Yong Cheol Hong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yong Cheol Hong has a total of 86 co-authors. Here are the top co-authors by number of shared publications:
- Han Sup Uhm
Kwangwoon University
6 shared publications - Geon Woo Yang
Institute of Plasma Technology, 37 Dongjansan-ro, Gunsan 54004, Republic of Korea
5 shared publications Heejae Lee
Institute of Plasma Technology Research, Korea Institute of Fusion Energy, Gunsan, South Korea
5 shared publicationsKangil Kim
Institute of Plasma Technology Research, Korea Institute of Fusion Energy, Gunsan, South Korea
5 shared publications- Dong Hun Shin
Plasma Technology Research Center, National Fusion Research Institute, 37 Dongjansan-ro, Gunsan, Jeollabuk-do 54004, Korea
4 shared publications - Se Min Chun
Plasma Technology Research Center, National Fusion Research Institute, 37 Dongjansan-ro, Gunsan, Jeollabuk-do 54004, Korea
4 shared publications
Latest Publications
- 6 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 54 (3) , 1275-1278
Underwater Non-Thermal Plasma System for the Decolorization of Dyeing Wastewater
Plasma-based wastewater treatment has recently attracted considerable attention as a promising alternative for the decolorization of dye-containing wastewater. However, most previous studies have been limited to laboratory-scale experiments, and large-scale applications remain insufficiently explored. In this study, a submerged dielectric barrier discharge (DBD) plasma reactor with a porous ceramic tube was employed to decolorize real textile wastewater. The reactor generated reactive oxygen species (ROS), with ozone dissolving into water and acting as the dominant oxidizing species responsible for decolorization. An optimized underwater plasma module was designed to enhance the reaction rate and minimize energy consumption, enabling stable large-scale operation. The full system required 5.76 kW to process 3.5 ton/h of wastewater. Under these conditions, the color decreased from 153 to 23 Pt-Co units after 40 min of treatment, corresponding to a 70% reduction. To the best of our knowledge, this work provides the first demonstration oflarge-scale decolorization of real textile wastewater using an underwater plasma system, highlighting both its novelty and industrial applicability.
- 6 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 54 (3) , 1275-1278
Underwater Non-Thermal Plasma System for the Decolorization of Dyeing Wastewater
Plasma-based wastewater treatment has recently attracted considerable attention as a promising alternative for the decolorization of dye-containing wastewater. However, most previous studies have been limited to laboratory-scale experiments, and large-scale applications remain insufficiently explored. In this study, a submerged dielectric barrier discharge (DBD) plasma reactor with a porous ceramic tube was employed to decolorize real textile wastewater. The reactor generated reactive oxygen species (ROS), with ozone dissolving into water and acting as the dominant oxidizing species responsible for decolorization. An optimized underwater plasma module was designed to enhance the reaction rate and minimize energy consumption, enabling stable large-scale operation. The full system required 5.76 kW to process 3.5 ton/h of wastewater. Under these conditions, the color decreased from 153 to 23 Pt-Co units after 40 min of treatment, corresponding to a 70% reduction. To the best of our knowledge, this work provides the first demonstration oflarge-scale decolorization of real textile wastewater using an underwater plasma system, highlighting both its novelty and industrial applicability.
- Open Access
- 29 January 2026
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 41, 3465-3480
Enhanced flowability of fine cohesive Y2O3 powders in an enlarged atmospheric-pressure microwave plasma
- 29 January 2026
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 41, 3465-3480
Open AccessEnhanced flowability of fine cohesive Y2O3 powders in an enlarged atmospheric-pressure microwave plasma
- 25 September 2025
- Published by Elsevier in Journal of Electrostatics
- Vol. 138
Rapid degradation of methylene blue using a dielectric barrier discharge plasma reactor with a water circulation system
- 25 September 2025
- Published by Elsevier in Journal of Electrostatics
- Vol. 138
Rapid degradation of methylene blue using a dielectric barrier discharge plasma reactor with a water circulation system
- Open Access
Methylene Blue Degradation Using Non-Thermal Plasma
Methylene blue (C16H18ClN3) dye can be decomposed using non-thermal plasma. However, there is a problem in that the maintenance of electrodes and dielectrics is necessary due to the durability and heat generation problems due to the high temperatures. Therefore, in this study, a comparative experiment was performed between the flat DBD plasma module and the diffuser DBD module under the same conditions. For methylene blue decomposition, the characteristic changes in the air flow rate, ozone production rate, energy consumption rate, and decomposition rate were compared. In the experiment, 7 L water was placed in a 15 L reactor, and measurements were performed for approximately 1 h. We performed the same process by setting the initial methylene blue concentration to 143 mg/L. According to the results, the flat DBD module achieved a decomposition rate of 100% in 40 min, an energy yield of 46.7 g/kWh, and an ozone generation amount of 6.5 g/h. The diffuser DBD module achieved a decomposition rate of 90%, an energy production of 24.6 g/kWh, and an ozone generation of 1.97 g/h in 60 min.
Open AccessMethylene Blue Degradation Using Non-Thermal Plasma
Methylene blue (C16H18ClN3) dye can be decomposed using non-thermal plasma. However, there is a problem in that the maintenance of electrodes and dielectrics is necessary due to the durability and heat generation problems due to the high temperatures. Therefore, in this study, a comparative experiment was performed between the flat DBD plasma module and the diffuser DBD module under the same conditions. For methylene blue decomposition, the characteristic changes in the air flow rate, ozone production rate, energy consumption rate, and decomposition rate were compared. In the experiment, 7 L water was placed in a 15 L reactor, and measurements were performed for approximately 1 h. We performed the same process by setting the initial methylene blue concentration to 143 mg/L. According to the results, the flat DBD module achieved a decomposition rate of 100% in 40 min, an energy yield of 46.7 g/kWh, and an ozone generation amount of 6.5 g/h. The diffuser DBD module achieved a decomposition rate of 90%, an energy production of 24.6 g/kWh, and an ozone generation of 1.97 g/h in 60 min.
