MPMabel Ponton

Mabel Ponton

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Mabel Ponton has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Microwave Sensor Based on a Self-Modulated Oscillator

    by Mabel Pontón, Sergio Sancho, Almudena Suárez

    We propose a new type of oscillator sensor based on a self-modulated oscillator, exhibiting two concurrent oscillations at high and low frequency. To ensure a low phase noise, a high-frequency design is based on a stepped-impedance resonator, over which the material under test (MUT) is placed. The low-frequency oscillation is achieved through the introduction of feedback elements in the bias circuitry, by following a systematic procedure based on the use of stability circles and a rigorous two-stage stability analysis. The low-frequency oscillation modulates the high-frequency one and its harmonic components, generating multiple spectral lines around each of these components. For the first time to our knowledge, we demonstrate the simultaneous influence of the MUT on two concurrent oscillations, coupled through the nonlinear effects of the active device, as explained using an envelope-domain formulation. Thus, the sensing is based on the central frequency, frequency spacing, and amplitude of the spectral lines, enhancing both sensitivity and reliability. This multivariable approach enables robust multipoint detection and is expected to offer higher sensitivity compared with traditional methods that rely on a single oscillation frequency and amplitude. We present a calibration procedure, based on these measurands, to determine the real and imaginary parts of the MUT dielectric constant. The circuit has been fabricated and experimentally characterized, yielding very good results.


  • Open Access

    Analysis and Modeling of Super-Regenerative Oscillators With FSCW Signals

    by Sergio Sancho, Mabel Pontón, Almudena Suárez

    Active transponders based on super-regenerative oscillators (SROs) have the advantages of a high gain, low consumption, and a compact implementation. They rely on a switched oscillator excited by a low amplitude frequency-modulated continuous-wave (FMCW) signal, which provides an approximately phase-coherent response. Due to the complexity of their operation mode, involving the start-up transient and a time-varying phase shift, their realistic modeling is demanding. Here, we present an in-depth semianalytical investigation of an SRO transponder excited by a frequency-stepped signal, which includes, for the first time to our knowledge, a thorough analysis of the noise perturbations. The SRO is analyzed with a 2-D envelope-domain formulation, derived from a current function extracted from harmonic balance. As will be shown, the SRO response to the incoming signal can be predicted with two nonlinear functions, corresponding to the amplitude and phase, obtained in a single oscillation interval. We will derive an Ornstein–Uhlenbeck system from which the variance of the SRO amplitude and phase will be determined through a detailed analytical approach. Like the SRO response, the noise behavior can be predicted with functions extracted from a single oscillation pulse, which will relate the noise effects to the unperturbed amplitude and phase at the various oscillation stages. The complete investigation provides insight into the effect of nonlinearity and noise on the detected baseband signal and the estimated distance. It will be applied to an SRO at 2.7 GHz, which has been manufactured and measured.


  • Open Access

    Analysis of the Nonlinear Dynamics of an Injection-Locked Dual-Mode Oscillator

    by Mabel Pontón, Almudena Suarez, Sergio Sancho

    A detailed investigation of the nonlinear dynamics of injection-locked dual-mode oscillators, intended for a sensor application, is presented. It starts with the analytical study of a cubic-nonlinearity oscillator loaded with two distributed LC resonators. We demonstrate the stable behavior of the two periodic oscillation modes when one or two resonators are affected by the material under test (MUT). We also show the impact of the harmonic content on the oscillation frequencies and the mechanism that gives rise to the oscillatory solutions. Next, a practical transistor-based oscillator is addressed. We initially make use of a novel resonance diagram, able to predict the oscillation coexistence and then perform an accurate calculation of the periodic oscillations through an exhaustive analysis method, based on harmonic balance (HB). In the presence of the input signal, the two locking bands existing for each dielectric constant are simultaneously obtained by tracing the contours of a nonlinear current function. The phenomenon that gives rise to the switching from one oscillation to the other is identified with concepts from bifurcation theory. Finally, the MUT dielectric constant and loss tangent are detected from the central frequencies and bandwidths of the two locking bands using a linear interpolation procedure.


