LawrenceH. Bennett
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
LawrenceH. Bennett has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Amir Aslani
Department of Electrical and Computer Engineering, George Washington University, Washington DC 20052, USA
4 shared publications - Edward Della Torre
Department of Electrical and Computer Engineering, The George Washington University, Washington, DC 20052, USA
4 shared publications - Mohammadreza Ghahremani
Department of Computer Science, Mathematics and Engineering, Shepherd University, Shepherdstown, WV 25443, USA
3 shared publications H. C. Torrey
2 shared publicationsMarjan Hosseinnia
Department of Clinical and Administrative Sciences, Notre Dame of Maryland University 3 , Baltimore, Maryland 21210, USA
2 shared publicationsA. Jamali
The George Washington University 1 Electrical and Computer Engineering Department Washington, DC 20052, USA
1 shared publication
Latest Publications
- Open Access
- 1 January 2020
- Published by AIP Publishing in AIP Advances
- Vol. 10 (1) , 015227
Hysteresis loss reduction and magnetocaloric effect improvement in the Ni-Co-Mn-In alloys
In this work the magnetocaloric effect (MCE) and hysteresis losses of Ni45Co5Mn(37-x)In(13+x) alloy (x= 0, 0.4) are studied. Also we propose a new approach in calculating the average entropy change to eliminate the overestimation of the magnetic entropy change calculation using Maxwell’s relations which is commonly seen in the indirect MCE calculation in the literature. The attributes of magnetostructural coupling have an important role in the magnetic behavior of these magnetofunctional alloys. This work exhibits that a strong magnetostructural coupling can be achieved over a wide temperature range in this alloy family which results in a higher MCE and relative cooling power (RCP) compared to other Ni-Mn-In based Heusler alloys. It’s shown that by increasing the applied field the peak of the entropy change curves shifts to lower temperatures. Additionally, a small variation in the stoichiometry composition broadens the magnetic entropy change curve and shifts the critical temperatures by about 36 K to around room temperature. Furthermore, due to the enhancement in ferromagnetic exchange interactions in austenite, the magnetization change accompanying the martensitic transformation is greatly improved, resulting in a large magnetic entropy change of 31 Jkg-1K-1 under 5T field. The broadened and higher peak of the entropy change curves produced a significantly high relative cooling power in Ni45Co5Mn36.6In13.4 (488 JKg-1) and Ni45Co5Mn37In13 (317 JKg-1) under 5T field. These results are especially promising in finding low-cost, high-performance magnetocaloric material for magnetic refrigeration systems.
- 1 January 2020
- Published by AIP Publishing in AIP Advances
- Vol. 10 (1) , 015227
Open AccessHysteresis loss reduction and magnetocaloric effect improvement in the Ni-Co-Mn-In alloys
In this work the magnetocaloric effect (MCE) and hysteresis losses of Ni45Co5Mn(37-x)In(13+x) alloy (x= 0, 0.4) are studied. Also we propose a new approach in calculating the average entropy change to eliminate the overestimation of the magnetic entropy change calculation using Maxwell’s relations which is commonly seen in the indirect MCE calculation in the literature. The attributes of magnetostructural coupling have an important role in the magnetic behavior of these magnetofunctional alloys. This work exhibits that a strong magnetostructural coupling can be achieved over a wide temperature range in this alloy family which results in a higher MCE and relative cooling power (RCP) compared to other Ni-Mn-In based Heusler alloys. It’s shown that by increasing the applied field the peak of the entropy change curves shifts to lower temperatures. Additionally, a small variation in the stoichiometry composition broadens the magnetic entropy change curve and shifts the critical temperatures by about 36 K to around room temperature. Furthermore, due to the enhancement in ferromagnetic exchange interactions in austenite, the magnetization change accompanying the martensitic transformation is greatly improved, resulting in a large magnetic entropy change of 31 Jkg-1K-1 under 5T field. The broadened and higher peak of the entropy change curves produced a significantly high relative cooling power in Ni45Co5Mn36.6In13.4 (488 JKg-1) and Ni45Co5Mn37In13 (317 JKg-1) under 5T field. These results are especially promising in finding low-cost, high-performance magnetocaloric material for magnetic refrigeration systems.
