Aaron M. Scurto
Research Subjects
Research Interests
Aaron M. Scurto has a total of 105 co-authors. Here are the top co-authors by number of shared publications:
- Mark Brandon Shiflett
University of Kansas
12 shared publications - Diego Trevisan Melfi
Department of Chemical and Petroleum Engineering
7 shared publications Ana Rita C. Morais
5 shared publications- Rajkumar Kore
College of Arts & Sciences, The University of Alabama, Tuscaloosa, Alabama 35487, United States
5 shared publications - Karim S. Al-Barghouti
Department of Chemical and Petroleum Engineering, University of Kansas, Lawrence, USA
4 shared publications - Linda J. Broadbelt
Northwestern University 2145 Sheridan Road
4 shared publications
Latest Publications
- Open Access
- 7 October 2026
- Published by Elsevier in SSRN Electronic Journal
Multicomponent Measurement and Modeling of the Solid–Liquid and Solid–Solid–Liquid Equilibria of N-Phenylsuccinimide and Succinanilic Acid in DMF/Antisolvent Mixtures
N-Phenylsuccinimide (NPS) is used in several industrial products and can be synthesized from succinanilic acid (SA) in dimethylformamide (DMF). However, incomplete conversion generally produces mixtures of NPS and residual SA in the reactor effluent. Antisolvent crystallization is a potential separation strategy but requires reliable multicomponent solubility data for NPS and SA and well-tuned thermodynamic models. In this study, openCOSMO-RS was evaluated for cosolvent/antisolvent screening and water, 2-propanol, and ethyl acetate were chosen for experimental studies. The melting point and enthalpy of fusion for the pure NPS and SA were measured. Solid-liquid equilibrium (SLE) and solid-solid-liquid equilibrium (SSLE) of binary, ternary, and quaternary systems involving NPS, SA, DMF, water, ethyl acetate, and 2-propanol were measured at temperatures between 10°C and 25°C. Water and 2-propanol act as antisolvents for NPS in DMF, while only water showed an antisolvent effect for SA. Ethyl acetate behaves as a cosolvent in the studied DMF mixtures. While openCOSMO-RS was able to predict the general qualitative trends, the NRTL activity coefficient model was used to correlate the binary data and predict higher-order mixtures. The NRTL parameters obtained only from binary SLE data described pure-solvent systems well but did not represent ternary DMF/antisolvent systems quantitatively for all systems. However, including ternary SLE data in the regression improved the correlation and would allow design and simulation of a crystallizer.
- 7 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessMulticomponent Measurement and Modeling of the Solid–Liquid and Solid–Solid–Liquid Equilibria of N-Phenylsuccinimide and Succinanilic Acid in DMF/Antisolvent Mixtures
N-Phenylsuccinimide (NPS) is used in several industrial products and can be synthesized from succinanilic acid (SA) in dimethylformamide (DMF). However, incomplete conversion generally produces mixtures of NPS and residual SA in the reactor effluent. Antisolvent crystallization is a potential separation strategy but requires reliable multicomponent solubility data for NPS and SA and well-tuned thermodynamic models. In this study, openCOSMO-RS was evaluated for cosolvent/antisolvent screening and water, 2-propanol, and ethyl acetate were chosen for experimental studies. The melting point and enthalpy of fusion for the pure NPS and SA were measured. Solid-liquid equilibrium (SLE) and solid-solid-liquid equilibrium (SSLE) of binary, ternary, and quaternary systems involving NPS, SA, DMF, water, ethyl acetate, and 2-propanol were measured at temperatures between 10°C and 25°C. Water and 2-propanol act as antisolvents for NPS in DMF, while only water showed an antisolvent effect for SA. Ethyl acetate behaves as a cosolvent in the studied DMF mixtures. While openCOSMO-RS was able to predict the general qualitative trends, the NRTL activity coefficient model was used to correlate the binary data and predict higher-order mixtures. The NRTL parameters obtained only from binary SLE data described pure-solvent systems well but did not represent ternary DMF/antisolvent systems quantitatively for all systems. However, including ternary SLE data in the regression improved the correlation and would allow design and simulation of a crystallizer.
