BBBirger Berghoff

Birger Berghoff

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Birger Berghoff has a total of 96 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Electronic Structure Shift of Deeply Nanoscale Silicon by SiO2 versus Si3N4 Embedding as an Alternative to Impurity Doping

    by Dirk König, Noël Wilck, Daniel Hiller, Birger Berghoff, Alexander Meledin, Giovanni Di Santo, Luca Petaccia, Joachim Mayer, Sean Smith, Joachim Knoch

    Conventional impurity doping of deeply nanoscale silicon (dns-Si) used in ultra-large-scale integration (ULSI) faces serious challenges below the 14-nm technology node. We report on a fundamental effect in theory and experiment, namely the electronic structure of dns-Si experiencing energy offsets of approximately 1 eV as a function of SiO2 versus Si3N4 embedding with a few monolayers (MLs). An interface charge transfer (ICT) from dns-Si specific to the anion type of the dielectric is at the core of this effect and is arguably nested in the quantum-chemical properties of oxygen (O) and nitrogen (N) versus Si. We investigate the size up to which this energy offset defines the electronic structure of dns-Si by density-functional theory (DFT), considering the interface orientation, the embedding-layer thickness, and approximants featuring two Si nanocrystals (NCs), one embedded in SiO2 and the other in Si3N4. Working with synchrotron ultraviolet- (UV) photoelectron spectroscopy (UPS), we use SiO2- versus Si3N4-embedded Si nanowells (NWells) to obtain their energy of the top valence-band states. These results confirm our theoretical findings and gauge an analytic model for projecting maximum dns-Si sizes for NCs, nanowires (NWires), and NWells where the energy offset reaches full scale, yielding a clear preference for electrons or holes as majority carriers in dns-Si. Our findings can replace impurity doping for n- or p-type dns-Si as used in ultra-low-power electronics and ULSI, eliminating dopant-related issues such as inelastic carrier scattering, thermal ionization, clustering, out-diffusion, and defect generation. As far as majority-carrier preference is concerned, the elimination of those issues effectively shifts the lower size limit of Si-based ULSI devices to the crystallization limit of Si of approximately 1.5 nm and also enables them to work under cryogenic conditions.


  • Role of elemental intermixing at the In2S3/CIGSe heterojunction deposited using reactive RF magnetron sputtering

    by Purvesh Soni, Mohit Raghuwanshi, Roland Wuerz, Birger Berghoff, Joachim Knoch, Dierk Raabe, Oana Cojocaru-Mirédin


  • Open Access

    Sputtering as a viable route for In2S3 buffer layer deposition in high efficiency Cu(In,Ga)Se2 solar cells

    by Purvesh Soni, Mohit Raghuwanshi, Roland Wuerz, Birger Berghoff, Joachim Knoch, Dierk Raabe, Oana Cojocaru‐Mirédin

    Alternative buffer layers in CIGSe are deposited mainly using chemical bath deposition because of its benefits like simplicity, good film quality and surface/step coverage. All the layers in CIGSe cell stack such as back contact, absorber and window layers are deposited by vacuum–deposition methods such as coevaporation, sputtering, and sometimes thermal evaporation, except for the buffer layer. Therefore, in the present work we demonstrate the feasibility to deposit In2S3 by RF magnetron sputtering reaching cell efficiencies of 13.6%, which is the highest value available for sputtered In2S3 in literature to date. Absorber surface damage and nonuniform buffer layer thickness are the primary limitations when using sputtering, and hence need to be eliminated for reaching reasonable cell efficiencies. We studied the extent of sputter induced damage on CIGSe absorber as well as the sputtering– and annealing–induced intermixing phenomenon at the In2S3/Cu(In,Ga)Se2 interface at the subnanometer level using atom probe tomography. We have also shown that a post deposition annealing not only significantly improves the crystallinity of In2S3, but also recovers the surface damage caused by sputter‐induced intermixing resulting in an improved p‐n Junction quality (as shown by the electron beam induced current investigations), and substantially improves cell efficiency. The present work opens a new way for designing efficient and industry–compatible CIGSe cells using sputter–deposited Cd‐free buffer layers. Moreover, this work clearly demonstrates that this novel and fully vacuum–deposited CIGSe cell meets the standard requirements, in terms of chemistry, structure, and electrical performance of a working cell for the PV industry.


  • Open Access

    Intrinsic ultrasmall nanoscale silicon turns n-/p-type with SiO2/Si3N4-coating

    by Dirk König, Daniel Hiller, Noël Wilck, Birger Berghoff, Merlin Müller, Sangeeta Thakur, Giovanni Di Santo, Luca Petaccia, Joachim Mayer, Sean Smith, et al.