- Open Access
- 4 January 2018
- Published by AIP Publishing in AIP Advances
- Vol. 8 (5)
Direct and indirect measurement of the magnetocaloric effect in bulk and nanostructured Ni-Mn-In Heusler alloy
A systematic study of the magnetocaloric effect of a Ni51Mn33.4In15.6 Heusler alloy converted to nanoparticles via high energy ball-milling technique in the temperature range of 270 to 310 K has been performed. The properties of the particles were characterized by x-ray diffraction, electron microscopy, and magnetometer techniques. Isothermal magnetic field variation of magnetization exhibits field hysteresis in bulk Ni51Mn33.4In15.6 alloy across the martensitic transition which significantly lessened in the nanoparticles. The magnetocaloric effects of the bulk and nanoparticle samples were measured both with direct method, through our state of the art direct test bed apparatus with controllability over the applied fields and temperatures, as well as an indirect method through Maxwell and thermodynamic equations. In direct measurements, nanoparticle sample’s critical temperature decreased by 6 K, but its magnetocaloric effect enhanced by 17% over the bulk counterpart. Additionally, when comparing the direct and indirect magnetocaloric curves, the direct method showed 14% less adiabatic temperature change in the bulk and 5% less adiabatic temperature change in the nanostructured sample.
- 4 January 2018
- Published by AIP Publishing in AIP Advances
- Vol. 8 (5)
Open AccessDirect and indirect measurement of the magnetocaloric effect in bulk and nanostructured Ni-Mn-In Heusler alloy
A systematic study of the magnetocaloric effect of a Ni51Mn33.4In15.6 Heusler alloy converted to nanoparticles via high energy ball-milling technique in the temperature range of 270 to 310 K has been performed. The properties of the particles were characterized by x-ray diffraction, electron microscopy, and magnetometer techniques. Isothermal magnetic field variation of magnetization exhibits field hysteresis in bulk Ni51Mn33.4In15.6 alloy across the martensitic transition which significantly lessened in the nanoparticles. The magnetocaloric effects of the bulk and nanoparticle samples were measured both with direct method, through our state of the art direct test bed apparatus with controllability over the applied fields and temperatures, as well as an indirect method through Maxwell and thermodynamic equations. In direct measurements, nanoparticle sample’s critical temperature decreased by 6 K, but its magnetocaloric effect enhanced by 17% over the bulk counterpart. Additionally, when comparing the direct and indirect magnetocaloric curves, the direct method showed 14% less adiabatic temperature change in the bulk and 5% less adiabatic temperature change in the nanostructured sample.
- Open Access
- 3 February 2017
- Published by AIP Publishing in AIP Advances
- Vol. 7 (5)
Enhanced magnetic properties of yttrium-iron nanoparticles
A systematic study of the size effect on the magnetic and structural properties of Y2Fe17 nanoparticles has been performed. We present new data to explain the enhanced magnetic properties of nanostructured yttrium-iron alloy synthesized through alkalide reduction chemical synthesis. The properties of the particles were characterized by x-ray diffraction, electron microscopy, and magnetometer techniques. As the size of the nanoparticles is reduced, there is an increase in magnetization per unit of applied magnetic field, a decrease in the coercivity and a substantial reduction in hysteresis.
- 3 February 2017
- Published by AIP Publishing in AIP Advances
- Vol. 7 (5)
Open AccessEnhanced magnetic properties of yttrium-iron nanoparticles
A systematic study of the size effect on the magnetic and structural properties of Y2Fe17 nanoparticles has been performed. We present new data to explain the enhanced magnetic properties of nanostructured yttrium-iron alloy synthesized through alkalide reduction chemical synthesis. The properties of the particles were characterized by x-ray diffraction, electron microscopy, and magnetometer techniques. As the size of the nanoparticles is reduced, there is an increase in magnetization per unit of applied magnetic field, a decrease in the coercivity and a substantial reduction in hysteresis.