- Open Access
- 24 June 2026
- Published by Elsevier in SSRN Electronic Journal
Vapor-Liquid Equilibrium and Thermophysical Properties of the Deep Eutectic Solvent, Choline Chloride: Ethylene Glycol (1:3), with the Hydrofluorocarbons HFC-32, HFC-125 and HFC-134a
Regulations requiring the phase down of high global warming potential (GWP) hydrofluorocarbons (HFCs) have motivated the development of efficient separation technologies for HFC blends. Such blends are often near-azeotropic/azeotropic and difficult to separate by fractional distillation. Deep Eutectic Solvents (DESs) have emerged as promising entrainers for extractive distillation of such mixtures. In this work, vapor-liquid equilibrium (VLE), Fickian diffusivity, and saturated liquid density and viscosity data were measured for difluoromethane (HFC‑32), pentafluoroethane (HFC‑125), and 1,1,1,2-tetrafluoroethane (HFC‑134a) with pure ethylene glycol (EG) and a DES composed of choline chloride (ChCl) and ethylene glycol (EG) in a molar ratio of 1:3 (ChCl:EG=1:3). Vapor-liquid equilibrium (VLE), and saturated liquid density and viscosity measurements were conducted at temperatures from 298.15 to 348.15 K and pressures up to 5 MPa using a custom Phase Equilibrium and Thermophysical Properties Apparatus (PETPA). VLE data demonstrate that, in a mole fraction basis, HFC-32 has higher solubility in ChCl:EG (1:3) DES than HFC-125 and HFC-134a at a given temperature and pressure, resulting in high selectivity values required for the effective separation of HFC blends. Diffusion coefficients calculated from gravimetric absorption experiments indicate faster diffusion of HFC‑32 relative to HFC‑125 and HFC‑134a in ChCl:EG (1:3) DES at 298.15 K and similar compositions. The experimental VLE data were well correlated with the PCP-SAFT equation of state for all HFC/EG and HFC/DES systems.
- 24 June 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessVapor-Liquid Equilibrium and Thermophysical Properties of the Deep Eutectic Solvent, Choline Chloride: Ethylene Glycol (1:3), with the Hydrofluorocarbons HFC-32, HFC-125 and HFC-134a
Regulations requiring the phase down of high global warming potential (GWP) hydrofluorocarbons (HFCs) have motivated the development of efficient separation technologies for HFC blends. Such blends are often near-azeotropic/azeotropic and difficult to separate by fractional distillation. Deep Eutectic Solvents (DESs) have emerged as promising entrainers for extractive distillation of such mixtures. In this work, vapor-liquid equilibrium (VLE), Fickian diffusivity, and saturated liquid density and viscosity data were measured for difluoromethane (HFC‑32), pentafluoroethane (HFC‑125), and 1,1,1,2-tetrafluoroethane (HFC‑134a) with pure ethylene glycol (EG) and a DES composed of choline chloride (ChCl) and ethylene glycol (EG) in a molar ratio of 1:3 (ChCl:EG=1:3). Vapor-liquid equilibrium (VLE), and saturated liquid density and viscosity measurements were conducted at temperatures from 298.15 to 348.15 K and pressures up to 5 MPa using a custom Phase Equilibrium and Thermophysical Properties Apparatus (PETPA). VLE data demonstrate that, in a mole fraction basis, HFC-32 has higher solubility in ChCl:EG (1:3) DES than HFC-125 and HFC-134a at a given temperature and pressure, resulting in high selectivity values required for the effective separation of HFC blends. Diffusion coefficients calculated from gravimetric absorption experiments indicate faster diffusion of HFC‑32 relative to HFC‑125 and HFC‑134a in ChCl:EG (1:3) DES at 298.15 K and similar compositions. The experimental VLE data were well correlated with the PCP-SAFT equation of state for all HFC/EG and HFC/DES systems.
