Lyubov Snizhko
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Lyubov Snizhko has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
- Allan Matthews
Department of Materials, The University of Manchester, Manchester M13 9PL, UK
4 shared publications N.L. Gurevina
4 shared publicationsD.O. Misnyankin
3 shared publicationsO. A. Kalinichenko
State Higher Educational Institution “Ukrainian State University of Chemical Technology
3 shared publicationsA. Yerokhin
2 shared publicationsA.L. Yerokhin
2 shared publications
Latest Publications
- 16 January 2020
- Published by Wiley in Israel Journal of Chemistry
- Vol. 60 (5-6) , 593-599
Comparative Adsorption of Tungsten and Silicon Oxides by Alumina Matrix
The incorporation of tungsten oxides on the surface of the oxidized aluminum alloy was investigated. Deposition was carried out in two ways – during the process of plasma‐electrolytic oxidation (PEO) and by impregnation of the oxide in solutions of tungsten salts. The experimental program was performed using a central composite rotatable planning. It is established that the amount of tungsten oxides in coatings obtained by PEO in mixed silicate‐tungstate electrolyte is 50 times higher than in coatings received by PEO in silicate electrolyte with following soaking in WO42− containing solutions.
- 16 January 2020
- Published by Wiley in Israel Journal of Chemistry
- Vol. 60 (5-6) , 593-599
Comparative Adsorption of Tungsten and Silicon Oxides by Alumina Matrix
The incorporation of tungsten oxides on the surface of the oxidized aluminum alloy was investigated. Deposition was carried out in two ways – during the process of plasma‐electrolytic oxidation (PEO) and by impregnation of the oxide in solutions of tungsten salts. The experimental program was performed using a central composite rotatable planning. It is established that the amount of tungsten oxides in coatings obtained by PEO in mixed silicate‐tungstate electrolyte is 50 times higher than in coatings received by PEO in silicate electrolyte with following soaking in WO42− containing solutions.
- 1 September 2019
- Published by Allerton Press in Surface Engineering and Applied Electrochemistry
- Vol. 55 (5) , 595-601
Corrosion of Magnesium Alloy AZ31 Coated by Plasma Electrolytic Oxidation
In this work, plasma electrolytic oxidation was performed on AZ31 magnesium alloy. The electrolytes contained mixtures of sodium silicate, sodium hexamethaphosphate, potassium hydroxide, and...
- 1 September 2019
- Published by Allerton Press in Surface Engineering and Applied Electrochemistry
- Vol. 55 (5) , 595-601
Corrosion of Magnesium Alloy AZ31 Coated by Plasma Electrolytic Oxidation
In this work, plasma electrolytic oxidation was performed on AZ31 magnesium alloy. The electrolytes contained mixtures of sodium silicate, sodium hexamethaphosphate, potassium hydroxide, and...
- 1 March 2019
- Published by Allerton Press in Surface Engineering and Applied Electrochemistry
- Vol. 55 (2) , 191-196
Analysis of Gaseous Products of Plasma Electrolytic Oxidation of Aluminum
The measurements of the volume and density of the anodic gas evolved in anodic-spark oxidation showed that the ratio of hydrogen to oxygen is about 1.6–1.8 at current densities of 1000–3000 A m−2....
- 1 March 2019
- Published by Allerton Press in Surface Engineering and Applied Electrochemistry
- Vol. 55 (2) , 191-196
Analysis of Gaseous Products of Plasma Electrolytic Oxidation of Aluminum
The measurements of the volume and density of the anodic gas evolved in anodic-spark oxidation showed that the ratio of hydrogen to oxygen is about 1.6–1.8 at current densities of 1000–3000 A m−2....
- Open Access
The Influence of the Electrolyte Nature and PEO Process Parameters on Properties of Anodized Ti-15Mo Alloy Intended for Biomedical Applications
Plasma electrolytic oxidation (PEO) of Ti-15Mo alloys conducted in electrolytes containing Ca and P compounds can be an efficient process with which to obtain bioactive coatings. This paper reports on the influence of the nature of the electrolyte, its concentration, and PEO process parameters on the properties of anodized layers on Ti-15Mo. A wide range of Ca- and P-containing alkaline and acidic solutions was employed to incorporate Ca and P ions into the anodized layer. The efficiency of the incorporation was evaluated by the Ca/P ratio in the coating as compared to that in the electrolyte. It was found that alkaline solutions are not suitable electrolytes for the formation of good quality, uniform PEO coatings. Only acidic electrolytes are appropriate for obtaining well-adherent homogeneous layers on Ti-15Mo. However, the maximum Ca/P ratios reached in the coatings were rather low (close to 1). The variation of electrical signal (negative-to-positive current ratio, frequency) and time of electrolysis do not result in a substantial change of this value. The processing time, however, did influence the coating thickness. Despite their low Ca/P ratio, the anodized layers demonstrate good biological activity, comparable to pure microrough titanium.
Open AccessThe Influence of the Electrolyte Nature and PEO Process Parameters on Properties of Anodized Ti-15Mo Alloy Intended for Biomedical Applications
Plasma electrolytic oxidation (PEO) of Ti-15Mo alloys conducted in electrolytes containing Ca and P compounds can be an efficient process with which to obtain bioactive coatings. This paper reports on the influence of the nature of the electrolyte, its concentration, and PEO process parameters on the properties of anodized layers on Ti-15Mo. A wide range of Ca- and P-containing alkaline and acidic solutions was employed to incorporate Ca and P ions into the anodized layer. The efficiency of the incorporation was evaluated by the Ca/P ratio in the coating as compared to that in the electrolyte. It was found that alkaline solutions are not suitable electrolytes for the formation of good quality, uniform PEO coatings. Only acidic electrolytes are appropriate for obtaining well-adherent homogeneous layers on Ti-15Mo. However, the maximum Ca/P ratios reached in the coatings were rather low (close to 1). The variation of electrical signal (negative-to-positive current ratio, frequency) and time of electrolysis do not result in a substantial change of this value. The processing time, however, did influence the coating thickness. Despite their low Ca/P ratio, the anodized layers demonstrate good biological activity, comparable to pure microrough titanium.