- Open Access
- 1 July 2016
- Published by AIP Publishing in AIP Advances
- Vol. 6 (7) , 075221
Tuning the heat transfer medium and operating conditions in magnetic refrigeration
A new experimental test bed has been designed, built, and tested to evaluate the effect of the system’s parameters on a reciprocating Active Magnetic Regenerator (AMR) near room temperature. Bulk gadolinium was used as the refrigerant, silicon oil as the heat transfer medium, and a magnetic field of 1.3 T was cycled. This study focuses on the methodology of single stage AMR operation conditions to get a high temperature span near room temperature. Herein, the main objective is not to report the absolute maximum attainable temperature span seen in an AMR system, but rather to find the system’s optimal operating conditions to reach that maximum span. The results of this research show that there is a optimal operating frequency, heat transfer fluid flow rate, flow duration, and displaced volume ratio in any AMR system. By optimizing these parameters in our AMR apparatus the temperature span between the hot and cold ends increased by 24%. The optimized values are system dependent and need to be determined and measured for any AMR system by following the procedures that are introduced in this research. It is expected that such optimization will permit the design of a more efficient magnetic refrigeration system.
- 1 July 2016
- Published by AIP Publishing in AIP Advances
- Vol. 6 (7) , 075221
Open AccessTuning the heat transfer medium and operating conditions in magnetic refrigeration
A new experimental test bed has been designed, built, and tested to evaluate the effect of the system’s parameters on a reciprocating Active Magnetic Regenerator (AMR) near room temperature. Bulk gadolinium was used as the refrigerant, silicon oil as the heat transfer medium, and a magnetic field of 1.3 T was cycled. This study focuses on the methodology of single stage AMR operation conditions to get a high temperature span near room temperature. Herein, the main objective is not to report the absolute maximum attainable temperature span seen in an AMR system, but rather to find the system’s optimal operating conditions to reach that maximum span. The results of this research show that there is a optimal operating frequency, heat transfer fluid flow rate, flow duration, and displaced volume ratio in any AMR system. By optimizing these parameters in our AMR apparatus the temperature span between the hot and cold ends increased by 24%. The optimized values are system dependent and need to be determined and measured for any AMR system by following the procedures that are introduced in this research. It is expected that such optimization will permit the design of a more efficient magnetic refrigeration system.
- 14 April 2015
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 117 (17) , 17D141
Vector properties of magnetostriction
The vector properties of a newly developed Preisach-type magnetostriction model are discussed. The model uses a modified version of the Della Torre-Pinzaglia-Cardelli model to compute the irreversible and the reversible components of the magnetization. The magnetostriction can then be simulated by assuming that its magnitude is proportional to the magnetization and its direction is dependent on the magnetization history. The modeling approach is outlined for two types of isotropic media: native and polycrystalline. The preliminary results show excellent agreement with the rotational magnetization measurements for a sample of high-strength steel.
- 14 April 2015
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 117 (17) , 17D141
Vector properties of magnetostriction
The vector properties of a newly developed Preisach-type magnetostriction model are discussed. The model uses a modified version of the Della Torre-Pinzaglia-Cardelli model to compute the irreversible and the reversible components of the magnetization. The magnetostriction can then be simulated by assuming that its magnitude is proportional to the magnetization and its direction is dependent on the magnetization history. The modeling approach is outlined for two types of isotropic media: native and polycrystalline. The preliminary results show excellent agreement with the rotational magnetization measurements for a sample of high-strength steel.
- Open Access
- 1 June 1959
- Published by AIP Publishing in Physics Today
- Vol. 12 (6) , 58
Physics for Engineers and Scientists
- 1 June 1959
- Published by AIP Publishing in Physics Today
- Vol. 12 (6) , 58
Open AccessPhysics for Engineers and Scientists
- 15 March 1958
- Published by American Physical Society (APS) in Physical Review B
- Vol. 109 (6) , 2218
High Negative Nuclear Polarizations in a Liquid
DOI:https://doi.org/10.1103/PhysRev.109.2218.2
- 15 March 1958
- Published by American Physical Society (APS) in Physical Review B
- Vol. 109 (6) , 2218
High Negative Nuclear Polarizations in a Liquid
DOI:https://doi.org/10.1103/PhysRev.109.2218.2
- 15 October 1957
- Published by American Physical Society (APS) in Physical Review B
- Vol. 108 (2) , 499-500
High Negative Nuclear Polarizations in a Liquid
DOI:https://doi.org/10.1103/PhysRev.108.499
- 15 October 1957
- Published by American Physical Society (APS) in Physical Review B
- Vol. 108 (2) , 499-500
High Negative Nuclear Polarizations in a Liquid
DOI:https://doi.org/10.1103/PhysRev.108.499