- 27 March 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 14 (14) , 6634-6648
Compressed CO 2 -Assisted Catalytic Hydrocracking of Polyethylene over Ru-Loaded Zeolites
- 27 March 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 14 (14) , 6634-6648
Compressed CO 2 -Assisted Catalytic Hydrocracking of Polyethylene over Ru-Loaded Zeolites
- 3 July 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
Experimental Measurements and Molecular Dynamics Simulations of Self-Diffusivity in Mixtures of [C2C1im][Tf2N] with Difluoromethane and Pentafluoroethane
Thermophysical properties of hydrofluorocarbon (HFC) gas and ionic liquid (IL) mixtures have previously been shown to exhibit large deviations from ideal solution behavior. Understanding self-diffusivity can help elucidate the contributing dynamic and structural properties. 1H and 19F NMR pulsed-field gradient stimulated echo techniques were utilized to measure the self-diffusion coefficients of the ions of 1-ethyl-3-methyl-imidazolium bis(trifluoromethylsulfonyl)amide ([C2C1im][Tf2N]) with either difluoromethane (HFC-32) or pentafluoroethane (HFC-125) at saturation with temperatures from 25 to 75 °C and pressures to 62 bar. Molecular dynamics (MD) simulations were performed for mixtures of difluoromethane in [C2C1im][Tf2N] across a wide range of HFC compositions. MD simulations demonstrated good qualitative agreement with experiments, with better quantitative agreement at high HFC compositions. MD predicted diffusivities were generally lower and viscosities higher than experimental values, probably due to polarizability effects. Experiments and simulations illustrate that the HFC diffusivity is the highest of all mixture constituents at all investigated conditions and the cation diffuses faster than the anion. A sharp increase in the liquid self-diffusivity of all constituents was observed at HFC compositions above 80% moleHFC in the difluoromethane/IL system. From previous viscosity measurements and MD simulations, the anion generally follows Stokes-Einstein behavior while the cation and HFC exhibit increased deviations.
- 3 July 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
Experimental Measurements and Molecular Dynamics Simulations of Self-Diffusivity in Mixtures of [C2C1im][Tf2N] with Difluoromethane and Pentafluoroethane
Thermophysical properties of hydrofluorocarbon (HFC) gas and ionic liquid (IL) mixtures have previously been shown to exhibit large deviations from ideal solution behavior. Understanding self-diffusivity can help elucidate the contributing dynamic and structural properties. 1H and 19F NMR pulsed-field gradient stimulated echo techniques were utilized to measure the self-diffusion coefficients of the ions of 1-ethyl-3-methyl-imidazolium bis(trifluoromethylsulfonyl)amide ([C2C1im][Tf2N]) with either difluoromethane (HFC-32) or pentafluoroethane (HFC-125) at saturation with temperatures from 25 to 75 °C and pressures to 62 bar. Molecular dynamics (MD) simulations were performed for mixtures of difluoromethane in [C2C1im][Tf2N] across a wide range of HFC compositions. MD simulations demonstrated good qualitative agreement with experiments, with better quantitative agreement at high HFC compositions. MD predicted diffusivities were generally lower and viscosities higher than experimental values, probably due to polarizability effects. Experiments and simulations illustrate that the HFC diffusivity is the highest of all mixture constituents at all investigated conditions and the cation diffuses faster than the anion. A sharp increase in the liquid self-diffusivity of all constituents was observed at HFC compositions above 80% moleHFC in the difluoromethane/IL system. From previous viscosity measurements and MD simulations, the anion generally follows Stokes-Einstein behavior while the cation and HFC exhibit increased deviations.
- 10 June 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 64 (24) , 11615-11623
2024 in Retrospective: Trends in Chemical Engineering
- 10 June 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 64 (24) , 11615-11623
2024 in Retrospective: Trends in Chemical Engineering
- Open Access
- 14 March 2025
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 595
Multi-objective optimization of PC-SAFT parameters for ionic liquids from density and viscosity data using entropy scaling
- 14 March 2025
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 595
Open AccessMulti-objective optimization of PC-SAFT parameters for ionic liquids from density and viscosity data using entropy scaling
- 2 December 2024
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 12 (50) , 17977-17981
Carbon Dioxide-Induced Separations of Terephthalic Acid from Aqueous Disodium Terephthalate Solutions for Polyester Upcycling
- 2 December 2024
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 12 (50) , 17977-17981
Carbon Dioxide-Induced Separations of Terephthalic Acid from Aqueous Disodium Terephthalate Solutions for Polyester Upcycling
- 27 September 2024
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
2023 in Retrospective: Trends in Chemical Engineering
- 27 September 2024
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
2023 in Retrospective: Trends in Chemical Engineering