Giulia Lanzara
Research Subjects
Giulia Lanzara has a total of 64 co-authors. Here are the top co-authors by number of shared publications:
Fu-Kuo Chang
Department of Aeronautics and Astronautics, Stanford University, Stanford, CA, USA
8 shared publications- Nathan Salowitz
Department of Mechanical Engineering, University of Wisconsin-Milwaukee, Milwaukee, WI, United States of America
5 shared publications Zhiqiang Guo
Department of Mechanical Engineering, Stanford University, Stanford, CA, USA
5 shared publications- Evert P. Houwman
Inorganic Materials Science, MESA+ Institute, University of Twente , 7522 NB Enschede
4 shared publications - Alessandro Porrari
Roma Tre University
3 shared publications - Ginevra Hausherr
University of Rome, Roma Tre
3 shared publications
Latest Publications
- 21 August 2026
- Published by Springer Nature
- p. 3-12
An “Invisible” Piezoelectric Web for Detecting Structural Nonlinearities
- 21 August 2026
- Published by Springer Nature
- p. 3-12
An “Invisible” Piezoelectric Web for Detecting Structural Nonlinearities
- Open Access
- 10 July 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 140 (2)
Analysis of the film thickness dependence of the ferroelectric properties of epitaxial PMN–PT thin films on a thin PZT interfacial layer
Perovskite phase-pure, (001)-oriented, epitaxial [Pb(Mg1/3Nb2/3)O3]0.67–(PbTiO3)0.33 (PMN–PT) thin films with six different thicknesses in the range 100–1000 nm were deposited on single-crystal, (001)-oriented SrTiO3 substrates on a 25 nm Pb(Zr0.5Ti0.5)O3 interfacial layer. The measured ferroelectric, dielectric, and piezoelectric property values of parallel-plate capacitor structures increase with PMN–PT layer thickness. This is explained by increasing local polarization further away from the substrate, which is deduced from the properties of the thickness series. The polarization change is explained by strain relaxation with increasing thickness and also indicates a symmetry change from rhombohedral to tetragonal symmetry above a thickness of 800 nm. This correlates with an earlier found abrupt change of Young's modulus and hardness.
- 10 July 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 140 (2)
Open AccessAnalysis of the film thickness dependence of the ferroelectric properties of epitaxial PMN–PT thin films on a thin PZT interfacial layer
Perovskite phase-pure, (001)-oriented, epitaxial [Pb(Mg1/3Nb2/3)O3]0.67–(PbTiO3)0.33 (PMN–PT) thin films with six different thicknesses in the range 100–1000 nm were deposited on single-crystal, (001)-oriented SrTiO3 substrates on a 25 nm Pb(Zr0.5Ti0.5)O3 interfacial layer. The measured ferroelectric, dielectric, and piezoelectric property values of parallel-plate capacitor structures increase with PMN–PT layer thickness. This is explained by increasing local polarization further away from the substrate, which is deduced from the properties of the thickness series. The polarization change is explained by strain relaxation with increasing thickness and also indicates a symmetry change from rhombohedral to tetragonal symmetry above a thickness of 800 nm. This correlates with an earlier found abrupt change of Young's modulus and hardness.
- 1 May 2024
- Published by Springer Nature
- p. 271-278
Magneto-Dynamic Characterization of a Silicone Filament Embedded with Magnetic Composite Microspheres
- 1 May 2024
- Published by Springer Nature
- p. 271-278
Magneto-Dynamic Characterization of a Silicone Filament Embedded with Magnetic Composite Microspheres
- 1 May 2024
- Published by Springer Nature
- p. 463-469
Multilayer Radical Morphing: Shape Transitions and Vibration
- 1 May 2024
- Published by Springer Nature
- p. 463-469
Multilayer Radical Morphing: Shape Transitions and Vibration
- 1 May 2024
- Published by Springer Nature
- p. 233-241
Sensing Sound with Electrospun Piezo Materials on a 3D-Printed Structure
- 1 May 2024
- Published by Springer Nature
- p. 233-241
Sensing Sound with Electrospun Piezo Materials on a 3D-Printed Structure
- 1 May 2024
- Published by Springer Nature
- p. 267-277
Vibration Damping in Fiber-Reinforced Bistable Composites with Magnetic Particles
- 1 May 2024
- Published by Springer Nature
- p. 267-277
Vibration Damping in Fiber-Reinforced Bistable Composites with Magnetic Particles
- 1 May 2024
- Published by Springer Nature
- p. 279-290
Magnetic Field and Ferrite Particles Interaction for Membranes with Augmented Shock-Absorption Capability
- 1 May 2024
- Published by Springer Nature
- p. 279-290
Magnetic Field and Ferrite Particles Interaction for Membranes with Augmented Shock-Absorption Capability
- Open Access
- 10 April 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (14) , 145302
Effect of a niobium-doped PZT interfacial layer thickness on the properties of epitaxial PMN-PT thin films
We are reporting on high quality epitaxial thin films of [Pb(Mg1/3Nb2/3)O3]0.67-(PbTiO3)0.33 [PMN-PT (67/33)]. These films were deposited on (001) oriented, vicinal SrTiO3 single crystal substrates, using 1 mol. % niobium-doped Pb(Zr0.52,Ti0.48)O3 (Nb-PZT) as an interfacial layer. The functional properties of the epitaxial PMN-PT (67/33) thin films were investigated as a function of the layer thickness of the Nb-PZT layer. The deposited hetero-structures are perovskite phase pure and fully (001)-oriented. The variation in Nb-PZT interfacial layer thickness results in an increasing trend change of the in-plane lattice parameter of that layer, which in turn causes a decrease in the c/a ratio of the PMN-PT film on top. The most noticeable effect related to this is a decrease in built-in-bias (imprint) voltage. Thus, the built-in bias can be tuned by changing the interfacial layer thickness. The ferroelectric capacitor properties are found to be most stable for the thinnest interfacial layers under a high number (108) of switching cycles.
