Nabil El-Faramawy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Nabil El-Faramawy has a total of 197 co-authors. Here are the top co-authors by number of shared publications:
Shrouk Farouk
10 shared publicationsMohamed El-Kinawy
9 shared publications- Mohamed El-Kinawy
Ain Shams Univ, Fac Sci, Dept Phys, Cairo 11566, Egypt
8 shared publications - W. Rühm
Federal Office for Radiation Protection, Neuherberg, Germany
6 shared publications - A. Wieser
GSF-National Research Centre for Environment and Health, Institute for Radiation Protection, Neuherberg, Germany
4 shared publications Abeer Salah
Department of Basic Science, Faculty of Engineering, Heliopolis University, Cairo, Egypt
4 shared publications
Latest Publications
- 14 September 2026
- Published by Elsevier in Optical Materials
- Vol. 180
Thermoluminescence properties of Er-doped Li2B4O7 for radiation dosimetry
- 14 September 2026
- Published by Elsevier in Optical Materials
- Vol. 180
Thermoluminescence properties of Er-doped Li2B4O7 for radiation dosimetry
- 14 July 2026
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 141 (7)
Thermoluminescence properties of Egyptian clay as a promising dosimeter
- 14 July 2026
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 141 (7)
Thermoluminescence properties of Egyptian clay as a promising dosimeter
- 20 April 2026
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 141 (4)
Assessment of dosimetric characteristics of sheep tooth enamel using electron paramagnetic resonance technique
- 20 April 2026
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 141 (4)
Assessment of dosimetric characteristics of sheep tooth enamel using electron paramagnetic resonance technique
- 20 November 2025
- Published by Elsevier in Journal of Luminescence
- Vol. 289
Physicochemical and thermoluminescence characterization of biogenic hydroxyapatite–calcium oxide mixture derived from marine waste
- 20 November 2025
- Published by Elsevier in Journal of Luminescence
- Vol. 289
Physicochemical and thermoluminescence characterization of biogenic hydroxyapatite–calcium oxide mixture derived from marine waste
- 19 August 2025
- Published by Elsevier in Journal of Luminescence
- Vol. 287
Impact of dysprosium doping concentration on the thermoluminescence properties of tricalcium phosphate
- 19 August 2025
- Published by Elsevier in Journal of Luminescence
- Vol. 287
Impact of dysprosium doping concentration on the thermoluminescence properties of tricalcium phosphate
- Open Access
- 7 July 2025
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 57 (11)
Thermoluminescence and structural characterization of crystalline alkali strontium borates
- 7 July 2025
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 57 (11)
Open AccessThermoluminescence and structural characterization of crystalline alkali strontium borates
- 16 June 2025
- Published by Elsevier in Radiation Physics and Chemistry
- Vol. 237
Photo-thermal- luminescence traits of beta-ray irradiated fluoroborate glasses doped with Sm3+
- 16 June 2025
- Published by Elsevier in Radiation Physics and Chemistry
- Vol. 237
Photo-thermal- luminescence traits of beta-ray irradiated fluoroborate glasses doped with Sm3+
- 1 May 2025
- Published by Elsevier in Journal of Luminescence
- Vol. 284
Physicochemical and thermoluminescence characterizations of TiO2 nanoparticles
- 1 May 2025
- Published by Elsevier in Journal of Luminescence
- Vol. 284
Physicochemical and thermoluminescence characterizations of TiO2 nanoparticles
- Open Access
- 3 December 2024
- Published by Springer Nature in Journal of Fluorescence
- Vol. 35 (8) , 6913-6922
Phase-Dependent Thermoluminescence Properties of Zinc Sulphide
In the current study, the effects of heat treatment on the thermoluminescence (TL) and structural properties of zinc blend samples were studied. The samples were annealed after being heated for different time periods from 2 up to 10 h. The wurtzite hexagonal phase was observed upon heat treatment. It was observed that the presence of hexagonal phase with small percentage enhanced the thermoluminescence effect where the highest intensity was found to be for the sample with 8.2% wurtzite and 91.8% cubic zinc sulphide. The morphology of ZnS particles was studied by the HR-TEM analysis and it displayed an aggregated ZnS nanoparticles with almost uniform shape and size. The TL-glow curves for each sample were analysed using the Computerized Glow Curve Deconvolution (CGCD) and initial rise (IR) methods. Six trapping peaks exist between 0.98 and 1.45 eV through the deconvolution process. The number of peaks increased to 8 peaks for the fourth treatment, located between 0.95 and 1.56 eV. The activation energies and the frequency factors for getting traps were evaluated too.
- 3 December 2024
- Published by Springer Nature in Journal of Fluorescence
- Vol. 35 (8) , 6913-6922
Open AccessPhase-Dependent Thermoluminescence Properties of Zinc Sulphide
In the current study, the effects of heat treatment on the thermoluminescence (TL) and structural properties of zinc blend samples were studied. The samples were annealed after being heated for different time periods from 2 up to 10 h. The wurtzite hexagonal phase was observed upon heat treatment. It was observed that the presence of hexagonal phase with small percentage enhanced the thermoluminescence effect where the highest intensity was found to be for the sample with 8.2% wurtzite and 91.8% cubic zinc sulphide. The morphology of ZnS particles was studied by the HR-TEM analysis and it displayed an aggregated ZnS nanoparticles with almost uniform shape and size. The TL-glow curves for each sample were analysed using the Computerized Glow Curve Deconvolution (CGCD) and initial rise (IR) methods. Six trapping peaks exist between 0.98 and 1.45 eV through the deconvolution process. The number of peaks increased to 8 peaks for the fourth treatment, located between 0.95 and 1.56 eV. The activation energies and the frequency factors for getting traps were evaluated too.