- 1 November 2016
- Published by Springer Nature in Materials Science
- Vol. 52 (3) , 421-430
Hydrogen Release on the Anode in the Course of Plasma Electrolytic Oxidation of Aluminum
- 1 November 2016
- Published by Springer Nature in Materials Science
- Vol. 52 (3) , 421-430
Hydrogen Release on the Anode in the Course of Plasma Electrolytic Oxidation of Aluminum
- 1 August 2016
- Published by Elsevier in Applied Surface Science
- Vol. 378, 207-215
Synthesis by anodic-spark deposition of Ca- and P-containing films on pure titanium and their biological response
- 1 August 2016
- Published by Elsevier in Applied Surface Science
- Vol. 378, 207-215
Synthesis by anodic-spark deposition of Ca- and P-containing films on pure titanium and their biological response
- 1 May 2016
- Published by Allerton Press in Surface Engineering and Applied Electrochemistry
- Vol. 52 (3) , 257-262
Synthesis of calcium phosphates on titanium
- 1 May 2016
- Published by Allerton Press in Surface Engineering and Applied Electrochemistry
- Vol. 52 (3) , 257-262
Synthesis of calcium phosphates on titanium
- Open Access
- 29 May 2015
- Published by Igor Sikorsky Kyiv Polytechnic Institute in Матеріали міжнародної науково-практиченої конференції "Екологія. Людина. Суспільство"
- p. 136-137
A promising use of asphalt-resin-paraffin deposits
The organic fraction of asphalt-resin-paraffin deposits was investigated as an additive to BND 60/90 and BND 90/130 road bitumens modified with latex and styrene-butadiene-styrene block copolymer. The deposits were prepared by hot vacuum filtration with a petroleum solvent and distillation. Mixing was conducted at 160–165 °C. Adding the deposits increased the softening point. The compositions met the specified penetration-index range and the BMP 40/60-56 grade requirements. Experimental asphalt concrete met water saturation and compressive strength standards. A single-stage technological scheme for producing modified bitumen was proposed. Editorial note (2026): This abstract was prepared for reference purposes using artificial intelligence technology, based on the original publication, without the involvement of the author(s).
- 29 May 2015
- Published by Igor Sikorsky Kyiv Polytechnic Institute in Матеріали міжнародної науково-практиченої конференції "Екологія. Людина. Суспільство"
- p. 136-137
Open AccessA promising use of asphalt-resin-paraffin deposits
The organic fraction of asphalt-resin-paraffin deposits was investigated as an additive to BND 60/90 and BND 90/130 road bitumens modified with latex and styrene-butadiene-styrene block copolymer. The deposits were prepared by hot vacuum filtration with a petroleum solvent and distillation. Mixing was conducted at 160–165 °C. Adding the deposits increased the softening point. The compositions met the specified penetration-index range and the BMP 40/60-56 grade requirements. Experimental asphalt concrete met water saturation and compressive strength standards. A single-stage technological scheme for producing modified bitumen was proposed. Editorial note (2026): This abstract was prepared for reference purposes using artificial intelligence technology, based on the original publication, without the involvement of the author(s).
- 5 November 2014
- Published by Pleiades Publishing Ltd in Protection of Metals and Physical Chemistry of Surfaces
- Vol. 50 (6) , 705-708
The nature of anodic gas at plasma electrolytic oxidation
The output of electro- and thermochemical reactions has been estimated quantitatively on the basis of analyses of the products obtained by plasma electrolytic oxidation (PEO) such as volume and...
- 5 November 2014
- Published by Pleiades Publishing Ltd in Protection of Metals and Physical Chemistry of Surfaces
- Vol. 50 (6) , 705-708
The nature of anodic gas at plasma electrolytic oxidation
The output of electro- and thermochemical reactions has been estimated quantitatively on the basis of analyses of the products obtained by plasma electrolytic oxidation (PEO) such as volume and...
- Open Access
- 30 December 2013
- Published by State University "Kyiv Aviation Institute" in Proceedings of the National Aviation University
- Vol. 57 (4) , 139-143
Аналіз асфальто-смоло-парафінових відкладень на нафтопереробному обладнанні
The methodology and analysis of wax deposits formed in-water-cooling tower, cistern and tank from wax petroleum were developed. It was shown, that deposits consist of organic (>90%) and inorganic components – the first one was enriched by high molecular wax hydrocarbons, the second one – by mechanical impurities. The methods of deposits utilization were proposed
- 30 December 2013
- Published by State University "Kyiv Aviation Institute" in Proceedings of the National Aviation University
- Vol. 57 (4) , 139-143
Open AccessАналіз асфальто-смоло-парафінових відкладень на нафтопереробному обладнанні
The methodology and analysis of wax deposits formed in-water-cooling tower, cistern and tank from wax petroleum were developed. It was shown, that deposits consist of organic (>90%) and inorganic components – the first one was enriched by high molecular wax hydrocarbons, the second one – by mechanical impurities. The methods of deposits utilization were proposed