  • Oscillators Based on Step-Impedance and Slow Wave Transmission Lines for Sensing Applications

    by Mabel Ponton, Sergio Sancho, Amparo Herrera, Almudena Suarez

    This work investigates the capabilities of oscillators based on step-impedance and slow wave structures to sense dielectric constants. The material under test (MUT) is placed over the structure and the objective is to achieve a high sensitivity of the oscillation frequency with the advantage of low phase noise, enabled by the high quality factor of the structure. With the aid of simplified analytical models, we will initially study the variation of the resonance frequency of a istep-impedance transmission line with the dielectric constant of the MUT, paying attention to the influence of the number of line sections. The study includes the derivation of analytical expressions for the sensitivity of the resonance frequency. Next, the structure will be connected to the oscillator active core, which will be modeled with a numerical nonlinear admittance function extracted from harmonic-balance (HB) simulations. The resulting semianalytical formulation will provide insight into the variation of the oscillation frequency and amplitude with the dielectric constant of the MUT, as well as the variation of the phase-noise spectral density. It will also enable a versatile test and optimization of the various structures to achieve high sensitivity with low phase noise. The methods have been successfully applied to an field-effect transistor (FET)-based oscillator at about 2 GHz.


  • Wireless Injection Locking of Zero-IF Self-Oscillating Mixers

    by Mabel Ponton, Sergio Sancho, Amparo Herrera, Almudena Suarez

    The recently introduced Zero-IF self-oscillating mixers (SOMs) enable a direct frequency conversion, of interest for the implementation of compact and low consumption radio frequency identification (RFID) tags, among other applications. In previous works, the Zero-IF SOM is placed in only one of the terminals of the wireless link, the other one being based on a conventional scheme. In this article, a system made up of two wirelessly locked Zero-IF SOMs, operating as a frequency upconverter and downconverter, will be analyzed to evaluate its potential for low-cost short-range communications. A complete formulation describing the system under antenna and propagation effects will be presented, which, as a particular case, is able to predict the behavior of the previously proposed Zero-IF SOM, locked by an independent signal. The formulation based on oscillator models extracted from harmonic balance allows deriving design criteria for an optimum and robust performance and can predict the maximum communication range, as well as the stability properties and phase-noise behavior. The operation under modulated conditions is analyzed with a novel envelope-transient formulation, accounting for the time differentiation caused by the propagation effects. The methods have been applied to a system of two Zero-IF SOMs operating at 900 MHz.


  • Open Access

    Stability and Oscillation Analysis at Circuit Level and Through Semi-Analytical Formulations

    by Almudena Suarez, Sergio Sancho, Franco Ramirez, Mabel Ponton

    Harmonic balance provides steady-state solutions only and has significant shortcomings when addressing oscillatory regimes. As a result, complementary methodologies are required both to ensure the stability of the solution obtained and to design/simulate oscillator circuits. The complexity of the stability analysis increases with the number of active elements and the intricacy of the topology, so there can be uncertainties in the case of complex structures. On the other hand, as recently demonstrated oscillators enable a compact and low-cost implementation of RFID readers and radar systems, which comes at the expense of a more complex performance, very difficult/impossible to simulate with commercial HB. This work presents a review of recent advances on stability and oscillation analysis at circuit level and through semi-analytical formulations. At circuit level, a method for the stability analysis of complex microwave systems is presented, based on the calculation of the characteristic determinant, extracted from the commercial simulator through a judicious partition of the system into simpler blocks. This determinant will be used for the first time to obtain the stability boundaries through a contour-intersection method, able to provide multivalued and disconnected curves. At a semi-analytical level, a realistic numerical model of the standalone oscillator, extracted from HB simulations, is introduced in an analytical formulation that describes the oscillator interaction with other elements. Here it will be applied to a self-injection locked radar, in which the oscillator is injected by its own signal after this signal undergoes propagation and reflection effects. A procedure to determine the stability properties considering the time delay of the signal envelope is presented for the first time. Using the same self-injection concept, a new stabilization method to reduce the phase-noise of an existing oscillator with minimum impact on its original frequency is described.