    Intrinsic ultrasmall nanoscale silicon turns n-/p-type with SiO2/Si3N4-coating Intrinsic ultrasmall nanoscale silicon turns n-/p-type with SiO2/Si3N4-coating


  • Quasi-metallic behavior of ZnO grown by atomic layer deposition: The role of hydrogen

    by Holger Beh, Daniel Hiller, Michael Bruns, Alexander Welle, Hans-Werner Becker, Birger Berghoff, Christoph Sürgers, Rolf Merz, Margit Zacharias

    Zinc oxide (ZnO) fabricated by atomic layer deposition (ALD) is intrinsically well-conductive (∼5 mΩ cm), in contrast to the single-crystalline bulk material or sputtered ZnO thin films. There are generally three groups of candidates for the intrinsic n-type conductivity: intrinsic point defects, elemental impurities other than hydrogen, and incorporated hydrogen itself. In this study, we assess the different candidates concerning their impact on conductivity. In the presence of free electron densities of up to 5 × 1019 cm−3, impurities other than hydrogen are ruled out due to their ultra-low concentrations in the ppm range. Intrinsic point defects are also considered unlikely since the evolution of conductivity with deposition temperature is not reproduced in the Zn/O ratio as measured by Rutherford backscattering spectrometry. Hence, the most promising candidate is hydrogen with a concentration of ∼1 at. %, i.e., more than sufficient to account for the free electron density. In addition, we find a correlation between the deposition-temperature dependence of the carrier concentration and the hydrogen concentration. The formation energy of the conductive, hydrogen-related state is determined to be ∼40 meV. Hall measurements down to liquid helium temperatures revealed that the electron densities are constant over the whole temperature range. This constitutes a quasi-metallic behavior of ALD-ZnO for deposition temperatures of ≥150 °C. We propose that the very high concentration of hydrogen-induced donor states causes a vanishing ionization energy so that the donor band merges energetically with the ZnO conduction band. This model is supported by ultraviolet photoelectron spectroscopy measurements.


  • A monolithic all-silicon multi-junction solar device for direct water splitting

    by S. Nordmann, B. Berghoff, A. Hessel, N. Wilck, B. Osullivan, M. Debucquoy, J. John, S. Starschich, J. Knoch


  • Dopant‐free complementary metal oxide silicon field effect transistors

    by Sergej Fischer, Hauke Ingolf Kremer, Birger Berghoff, Tobias Maß, Thomas Taubner, Joachim Knoch

    Authoren We present a dopant‐free CMOS technology where n‐ and p‐type semiconductor contacts are realized exclusively based on ultrathin silicon nitrides and metals with appropriate work function. Ellipsometry and FTIR measurements are applied to characterize the thermally grown nitride layers. Unipolar behavior and ohmic contact behavior are accomplished showing that with an appropriate nitride thickness dangling bonds as well as metal‐induced gap states can be suppressed, thus yielding a depinning of the Fermi level. n‐type and –for the first time – p‐type MOSFETs using low‐ and high‐work‐function metals such as aluminum, nickel, or platinum are successfully presented. In contrast to (metal–silicon) Schottky‐barrier MOSFETs, the fabricated devices exhibit on/off ratios larger than.


  • Investigation of dopant segregation induced surface-fields using THz pulse transmission

    by M. Lenz, A. Kianfar, S. Nordmann, S. Sawallich, M. Nagel, B. Berghoff, J. Knoch

    Doping layers like the emitter or a surface field in silicon solar cells have to fulfill two important functions: They have to allow ohmic contact formation and they should also suppress Auger and surface recombination effects. The latter can be supported by an electrical field, provided by the layer itself. In the case of an emitter this is provided by a peak doping concentration beneath the surface, like a segregation layer, formed during a silicidation process. Layers, like front surface fields applied in rear emitter concepts have a significant influence on the performance of the resulting solar cell, which is very sensitive for process fluctuations. For all these reasons, it is crucial to have an appropriate tool for analyzing these layers in terms of the resulting lifetime. Current established measurement methods are not able to provide the sufficient sensitivity, to carry out further investigations. In this work a method, based on THz transmission through the silicon material is presented to analyze these layers. Corresponding measurements were carried out with two kind of samples: a sample containing a front surface field and a sample with a dopant segregation layer. Depth dependent THz measurements were carried out, by etching the surface layers back. It is shown in this work, that the segregation layer has a large influence on the resulting effective excess carrier density or lifetime, respectively of the material.

  • Defect passivation by hydrogen reincorporation for silicon quantum dots in SiC/SiOx hetero-superlattice

    by Kaining Ding, Urs Aeberhard, Oleksandr Astakhov, Uwe Breuer, Maryam Beigmohamadi, Stephan Suckow, Birger Berghoff, Wolfhard Beyer, Friedhelm Finger, Reinhard Carius, et al.