M. T. de Melo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
M. T. de Melo has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- Crislane Priscila Do Nascimento Silva
Universidade Federal de Pernambuco, Brazil
4 shared publications - Elias M. F. de Oliveira
Departamento de Eletronica e Sistemas, Universidade Federal de Pernambuco, Recife, Brazil
3 shared publications F. R. L. e Silva
Departamento de Eletronica e Sistemas - Grupo de Fotonica, Universidade Federal de Pernambuco (UFPE), Av. Academico Helio Ramos, S/N, 50740-530 Recife, Pernambuco, Brazil
2 shared publicationsFrancisco Ariaildo C. S. Lucena
Departamento de Eletrônica e Sistemas ‐ Grupo de Fotônica Universidade Federal de Pernambuco (UFPE) Pernambuco 50740‐530 Brazil
2 shared publications- Ignacio Llamas-Garro
Centre Tecnològic de Telecomunicacions de Catalunya, Spain
2 shared publications - Marcio F. A. de Souza
Universidade Federal de Pernambuco, Brazil
2 shared publications
Latest Publications
- Open Access
- 1 December 2021
- Published by FapUNIFESP (SciELO) in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
- Vol. 20 (4) , 834-854
Reconfigurable Filtenna using Varactor Diode for Wireless Applications
- 1 December 2021
- Published by FapUNIFESP (SciELO) in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
- Vol. 20 (4) , 834-854
Open AccessReconfigurable Filtenna using Varactor Diode for Wireless Applications
- Open Access
- 22 January 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 29 (3) , 186-188
Reconfigurable Frequency Discriminator Based on Fractal Delay Line
A new compact reconfigurable frequency measurement device, based on interferometry is presented in this letter. The device combines the advantages of reconfigurability and fractal geometry. The interferometer uses a Wilkinson power divider connected to two microstrip delay lines; one of these corresponds to the second iteration of the Hilbert fractal curve. PIN diode switches are properly placed in the fractal delay line to achieve a 3-bit circuit, which operates in the 2.7-4.5-GHz range. The design and simulations presented are done using a full-wave electromagnetic simulator, and the frequency responses of the circuit are then shown and compared to measured results.
- 22 January 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 29 (3) , 186-188
Open AccessReconfigurable Frequency Discriminator Based on Fractal Delay Line
A new compact reconfigurable frequency measurement device, based on interferometry is presented in this letter. The device combines the advantages of reconfigurability and fractal geometry. The interferometer uses a Wilkinson power divider connected to two microstrip delay lines; one of these corresponds to the second iteration of the Hilbert fractal curve. PIN diode switches are properly placed in the fractal delay line to achieve a 3-bit circuit, which operates in the 2.7-4.5-GHz range. The design and simulations presented are done using a full-wave electromagnetic simulator, and the frequency responses of the circuit are then shown and compared to measured results.
- 1 January 2019
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 61 (1) , 68-72
Four-bit instantaneous frequency measurement systems based on frequency selective surfaces
- 1 January 2019
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 61 (1) , 68-72
Four-bit instantaneous frequency measurement systems based on frequency selective surfaces
- 11 August 2018
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 60 (9) , 2103-2107
Controlled high‐gain of an UWB antenna using cross dipole RFSS based on PIN diode
This work presents an ultra‐wideband antenna with controlled gain. The gain control of antenna is achieved by employing a Reconfigurable Frequency Selective Surface (RFSS) as superstrate which is formed by 4 × 4 array of cross dipole. The filtering characteristics of the FSS are variable and depend on the PIN diodes state. The RFSS behaves as an array of cross dipole elements with stop‐band response when all diodes are in the OFF‐state and as an array of square slots with pass‐band response when the diodes are in the ON‐state. The gain improvement depends on the PIN diodes biasing. Simulation and measurements of return loss and antenna gain are presented, demonstrating changes and improvement in the antenna gain.
- 11 August 2018
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 60 (9) , 2103-2107
Controlled high‐gain of an UWB antenna using cross dipole RFSS based on PIN diode
This work presents an ultra‐wideband antenna with controlled gain. The gain control of antenna is achieved by employing a Reconfigurable Frequency Selective Surface (RFSS) as superstrate which is formed by 4 × 4 array of cross dipole. The filtering characteristics of the FSS are variable and depend on the PIN diodes state. The RFSS behaves as an array of cross dipole elements with stop‐band response when all diodes are in the OFF‐state and as an array of square slots with pass‐band response when the diodes are in the ON‐state. The gain improvement depends on the PIN diodes biasing. Simulation and measurements of return loss and antenna gain are presented, demonstrating changes and improvement in the antenna gain.
- 1 August 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Controlled directivity and gain of antenna using square loop RFSS based on PIN diode
This paper presents a microstrip antenna with controlled gain and directivity. The gain control of antenna is achieved by employing a Reconfigurable Frequency Selective Surface (RFSS) as superstrate which is formed by 2 × 2 array of square loops. The RFSS resonance is variable and depends on the PIN diodes biasing. When all diodes are in the ON-state, the RFSS resonates at 1.89 GHz, and at 3.00 GHz when the diodes are in the OFF-state. The RFSS resonance influences the antenna behavior which operates at 2.40 GHz. Analyses of the simulated antenna gain, radiation pattern and return loss are shown. The gain improvement depends on the PIN diodes biasing. The improvement is 2.95 dB and reduction is 6.95 dB at 2.40 GHz for reverse and forward bias, respectively. At reverse bias, the main lobe is in the opposite direction comparing to the forward bias.
