Matthias Kampmann
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Matthias Kampmann has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Sybille Hellebrand
Paderborn University, Paderborn, Germany
3 shared publications - Hans-Joachim Wunderlich
University of Stuttgart, Stuttgart, Germany
2 shared publications - Alexander Sprenger
Paderborn University, Paderborn, Germany
1 shared publication - Eric Schneider
Institute of Computer Architecture and Computer Engineering, University of Stuttgart, Stuttgart, Germany
1 shared publication Jan Dennis Reimer
Paderborn University, Paderborn, Germany
1 shared publication- Michael Andreas Kochte
Department of Electrical Engineering, National Cheng Kung University, Tainan, Taiwan
1 shared publication
Latest Publications
- 1 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-10
Logic Fault Diagnosis of Hidden Delay Defects
Hidden delay defects (HDDs) are small delay defects that pass all at-speed tests at nominal capture time. They are an important indicator of latent defects that lead to early-life failures and aging problems that are serious especially in autonomous and medical applications. An effective way to screen out HDDs is to use Faster-than-At-Speed Testing (FAST) to observe outputs of sensitized non-critical paths which are expected to be stable earlier than nominal capture time.To improve the reliability of current and future designs, it is important to learn about the population of HDDs using logic diagnosis. We present the very first logic fault diagnosis technique that is able to identify HDDs by analyzing fail logs produced by FAST.Even with aggressive FAST testing, HDDs generate only very few failing test response bits. To overcome this severe challenge, we propose new backtracing and response matching methods that yield high diagnostic success rates even with very limited amount of failure data. The performance and scalability of our HDD diagnosis method is validated using fault injection campaigns with large benchmark circuits.
- 1 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-10
Logic Fault Diagnosis of Hidden Delay Defects
Hidden delay defects (HDDs) are small delay defects that pass all at-speed tests at nominal capture time. They are an important indicator of latent defects that lead to early-life failures and aging problems that are serious especially in autonomous and medical applications. An effective way to screen out HDDs is to use Faster-than-At-Speed Testing (FAST) to observe outputs of sensitized non-critical paths which are expected to be stable earlier than nominal capture time.To improve the reliability of current and future designs, it is important to learn about the population of HDDs using logic diagnosis. We present the very first logic fault diagnosis technique that is able to identify HDDs by analyzing fail logs produced by FAST.Even with aggressive FAST testing, HDDs generate only very few failing test response bits. To overcome this severe challenge, we propose new backtracing and response matching methods that yield high diagnostic success rates even with very limited amount of failure data. The performance and scalability of our HDD diagnosis method is validated using fault injection campaigns with large benchmark circuits.
- 1 January 2018
- Published by Elsevier in Microelectronics Reliability
- Vol. 80, 124-133
Design for Small Delay Test - A Simulation Study
- 1 January 2018
- Published by Elsevier in Microelectronics Reliability
- Vol. 80, 124-133
Design for Small Delay Test - A Simulation Study
- 1 November 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2, 109-114
Optimized Selection of Frequencies for Faster-Than-at-Speed Test
Small gate delay faults (SDFs) are not detectable at-speed, if they can only be propagated along short paths. These hidden delay faults (HDFs) do not influence the circuit's behavior initially, but they may indicate design marginalities leading to early-life failures, and therefore they cannot be neglected. HDFs can be detected by faster-than-at-speed test (FAST), where typically several different frequencies are used to maximize the coverage. A given set of test patterns P potentially detects a HDF if it contains a test pattern sensitizing a path through the fault site, and the efficiency of FAST can be measured as the ratio of actually detected HDFs to potentially detected HDFs. The paper at hand targets maximum test efficiency with a minimum number of frequencies. The procedure starts with a test set for transition delay faults and a set of preselected equidistant frequencies. Timing-accurate simulation of this initial setup identifies the hard-to-detect faults, which are then targeted by a more complex timing-aware ATPG procedure. For the yet undetected HDFs, a minimum number of frequencies are determined using an efficient hypergraph algorithm. Experimental results show that with this approach, the number of test frequencies required for maximum test efficiency can be reduced considerably. Furthermore, test set inflation is limited as timing-aware ATPG is only used for a small subset of HDFs.
- 1 November 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2, 109-114
Optimized Selection of Frequencies for Faster-Than-at-Speed Test
Small gate delay faults (SDFs) are not detectable at-speed, if they can only be propagated along short paths. These hidden delay faults (HDFs) do not influence the circuit's behavior initially, but they may indicate design marginalities leading to early-life failures, and therefore they cannot be neglected. HDFs can be detected by faster-than-at-speed test (FAST), where typically several different frequencies are used to maximize the coverage. A given set of test patterns P potentially detects a HDF if it contains a test pattern sensitizing a path through the fault site, and the efficiency of FAST can be measured as the ratio of actually detected HDFs to potentially detected HDFs. The paper at hand targets maximum test efficiency with a minimum number of frequencies. The procedure starts with a test set for transition delay faults and a set of preselected equidistant frequencies. Timing-accurate simulation of this initial setup identifies the hard-to-detect faults, which are then targeted by a more complex timing-aware ATPG procedure. For the yet undetected HDFs, a minimum number of frequencies are determined using an efficient hypergraph algorithm. Experimental results show that with this approach, the number of test frequencies required for maximum test efficiency can be reduced considerably. Furthermore, test set inflation is limited as timing-aware ATPG is only used for a small subset of HDFs.