuating the second harmonic signal. By fitting the model to experimental data, an α = 0.13 is obtained leading to a room temperature, areal density of delocalized electrons of (3.53 ± 0.4) × 1014 cm−2 for the Au-Al2O3 interface and representing a 44% occupancy of MIGS.