RZRuijie Zhu

Ruijie Zhu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ruijie Zhu has a total of 5 co-authors. Here are the top co-authors by number of shared publications:

  • Chenglin Liu

    College of Field Engineering, Army Engineering University of PLA, Nanjing, China

    1 shared publication
  • Feng Li

    College of Field Engineering Army Engineering University of PLA Nanjing China

    1 shared publication
  • Jia Chen

    Jiangsu Police Institute Department of Police Command and Tactics Nanjing 210031 , China ; School of Energy and Power Engineering, Nanjing University of Science and Technology, Nanjing, Jiangsu 210094, China

    1 shared publication
  • Ming Ni

    College of Field Engineering, Army Engineering University of PLA, Nanjing, China

    1 shared publication
  • Xiaobing Zhang

    School of Energy and Power Engineering, Nanjing University of Science and Technology, Nanjing, China

    1 shared publication

Latest Publications

  • Open Access

    Evaluation of flexural deformation of a lightweight fabricated GFRP emergency bridge with a novel broken-line prestressed cable system

    by Chenglin Liu, Feng Li, Ruijie Zhu, Ming Ni

    To address the urgent need for rapid traffic restoration after bridge collapse, a novel lightweight fabricated GFRP (Glass Fiber-Reinforced Polymer) emergency bridge with a broken-line prestressed cable system was developed. Full-scale four-point bending tests and initial deformation measurement tests caused by dead load and clearance effect were conducted to determine the flexural deformation of the bridge. It was demonstrated that the broken-line prestressed cable system substantially enhances the structural stiffness while maintaining the advantages of modular assembly. The experimental results revealed that SLYP (Single Lug and Yoke Plate) joints serve as critical load transfer components, and the deformation caused by the clearance effect of SLYP joints cannot be ignored. The calculation method for the equivalent flexural stiffness, distinguishing GTAL (GFRP tube and aluminum alloy deck) part and SLYP joint part, was given. The flexural deformation caused by dead load, live load, prestressing, and clearance effect, considering the axial deformation and spatial angle reduction effect of the steel wire cables, was proposed based on the flexibility method. The validated analytical model exhibited excellent agreement with experimental data. The main parameters influencing the flexural deformation, such as the equivalent flexural stiffness, clearance between the pin and pinhole, height of the segment, length of the vertical stay and turning component, and SLYP joint arrangement, were discussed in detail based on the proposed method.


  • Topology Optimization Design for Heat Dissipation Performance of Semiconductor Ignition Device

    by Jia Chen, Xiaobing Zhang, Ruijie Zhu

    The trend of miniaturization and intgration of the electronic device has put forward higher requirements on efficiency of heat radiating, which can hardly be satisfied by the traditional forced convection heat dissipation method. In this paper, the strategy of topology optimization technique is adopted to greatly improve the heat dissipation efficiency of a semiconductor ignition device. The penalization method is used to implement the topology optimization process. Three kinds of objective functions of thermal compliance, temperature variance and geometric average temperature were separately applied in the topological optimization of two typical uniform heat generation cases, and the resulted topologically optimization results were analyzed and compared. Based on the two benchmark cases, the appropriate objective function was selected to conduct structural optimization of semiconductor bridge ignition devices with the aim of making the highest temperature in the design domain the lowest possible. Additionally, a parametric study on the effect of thermal conductivity on topology optimization results was conducted, which leads to a design suggestion beneficial for heat dissipation and material selection.