- 10 August 2024
- Published by Elsevier in Chemosphere
- Vol. 363, 143037
Corrigendum to ‘Degradation of dissolved sulfide in water using multi-hole dielectric barrier discharge’ [Chemosphere 354 (2024) 141687 1–10]
- 10 August 2024
- Published by Elsevier in Chemosphere
- Vol. 363, 143037
Corrigendum to ‘Degradation of dissolved sulfide in water using multi-hole dielectric barrier discharge’ [Chemosphere 354 (2024) 141687 1–10]
- 12 March 2024
- Published by Elsevier in Chemosphere
- Vol. 354, 141687
Degradation of dissolved sulfide in water using multi-hole dielectric barrier discharge
- 12 March 2024
- Published by Elsevier in Chemosphere
- Vol. 354, 141687
Degradation of dissolved sulfide in water using multi-hole dielectric barrier discharge
- Open Access
- 14 November 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (22) , 12302
Sterilization of Water-Based Cutting Fluids Using Compact Air-Cooled Coaxial Dielectric Barrier Discharge Reactor with Bubbler
Odor and discoloration in water-based cutting fluids are caused by the growth of microorganisms and putrefying bacteria. This significantly reduces cutting performance, prevents rust, and deteriorates the working environment. To overcome these drawbacks, we developed a compact air-cooled coaxial dielectric barrier discharge (DBD) with a bubbler. Bacteria and microorganisms living in waste cutting fluids were sterilized by the high concentration of ozone produced under the optimized conditions of the compact air-cooled coaxial DBD. Moreover, it was confirmed that 99.99% of bacteria and microorganisms were completely removed. Ozone was found to not affect property changes such as the composition, concentration, and pH of the water-based cutting fluids. The chromaticity and complex odor of waste cutting liquids were thus found to have been improved by the effects of microorganism and bacterial sterilization. We conclude that the proposed a compact air-cooled coaxial DBD with a bubbler is an efficient method for sterilizing water-based cutting fluids.
- 14 November 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (22) , 12302
Open AccessSterilization of Water-Based Cutting Fluids Using Compact Air-Cooled Coaxial Dielectric Barrier Discharge Reactor with Bubbler
Odor and discoloration in water-based cutting fluids are caused by the growth of microorganisms and putrefying bacteria. This significantly reduces cutting performance, prevents rust, and deteriorates the working environment. To overcome these drawbacks, we developed a compact air-cooled coaxial dielectric barrier discharge (DBD) with a bubbler. Bacteria and microorganisms living in waste cutting fluids were sterilized by the high concentration of ozone produced under the optimized conditions of the compact air-cooled coaxial DBD. Moreover, it was confirmed that 99.99% of bacteria and microorganisms were completely removed. Ozone was found to not affect property changes such as the composition, concentration, and pH of the water-based cutting fluids. The chromaticity and complex odor of waste cutting liquids were thus found to have been improved by the effects of microorganism and bacterial sterilization. We conclude that the proposed a compact air-cooled coaxial DBD with a bubbler is an efficient method for sterilizing water-based cutting fluids.
- Open Access
Erratum: Hong, Y.-C. Atmospheric-Pressure Air Plasma Jet and Its Striation Discharge Mode for Treatment of Thermally Sensitive Materials. Coatings 2021, 11, 866
There is an error in the Acknowledgements statement
Open AccessErratum: Hong, Y.-C. Atmospheric-Pressure Air Plasma Jet and Its Striation Discharge Mode for Treatment of Thermally Sensitive Materials. Coatings 2021, 11, 866
There is an error in the Acknowledgements statement
- 1 October 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 49 (10) , 3268-3271
Degradation of Rhodamine B and Methylene Blue by Underwater Dielectric Barrier Discharge
Numerous reports have elucidated different methods for treating dyeing wastewater using UV irradiation, ozonation, and chlorination. However, the high operational costs of these methods have necessitated the use of plasma. In this study, dielectric barrier discharge (DBD) was used to purify dyeing wastewater, generating ozone as a byproduct. An underwater DBD plasma system was designed to directly interact with water, thereby producing reactive oxygen species (ROS) and functioning as a powerful oxidizer. Additionally, UV, O 3 , and H 2 O 2 are generated by the developed plasma system without using any other additives to produce OH radicals for purifying organic pollutants; therefore, this system circumvents the use of complex and advanced oxidation processes. A simulation test was performed, which revealed that methylene blue and rhodamine B were completely removed within 7 and 3 min, respectively. Therefore, the developed plasma system can be successfully applied for the purification of dyeing wastewater.
- 1 October 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 49 (10) , 3268-3271
Degradation of Rhodamine B and Methylene Blue by Underwater Dielectric Barrier Discharge
Numerous reports have elucidated different methods for treating dyeing wastewater using UV irradiation, ozonation, and chlorination. However, the high operational costs of these methods have necessitated the use of plasma. In this study, dielectric barrier discharge (DBD) was used to purify dyeing wastewater, generating ozone as a byproduct. An underwater DBD plasma system was designed to directly interact with water, thereby producing reactive oxygen species (ROS) and functioning as a powerful oxidizer. Additionally, UV, O 3 , and H 2 O 2 are generated by the developed plasma system without using any other additives to produce OH radicals for purifying organic pollutants; therefore, this system circumvents the use of complex and advanced oxidation processes. A simulation test was performed, which revealed that methylene blue and rhodamine B were completely removed within 7 and 3 min, respectively. Therefore, the developed plasma system can be successfully applied for the purification of dyeing wastewater.