Alak Majumder
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Alak Majumder has a total of 73 co-authors. Here are the top co-authors by number of shared publications:
- Suraj Kumar Saw
National Institute of Technology
8 shared publications Madhusudan Maiti
Department of ECE, Integrated Circuit & System Lab, National Institute of Technology Arunachal Pradesh, Yupia, India
7 shared publications- Pritam Bhattacharjee
Amrita Vishwa Vidyapeetham
7 shared publications - Sanjeev Kumar Metya
National Institute of Technology Arunachal Pradesh
5 shared publications - Bidyut Kumar Bhattacharyya
Electronics and Communication Engineering Department, National Institute of Technology, Agartala, India
4 shared publications - Shashank Awasthi
Department of Electronics and Communication Engineering, Alliance School of Applied Engineering, Alliance University, Bengaluru, India
4 shared publications
Latest Publications
- 27 May 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. PP (15) , 1
Compact ASIC Design of a Secure Hexadecimal Digital Lock for Consumer Electronics
This paper presents HexLock, a compact and energy-efficient ASIC-based digital locking system that employs a 4-bit hexadecimal key architecture for secure hardware-level access control in embedded and consumer electronic applications. Unlike traditional microcontroller-based locks, it eliminates firmware dependencies and operates using fully synchronous, power gated digital logic, significantly reducing power and area overhead. The system accepts parallel 16-bit binary key input or 4-bit sequential hexadecimal key inputs, and verifies them through a pipelined XOR-OR logic against a configurable stored code, enforcing tamper resistance via an on-chip false attempt counter and early mismatch termination logic. Designed and verified on SCL 180nm CMOS node, HexLock records a core layout area of 0.35mm2 and post-layout delay of 4.5 ns along with dormant and active power consumption of 4.76 μW and 0.15 mW respectively under typical operating conditions. Functional validation across full PVT corners (-20°C to 120°C) confirms reliable operation up to 85 MHz. As summarized in Table IV, HexLock achieves substantially lower active power and a smaller silicon footprint compared to standard MCU and FPGA based locking alternatives, thereby eliminating firmware dependencies through hardware-only authentication. These properties make HexLock a practical candidate for integration in smart locks, IoT platforms, and safety-critical consumer systems.
- 27 May 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. PP (15) , 1
Compact ASIC Design of a Secure Hexadecimal Digital Lock for Consumer Electronics
This paper presents HexLock, a compact and energy-efficient ASIC-based digital locking system that employs a 4-bit hexadecimal key architecture for secure hardware-level access control in embedded and consumer electronic applications. Unlike traditional microcontroller-based locks, it eliminates firmware dependencies and operates using fully synchronous, power gated digital logic, significantly reducing power and area overhead. The system accepts parallel 16-bit binary key input or 4-bit sequential hexadecimal key inputs, and verifies them through a pipelined XOR-OR logic against a configurable stored code, enforcing tamper resistance via an on-chip false attempt counter and early mismatch termination logic. Designed and verified on SCL 180nm CMOS node, HexLock records a core layout area of 0.35mm2 and post-layout delay of 4.5 ns along with dormant and active power consumption of 4.76 μW and 0.15 mW respectively under typical operating conditions. Functional validation across full PVT corners (-20°C to 120°C) confirms reliable operation up to 85 MHz. As summarized in Table IV, HexLock achieves substantially lower active power and a smaller silicon footprint compared to standard MCU and FPGA based locking alternatives, thereby eliminating firmware dependencies through hardware-only authentication. These properties make HexLock a practical candidate for integration in smart locks, IoT platforms, and safety-critical consumer systems.
