Johan Sand
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Johan Sand has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- Juha Toivonen
Photonics Laboratory, Physics Unit, Faculty of Engineering and Natural Sciences, Tampere University
8 shared publications Harri Toivonen
HT Nuclear Ltd., Notkokatu 4, Hyvinkää, Finland
5 shared publications- Sakari Ihantola
Imperial College London, Department of Physics, London, U.K.
5 shared publications Adrian Nicholl
European Commission, Joint Research Centre, Institute for Transuranium Elements, Karlsruhe, Germany
3 shared publicationsErich Hrnecek
European Commission, Joint Research Centre, Institute for Transuranium Elements, Karlsruhe, Germany
3 shared publicationsKari Perajarvi
STUK–Radiation and Nuclear Safety Authority, Helsinki, Finland
3 shared publications
Latest Publications
- Open Access
- 9 December 2022
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1047
Novel optical technologies for emergency preparedness and response: Mapping contaminations with alpha-emitting radionuclides
- 9 December 2022
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1047
Open AccessNovel optical technologies for emergency preparedness and response: Mapping contaminations with alpha-emitting radionuclides
- 5 May 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 63 (3) , 1777-1783
Stand-Off Radioluminescence Mapping of Alpha Emitters Under Bright Lighting
Remote detection of alpha emitters is achieved by measuring the secondary radioluminescence light (air fluorescence) that is induced by alpha particles when absorbed in air. A telescope was used to collect the radioluminescence photons to a photomultiplier tube, which is operated in the photon counting mode. Careful matching of photocathode response and filter pass-band allows the sensing of a faint radioluminescence emission in a brightly illuminated environment, which is essential for operative use. A minimum detectable alpha activity of 4 kBq was reached at 1 m distance in 10 s time, when ultraviolet-free lighting is present, and 800 kBq under bright fluorescent lighting. These sensitivities are realized using an ultra-bialkali and cesium-telluride photocathodes in the aforementioned environments respectively. The presented approach is a robust and affordable solution to remotely detect and localize moderate alpha activities in a field environment, providing a means for automated alpha contamination mapping. Moreover, it is shown that a signal increase of more than two orders of magnitude (150–420) can be achieved in deep ultraviolet (close to 260 nm), if nitrogen or argon purge are used to enhance the detection.
- 5 May 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 63 (3) , 1777-1783
Stand-Off Radioluminescence Mapping of Alpha Emitters Under Bright Lighting
Remote detection of alpha emitters is achieved by measuring the secondary radioluminescence light (air fluorescence) that is induced by alpha particles when absorbed in air. A telescope was used to collect the radioluminescence photons to a photomultiplier tube, which is operated in the photon counting mode. Careful matching of photocathode response and filter pass-band allows the sensing of a faint radioluminescence emission in a brightly illuminated environment, which is essential for operative use. A minimum detectable alpha activity of 4 kBq was reached at 1 m distance in 10 s time, when ultraviolet-free lighting is present, and 800 kBq under bright fluorescent lighting. These sensitivities are realized using an ultra-bialkali and cesium-telluride photocathodes in the aforementioned environments respectively. The presented approach is a robust and affordable solution to remotely detect and localize moderate alpha activities in a field environment, providing a means for automated alpha contamination mapping. Moreover, it is shown that a signal increase of more than two orders of magnitude (150–420) can be achieved in deep ultraviolet (close to 260 nm), if nitrogen or argon purge are used to enhance the detection.
- Open Access
- 20 August 2015
- Published by Optica Publishing Group in Optica
- Vol. 2 (8) , 757-764
Supercontinuum generation as a signal amplifier
Supercontinuum white-light generation in optical fibers is a process that is known for its extreme sensitivity toward fluctuations of the input pulses, giving rise to a strong amplification of input noise. Such noise amplification has been recognized as a detrimental effect that prevents compression of the broad white-light spectra into a few-cycle pulse. Here, we show that the same effect can be exploited to amplify and recover faint modulation signals to an extent that seems impossible with any electronic method. We experimentally demonstrate the deterministic amplification of faint amplitude modulation signals by up to 60 dB. As we show from numerical simulations, this amplification process arises from the interaction dynamics between solitons and dispersive radiation in the fiber. The resulting all-optic signal restoration provides a new photonic building block that enables signal processing at virtually unlimited processing speeds.
- 20 August 2015
- Published by Optica Publishing Group in Optica
- Vol. 2 (8) , 757-764
Open AccessSupercontinuum generation as a signal amplifier
Supercontinuum white-light generation in optical fibers is a process that is known for its extreme sensitivity toward fluctuations of the input pulses, giving rise to a strong amplification of input noise. Such noise amplification has been recognized as a detrimental effect that prevents compression of the broad white-light spectra into a few-cycle pulse. Here, we show that the same effect can be exploited to amplify and recover faint modulation signals to an extent that seems impossible with any electronic method. We experimentally demonstrate the deterministic amplification of faint amplitude modulation signals by up to 60 dB. As we show from numerical simulations, this amplification process arises from the interaction dynamics between solitons and dispersive radiation in the fiber. The resulting all-optic signal restoration provides a new photonic building block that enables signal processing at virtually unlimited processing speeds.