- 10 April 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (14) , 145302
Open AccessEffect of a niobium-doped PZT interfacial layer thickness on the properties of epitaxial PMN-PT thin films
We are reporting on high quality epitaxial thin films of [Pb(Mg1/3Nb2/3)O3]0.67-(PbTiO3)0.33 [PMN-PT (67/33)]. These films were deposited on (001) oriented, vicinal SrTiO3 single crystal substrates, using 1 mol. % niobium-doped Pb(Zr0.52,Ti0.48)O3 (Nb-PZT) as an interfacial layer. The functional properties of the epitaxial PMN-PT (67/33) thin films were investigated as a function of the layer thickness of the Nb-PZT layer. The deposited hetero-structures are perovskite phase pure and fully (001)-oriented. The variation in Nb-PZT interfacial layer thickness results in an increasing trend change of the in-plane lattice parameter of that layer, which in turn causes a decrease in the c/a ratio of the PMN-PT film on top. The most noticeable effect related to this is a decrease in built-in-bias (imprint) voltage. Thus, the built-in bias can be tuned by changing the interfacial layer thickness. The ferroelectric capacitor properties are found to be most stable for the thinnest interfacial layers under a high number (108) of switching cycles.
- Open Access
- 3 August 2020
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 128 (5) , 055302
Effect of a thin (doped) PZT interfacial layer on the properties of epitaxial PMN-PT films
Pure perovskite phase, (001)-oriented, epitaxial thin films of (Pb(Mg1/3Nb2/3)O3)0.67-(PbTiO3)0.33 (PMN-PT) were fabricated on single crystal, (001)-oriented SrTiO3 substrates using a hard (Fe-doped) and soft doped (Nb-doped) PZT(52/48) interfacial layer. The effect of different interface layers on the structural and ferroelectric properties of the PMN-PT films was investigated in detail. A significant self-bias voltage in the PMN-PT films can be introduced by using an appropriate interfacial layer. There are significant differences in polarization for different types of doped and undoped interface layers and a doubling of the relative dielectric constant was observed for the Nb-doped interfacial layer. Device properties remain stable up to at least 108 cycles.
- 3 August 2020
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 128 (5) , 055302
Open AccessEffect of a thin (doped) PZT interfacial layer on the properties of epitaxial PMN-PT films
Pure perovskite phase, (001)-oriented, epitaxial thin films of (Pb(Mg1/3Nb2/3)O3)0.67-(PbTiO3)0.33 (PMN-PT) were fabricated on single crystal, (001)-oriented SrTiO3 substrates using a hard (Fe-doped) and soft doped (Nb-doped) PZT(52/48) interfacial layer. The effect of different interface layers on the structural and ferroelectric properties of the PMN-PT films was investigated in detail. A significant self-bias voltage in the PMN-PT films can be introduced by using an appropriate interfacial layer. There are significant differences in polarization for different types of doped and undoped interface layers and a doubling of the relative dielectric constant was observed for the Nb-doped interfacial layer. Device properties remain stable up to at least 108 cycles.
- 28 January 2020
- Published by Springer Nature
- p. 141-149
Electromechanical Characterization of an Electrospun Piezoelectric Microfiber
- 28 January 2020
- Published by Springer Nature
- p. 141-149
Electromechanical Characterization of an Electrospun Piezoelectric Microfiber