Jia Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jia Chen has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Xiaobing Zhang
School of Energy and Power Engineering, Nanjing University of Science and Technology, Nanjing, China
4 shared publications Xiaobing Zhang
2 shared publications- Gang Li
Department of Mechanical Engineering Clemson University Clemson South Carolina USA
1 shared publication - Huijuan Zhao
Department of Mechanical Engineering, Clemson University, Clemson, SC 29634, USA
1 shared publication - Ruijie Zhu
College of Field Engineering, Army Engineering University of PLA, Nanjing, China
1 shared publication - Wei Li
School of Mechanical and Energy Engineering, Zhejiang University, Ningbo Institute of Technology, Ningbo, China
1 shared publication
Latest Publications
- 26 June 2023
- Published by ASME International in Journal of Thermal Science and Engineering Applications
- Vol. 15 (10) , 1-22
Topology Optimization Design for Heat Dissipation Performance of Semiconductor Ignition Device
The trend of miniaturization and intgration of the electronic device has put forward higher requirements on efficiency of heat radiating, which can hardly be satisfied by the traditional forced convection heat dissipation method. In this paper, the strategy of topology optimization technique is adopted to greatly improve the heat dissipation efficiency of a semiconductor ignition device. The penalization method is used to implement the topology optimization process. Three kinds of objective functions of thermal compliance, temperature variance and geometric average temperature were separately applied in the topological optimization of two typical uniform heat generation cases, and the resulted topologically optimization results were analyzed and compared. Based on the two benchmark cases, the appropriate objective function was selected to conduct structural optimization of semiconductor bridge ignition devices with the aim of making the highest temperature in the design domain the lowest possible. Additionally, a parametric study on the effect of thermal conductivity on topology optimization results was conducted, which leads to a design suggestion beneficial for heat dissipation and material selection.
- 26 June 2023
- Published by ASME International in Journal of Thermal Science and Engineering Applications
- Vol. 15 (10) , 1-22
Topology Optimization Design for Heat Dissipation Performance of Semiconductor Ignition Device
The trend of miniaturization and intgration of the electronic device has put forward higher requirements on efficiency of heat radiating, which can hardly be satisfied by the traditional forced convection heat dissipation method. In this paper, the strategy of topology optimization technique is adopted to greatly improve the heat dissipation efficiency of a semiconductor ignition device. The penalization method is used to implement the topology optimization process. Three kinds of objective functions of thermal compliance, temperature variance and geometric average temperature were separately applied in the topological optimization of two typical uniform heat generation cases, and the resulted topologically optimization results were analyzed and compared. Based on the two benchmark cases, the appropriate objective function was selected to conduct structural optimization of semiconductor bridge ignition devices with the aim of making the highest temperature in the design domain the lowest possible. Additionally, a parametric study on the effect of thermal conductivity on topology optimization results was conducted, which leads to a design suggestion beneficial for heat dissipation and material selection.
- 1 October 2021
- Published by Elsevier in Physics Letters A
- Vol. 413
Thermal resistance and thermal rectification of silicon device with triangular pores: A molecular dynamics study
- 1 October 2021
- Published by Elsevier in Physics Letters A
- Vol. 413
Thermal resistance and thermal rectification of silicon device with triangular pores: A molecular dynamics study
- 1 August 2021
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 614
Prediction of thermal conductivity and phonon spectral of silicon material with pores for semiconductor device
- 1 August 2021
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 614
Prediction of thermal conductivity and phonon spectral of silicon material with pores for semiconductor device
- 23 July 2019
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 31 (42) , 425701
Nanoscale size effect and phonon properties of silicon material through simple spectral energy density analysis based on molecular dynamics
Due to the importance of spectral analysis for the development of highly efficient semiconductor silicon devices and the complexity of current research techniques, the realization of an effective and simple method for phonon spectral analysis is imperative. Based on the molecular dynamics (MD) simulations and the phonon spectral energy density (SED) analysis (Thomas et al 2010 Phys. Rev . B 81 081411), a straightforward method is adopted to obtain the phonon dispersion for silicon films. The MD method is used to investigate the heat conduction of the three-dimensional (3D) thin silicon film with Stillinger–Weber (SW) potential. The thermal conductivity of the silicon is obtained from the non-equilibrium molecular dynamics (NEMD) simulation by using Muller–Plathe (M–P) method (Müller-Plathe 1997 J. Chem. Phys . 106 6082). For further analysis of thermal transport properties based on the phonon concept, the SED analysis technique is utilized by adopting the previously obtained atomic velocities as input. Moreover, the nanoscale size effect on the spectral analysis is considered. Domains with different sizes are studied to achieve a sufficient resolution of the dispersion relation from the phonon SED. The comparison with the results of existing approach demonstrates that the utilized method can accurately and directly obtain the phonon SED profiles along the frequency axis.