- Open Access
- 1 May 2014
- Published by IOP Publishing in New Journal of Physics
- Vol. 16 (5)
Radioluminescence yield of alpha particles in air
- 1 May 2014
- Published by IOP Publishing in New Journal of Physics
- Vol. 16 (5)
Open AccessRadioluminescence yield of alpha particles in air
- 1 May 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 52, 1
EMCCD imaging of strongly ionizing radioactive materials for safety and security
In this work, an electron-multiplying camera is introduced for the first time for rapid alpha imaging in a glovebox. To demonstrate the technique, fuel pellets containing uranium and plutonium isotopes were measured at the Institute for Transuranium Elements, Karlsruhe. Further development of the EMCCD imaging system can evolve to a viable tool for security and safety officials around the world. The method has potential to be used in crime scene investigation if illicit use of alpha active materials is suspected. Other applications lie in the field of nuclear industry and especially in decommissioning of old facilities.
- 1 May 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 52, 1
EMCCD imaging of strongly ionizing radioactive materials for safety and security
In this work, an electron-multiplying camera is introduced for the first time for rapid alpha imaging in a glovebox. To demonstrate the technique, fuel pellets containing uranium and plutonium isotopes were measured at the Institute for Transuranium Elements, Karlsruhe. Further development of the EMCCD imaging system can evolve to a viable tool for security and safety officials around the world. The method has potential to be used in crime scene investigation if illicit use of alpha active materials is suspected. Other applications lie in the field of nuclear industry and especially in decommissioning of old facilities.
- 1 May 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1
Optical signal enhancement in supercontinuum generation
We show in this contribution that there is a surprising beneficial application of the noise amplification capability. Launching a pulse train with a weak sinusoidal amplitude modulation into the microstructure fiber, we observe up to 30-fold optical signal amplification of this modulation after the fiber.
- 1 May 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1
Optical signal enhancement in supercontinuum generation
We show in this contribution that there is a surprising beneficial application of the noise amplification capability. Launching a pulse train with a weak sinusoidal amplitude modulation into the microstructure fiber, we observe up to 30-fold optical signal amplification of this modulation after the fiber.
- 17 January 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 60 (1) , 305-309
Fluorescence-Assisted Gamma Spectrometry for Surface Contamination Analysis
A fluorescence-based alpha-gamma coincidence spectrometry approach has been developed for the analysis of alpha-emitting radionuclides. The thermalization of alpha particles in air produces UV light, which in turn can be detected over long distances. The simultaneous detection of UV and gamma photons allows detailed gamma analyses of a single spot of interest even in highly active surroundings. Alpha particles can also be detected indirectly from samples inside sealed plastic bags, which minimizes the risk of cross-contamination. The position-sensitive alpha-UV-gamma coincidence technique reveals the presence of alpha emitters and identifies the nuclides ten times faster than conventional gamma spectrometry.
- 17 January 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 60 (1) , 305-309
Fluorescence-Assisted Gamma Spectrometry for Surface Contamination Analysis
A fluorescence-based alpha-gamma coincidence spectrometry approach has been developed for the analysis of alpha-emitting radionuclides. The thermalization of alpha particles in air produces UV light, which in turn can be detected over long distances. The simultaneous detection of UV and gamma photons allows detailed gamma analyses of a single spot of interest even in highly active surroundings. Alpha particles can also be detected indirectly from samples inside sealed plastic bags, which minimizes the risk of cross-contamination. The position-sensitive alpha-UV-gamma coincidence technique reveals the presence of alpha emitters and identifies the nuclides ten times faster than conventional gamma spectrometry.
- 1 October 2012
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 690, 79-84
Principles of UV–gamma coincidence spectrometry
- 1 October 2012
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 690, 79-84
Principles of UV–gamma coincidence spectrometry
- Open Access
Transversely Excited Multipass Photoacoustic Cell Using Electromechanical Film as Microphone
A novel multipass photoacoustic cell with five stacked electromechanical films as a microphone has been constructed, tested and characterized. The photoacoustic cell is an open rectangular structure with two steel plates facing each other. The longitudinal acoustic resonances are excited transversely in an optical multipass configuration. A detection limit of 22 ppb (10−9) was achieved for flowing NO2 in N2 at normal pressure by using the maximum of 70 laser beams between the resonator plates. The corresponding minimum detectable absorption and the normalized noise-equivalent absorption coefficients were 2:2 × 10−7 cm−1 and 3:2 × 10−9 cm−1WHz−1/2, respectively.
Open AccessTransversely Excited Multipass Photoacoustic Cell Using Electromechanical Film as Microphone
A novel multipass photoacoustic cell with five stacked electromechanical films as a microphone has been constructed, tested and characterized. The photoacoustic cell is an open rectangular structure with two steel plates facing each other. The longitudinal acoustic resonances are excited transversely in an optical multipass configuration. A detection limit of 22 ppb (10−9) was achieved for flowing NO2 in N2 at normal pressure by using the maximum of 70 laser beams between the resonator plates. The corresponding minimum detectable absorption and the normalized noise-equivalent absorption coefficients were 2:2 × 10−7 cm−1 and 3:2 × 10−9 cm−1WHz−1/2, respectively.