- 1 August 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Controlled directivity and gain of antenna using square loop RFSS based on PIN diode
This paper presents a microstrip antenna with controlled gain and directivity. The gain control of antenna is achieved by employing a Reconfigurable Frequency Selective Surface (RFSS) as superstrate which is formed by 2 × 2 array of square loops. The RFSS resonance is variable and depends on the PIN diodes biasing. When all diodes are in the ON-state, the RFSS resonates at 1.89 GHz, and at 3.00 GHz when the diodes are in the OFF-state. The RFSS resonance influences the antenna behavior which operates at 2.40 GHz. Analyses of the simulated antenna gain, radiation pattern and return loss are shown. The gain improvement depends on the PIN diodes biasing. The improvement is 2.95 dB and reduction is 6.95 dB at 2.40 GHz for reverse and forward bias, respectively. At reverse bias, the main lobe is in the opposite direction comparing to the forward bias.
- Open Access
- 27 June 2017
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 59 (9) , 2122-2126
RFSS based on cross dipole or grid using PIN diode
- 27 June 2017
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 59 (9) , 2122-2126
Open AccessRFSS based on cross dipole or grid using PIN diode
- 27 March 2017
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 59 (5) , 1153-1157
Compact fractal interferometers for a 4‐bit IFM system
Instantaneous frequency measurement (IFM) systems have been developed during the last decades, and new designs came across trying to keep the system as compact as possible. In this paper, the authors present compact interferometers based on Hilbert fractal geometry for a 4‐bit IFM system. The interferometers operate in the range 4.66–6.38 GHz, using a Wilkinson power divider connected to two microstrip lines, which one of these is the Hilbert fractal curve. The design and simulations to be presented were done in a full wave EM simulator. Measured and simulating results are presented and compared. © 2017 Wiley Periodicals, Inc. Microwave Opt Technol Lett 59:1153–1157, 2017
- 27 March 2017
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 59 (5) , 1153-1157
Compact fractal interferometers for a 4‐bit IFM system
Instantaneous frequency measurement (IFM) systems have been developed during the last decades, and new designs came across trying to keep the system as compact as possible. In this paper, the authors present compact interferometers based on Hilbert fractal geometry for a 4‐bit IFM system. The interferometers operate in the range 4.66–6.38 GHz, using a Wilkinson power divider connected to two microstrip lines, which one of these is the Hilbert fractal curve. The design and simulations to be presented were done in a full wave EM simulator. Measured and simulating results are presented and compared. © 2017 Wiley Periodicals, Inc. Microwave Opt Technol Lett 59:1153–1157, 2017
- 1 October 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 36-39
A Novel LSB Discriminator for a 5 bit IFM Subsystem Based on Microstrip Band-Stop Filter
The authors have studied a new way to design IFM (Instantaneous Frequency Measurement) subsystem. The method is based on band-stop filters. The IFM uses rectangular open loop resonators instead of delay lines. The resonance frequency is adjusted by resonator perimeter, that must be half guided wavelength, and also by coupling distance between the resonators and the main transmission line. A LSB (least significant bit) discriminator of an IFM subsystem with resolution of 62.5 MHz is designed. The device has been fabricated on RT6010.2 substrate of thickness h=1.27 mm. A full wave EM simulator is used to obtain the frequency response.
- 1 October 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 36-39
A Novel LSB Discriminator for a 5 bit IFM Subsystem Based on Microstrip Band-Stop Filter
The authors have studied a new way to design IFM (Instantaneous Frequency Measurement) subsystem. The method is based on band-stop filters. The IFM uses rectangular open loop resonators instead of delay lines. The resonance frequency is adjusted by resonator perimeter, that must be half guided wavelength, and also by coupling distance between the resonators and the main transmission line. A LSB (least significant bit) discriminator of an IFM subsystem with resolution of 62.5 MHz is designed. The device has been fabricated on RT6010.2 substrate of thickness h=1.27 mm. A full wave EM simulator is used to obtain the frequency response.
- 18 June 2008
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 50 (9) , 2422-2426
GSM open‐loop duplexer filter with internal stubs
- 18 June 2008
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 50 (9) , 2422-2426
GSM open‐loop duplexer filter with internal stubs
- 20 February 2008
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 50 (4) , 877-879
Coplanar antenna array design with stubs over dipoles for RFID applications
A new Coplanar Strip Antenna design is presented. This antenna is suitable for RFID tags, operating in the 2.4‐GHz range. Device was fabricated on RT6002 substrate of thicknessh= 1.5 mm. The input impedance control is based on the conformal mapping technique. A full‐wave EM simulator was used to obtain the frequency response. Simulated and experimental results are presented. © 2008 Wiley Periodicals, Inc. Microwave Opt Technol Lett 50: 877–879, 2008; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.23238
- 20 February 2008
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 50 (4) , 877-879
Coplanar antenna array design with stubs over dipoles for RFID applications
A new Coplanar Strip Antenna design is presented. This antenna is suitable for RFID tags, operating in the 2.4‐GHz range. Device was fabricated on RT6002 substrate of thicknessh= 1.5 mm. The input impedance control is based on the conformal mapping technique. A full‐wave EM simulator was used to obtain the frequency response. Simulated and experimental results are presented. © 2008 Wiley Periodicals, Inc. Microwave Opt Technol Lett 50: 877–879, 2008; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.23238