- 23 July 2019
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 31 (42) , 425701
Nanoscale size effect and phonon properties of silicon material through simple spectral energy density analysis based on molecular dynamics
Due to the importance of spectral analysis for the development of highly efficient semiconductor silicon devices and the complexity of current research techniques, the realization of an effective and simple method for phonon spectral analysis is imperative. Based on the molecular dynamics (MD) simulations and the phonon spectral energy density (SED) analysis (Thomas et al 2010 Phys. Rev . B 81 081411), a straightforward method is adopted to obtain the phonon dispersion for silicon films. The MD method is used to investigate the heat conduction of the three-dimensional (3D) thin silicon film with Stillinger–Weber (SW) potential. The thermal conductivity of the silicon is obtained from the non-equilibrium molecular dynamics (NEMD) simulation by using Muller–Plathe (M–P) method (Müller-Plathe 1997 J. Chem. Phys . 106 6082). For further analysis of thermal transport properties based on the phonon concept, the SED analysis technique is utilized by adopting the previously obtained atomic velocities as input. Moreover, the nanoscale size effect on the spectral analysis is considered. Domains with different sizes are studied to achieve a sufficient resolution of the dispersion relation from the phonon SED. The comparison with the results of existing approach demonstrates that the utilized method can accurately and directly obtain the phonon SED profiles along the frequency axis.
- 23 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 40 (6) , 854-857
Non-Fourier Effects on the Temperature Time-Dependence of a Silicon Igniter
With the trend of more transient and efficient semiconductor ignition system, the non-Fourier effect becomes a significant factor for the heat conduction analysis. Based on the Cattaneo-Vernotte model and the transient semiconductor drift diffusion equations, a coupled two-dimensional model is developed to predict the behavior of carrier transport in electrical field and heat transport in thermal field for semiconductor device. The superimposition and reflection phenomenon of heat propagation are found. The results indicate that the delay of the heat propagation has great influence not only on the temperature field, but also on the carrier mobilities which determine the carrier drift diffusion motions. Additionally, the temperature of the semiconductor device is given at different doping concentrations in the order of 1016cm-3. Ultimately, the thermoelectrical coupling mechanism is revealed with the consideration of the non-Fourier effect.
- 23 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 40 (6) , 854-857
Non-Fourier Effects on the Temperature Time-Dependence of a Silicon Igniter
With the trend of more transient and efficient semiconductor ignition system, the non-Fourier effect becomes a significant factor for the heat conduction analysis. Based on the Cattaneo-Vernotte model and the transient semiconductor drift diffusion equations, a coupled two-dimensional model is developed to predict the behavior of carrier transport in electrical field and heat transport in thermal field for semiconductor device. The superimposition and reflection phenomenon of heat propagation are found. The results indicate that the delay of the heat propagation has great influence not only on the temperature field, but also on the carrier mobilities which determine the carrier drift diffusion motions. Additionally, the temperature of the semiconductor device is given at different doping concentrations in the order of 1016cm-3. Ultimately, the thermoelectrical coupling mechanism is revealed with the consideration of the non-Fourier effect.
- 15 October 2018
- Published by Springer Nature in Journal of Materials Science
- Vol. 54 (3) , 2392-2405
Investigations of electrical and thermal properties in semiconductor device based on a thermoelectrical model
- 15 October 2018
- Published by Springer Nature in Journal of Materials Science
- Vol. 54 (3) , 2392-2405
Investigations of electrical and thermal properties in semiconductor device based on a thermoelectrical model
- 18 December 2017
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 10 (3) , 1432-1439
Heat flux induced coherent vibration of H-shaped single layer graphene structure
We report an exciting behavior of H-shaped single layer graphene structures subject to a heat flux. H-shaped graphene structures with certain particular dimensions were observed to be able to establish coherent mechanical vibrations in the out-of-plane direction directly from a steady state heat flux flowing from the centerline of the structure towards the two ends. Molecular dynamics (MD) simulation methods together with phonon spectral energy density (SED) analysis techniques were used to obtain the phonon dispersion profiles and identify the low frequency high energy phonon modes. Based on these calculations, we proposed a hypothesis that the mechanical vibration is the result of the superposition of the high energy out-of-plane acoustic (ZA mode) phonons traveling in opposite directions via scattering mechanisms. By using a theoretical model based on the superposition principle, we reproduced the vibrational mode of the graphene structure observed in the MD simulation and verified the proposed hypothesis.
- 18 December 2017
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 10 (3) , 1432-1439
Heat flux induced coherent vibration of H-shaped single layer graphene structure
We report an exciting behavior of H-shaped single layer graphene structures subject to a heat flux. H-shaped graphene structures with certain particular dimensions were observed to be able to establish coherent mechanical vibrations in the out-of-plane direction directly from a steady state heat flux flowing from the centerline of the structure towards the two ends. Molecular dynamics (MD) simulation methods together with phonon spectral energy density (SED) analysis techniques were used to obtain the phonon dispersion profiles and identify the low frequency high energy phonon modes. Based on these calculations, we proposed a hypothesis that the mechanical vibration is the result of the superposition of the high energy out-of-plane acoustic (ZA mode) phonons traveling in opposite directions via scattering mechanisms. By using a theoretical model based on the superposition principle, we reproduced the vibrational mode of the graphene structure observed in the MD simulation and verified the proposed hypothesis.