- Open Access
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of the Communications Society
- Vol. 7, 10385-10403
FPGA-Deployed Lightweight Adaptive Hybrid DPD Implementation for PA Linearization in LEO STIN
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of the Communications Society
- Vol. 7, 10385-10403
Open AccessFPGA-Deployed Lightweight Adaptive Hybrid DPD Implementation for PA Linearization in LEO STIN
- 27 December 2025
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 126 (2) , 27
The art of variable frequency clock generation: evolution and implications
- 27 December 2025
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 126 (2) , 27
The art of variable frequency clock generation: evolution and implications
- Open Access
- 21 December 2025
- Published by Springer Nature in Circuits, Systems, and Signal Processing
- Vol. 45 (1) , 1-8
Guest Editorial: Low Power Computing: Devices, Circuits & Systems for Signal Processing
- 21 December 2025
- Published by Springer Nature in Circuits, Systems, and Signal Processing
- Vol. 45 (1) , 1-8
Open AccessGuest Editorial: Low Power Computing: Devices, Circuits & Systems for Signal Processing
- 31 July 2025
- Published by Springer Nature in Circuits, Systems, and Signal Processing
- Vol. 44 (12) , 8941-8966
Multi-mode Power Gating to Reduce Current Ramp of Logic Circuit
- 31 July 2025
- Published by Springer Nature in Circuits, Systems, and Signal Processing
- Vol. 44 (12) , 8941-8966
Multi-mode Power Gating to Reduce Current Ramp of Logic Circuit
- 13 December 2024
- Published by Springer Nature in Iranian Journal of Science and Technology, Transactions of Electrical Engineering
- Vol. 49 (2) , 853-864
Ti-Diffused LiNbO$_3$ Based Reversible TR Gate: An Electro-Optic Design and Applications- 13 December 2024
- Published by Springer Nature in Iranian Journal of Science and Technology, Transactions of Electrical Engineering
- Vol. 49 (2) , 853-864
Ti-Diffused LiNbO$_3$ Based Reversible TR Gate: An Electro-Optic Design and Applications- 18 March 2024
- Published by World Scientific Pub Co Pte Ltd in Journal of Circuits, Systems and Computers
- Vol. 33 (13)
Time Domain and Area Efficient Smart Temperature Sensor Exploiting Channel Length Modulation Coefficient
This work suggests an all-digital temperature sensor with a high sampling rate that is based on a time-to-digital converter (TDC). Two on-chip voltage-controlled oscillators (VCOs) are used in the design of the sensor core, which senses temperatures between [ ]C and 200[ ]C. For digital code conversion, the outputs of the VCO are fed into two asynchronous counters. In both low- and high- resolution modes, the error following two-point calibration is observed between [ ]C and [ ]C. The sensor’s ability to function in both high- and low-resolution modes based on conversion time is an important feature. At a sampling frequency of 0.19[ ]MHz, the maximum resolution achieved is 0.18[ ]C. Additionally, the sensor has control logic built in to turn off the sensing as soon as the conversion is complete. At 90-nm process, 1.1[ ]V supply voltage and 27[ ]C, the proposed sensor occupies [ ] and consumes [ ].
- 18 March 2024
- Published by World Scientific Pub Co Pte Ltd in Journal of Circuits, Systems and Computers
- Vol. 33 (13)
Time Domain and Area Efficient Smart Temperature Sensor Exploiting Channel Length Modulation Coefficient
This work suggests an all-digital temperature sensor with a high sampling rate that is based on a time-to-digital converter (TDC). Two on-chip voltage-controlled oscillators (VCOs) are used in the design of the sensor core, which senses temperatures between [ ]C and 200[ ]C. For digital code conversion, the outputs of the VCO are fed into two asynchronous counters. In both low- and high- resolution modes, the error following two-point calibration is observed between [ ]C and [ ]C. The sensor’s ability to function in both high- and low-resolution modes based on conversion time is an important feature. At a sampling frequency of 0.19[ ]MHz, the maximum resolution achieved is 0.18[ ]C. Additionally, the sensor has control logic built in to turn off the sensing as soon as the conversion is complete. At 90-nm process, 1.1[ ]V supply voltage and 27[ ]C, the proposed sensor occupies [ ] and consumes [ ].
- 1 July 2023
- Published by Springer Nature in Silicon
- Vol. 15 (10) , 4513-4519
Configuring a Hybrid Full Adder Using Strained-Si Channel DG JLT with Work Function Modulation
- 1 July 2023
- Published by Springer Nature in Silicon
- Vol. 15 (10) , 4513-4519
Configuring a Hybrid Full Adder Using Strained-Si Channel DG JLT with Work Function Modulation