  • Open Access

    Analysis of noise and dynamical effects in zero-IF self-oscillating mixers

    by M. Ponton, S. Sancho, A. Herrera, A. Suarez

    Zero-IF self-oscillating mixers (SOMs), based on injection locking, enable a compact direct frequency conversion and substantially mitigate the phase noise problem of heterodyne SOMs. Despite these advantages, their operation is complex and susceptible to exhibit a variety of dynamical effects. Here the need for an optimum selection of the operation point in the static injection-locked curve is demonstrated, as well as the inability of the oscillator to follow the variations of the input signal from a certain modulation frequency. Then a noise analysis of the downconverted signal is presented, based on a conversion-matrix formalism applied to a semi-analytical formulation.


  • Double Functionality Concurrent Dual-Band Self-Oscillating Mixer

    by Mabel Ponton, Amparo Herrera, Almudena Suarez

    A concurrent dual-band self-oscillating mixer (SOM), based on a ring-shaped stepped-impedance resonator, is proposed and analyzed in detail. Taking advantage of the ring even and odd resonances, the circuit can operate in concurrent dual quasi-periodic mode and injection-locked mode. In the second case, it behaves as a dual-band zero-intermediate-frequency (IF) mixer. Initially, an analytical study of the SOM behavior in the two modes is presented. Then a variety of accurate numerical methods are used for an in-depth investigation of the main aspects of its performance, including stability, conversion gain, linearity, and phase noise. The recently proposed contour-intersection technique and the outer-tier perturbation analysis are suitably adapted to the SOM case. A method is also presented to distinguish the parameter intervals leading to heterodyne and to zero-IF operation at both the lower and upper frequency bands. In the zero-IF SOM, the possible instantaneous unlocking in the presence of modulated input signals is investigated and avoided. The methods have been applied to a dual mixer at the frequencies 2.4 and 4.1 GHz.


  • Analysis of high-order sub-harmonically injection-locked oscillators

    by Silvia Hernández, Mabel Pontón, Sergio Sancho, Almudena Suárez

    High-order sub-harmonically injection-locked oscillators have recently been proposed for low phase-noise frequency generation, with carrier-selection capabilities. Though excellent experimental behavior has been demonstrated, the analysis/simulation of these circuits is demanding, due to the high ratio between the oscillation frequency and the frequency of the input source. This work provides an analysis methodology that covers the main aspects of the circuit behavior, including the detection of the locking bands and the prediction of the phase-noise spectral density. Initially, the oscillator in the presence of a multi-harmonic input source is described with a reduced-order envelope-domain formulation, at the oscillation frequency, based on an oscillator-admittance function extracted from harmonic-balance simulations. This allows deriving an expression for the oscillation phase shift with respect to the input source, and the average of this phase shift is shown to evolve continuously in the distinct synchronization bands obtained when varying a tuning voltage. This property can be used to detect the locking bands in circuit-level envelope-domain simulations, which, as shown here, can be done through different Fourier decompositions and sampling rates. The phase noise of the high-order sub-harmonic injection-locked oscillator under an arbitrary periodic input waveform is investigated in detail. The frequency response to the noise sources is described with a semi-analytical formulation, relying on the oscillator-admittance function in injection-locked conditions. The input noise is derived from the timing jitter of the injection source and the phase-noise response is shown to exhibit a low-pass characteristic, which initially follows the up-converted input noise and then the oscillator own noise sources. A method is proposed to identify the key parameters of the derived phase-noise spectrum from envelope-domain simulations. The various analysis methodologies have been applied to a prototype at 2.7 GHz at the sub-harmonic order N = 30 which has been manufactured and measured.