Marina E. Galkina
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Marina E. Galkina has a total of 52 co-authors. Here are the top co-authors by number of shared publications:
- Aleksandr Poplavsky
Belgorod State University
12 shared publications - Alexander Ya. Kolpakov
Belgorod State National Research University
11 shared publications - Igor Yu. Goncharov
Joint Research Center “Technology and Materials”, Belgorod State National Research University, 308015 Belgorod, Russia
6 shared publications J. V. Gerus
4 shared publicationsS. S. Manokhin
4 shared publications- Marina Kovaleva
Joint Research Center «Technology and Materials», Belgorod State National Research University, Pobeda 85, 308015 Belgorod, Russia
3 shared publications
Latest Publications
- Open Access
- 28 September 2021
- Published by V. N. Karazin Kharkiv National University in East European Journal of Physics
- No. 3,p. 124-133
Influence Of Formation Conditions, Subsequent Annealing and Ion Irradiation on the Properties of Nanostructured Coatings Based on Amorphous Carbon with Gold, Silver and Nitrogen Additives
Nanostructured coatings based on amorphous carbon and carbon-doped with gold, silver, and nitrogen were obtained by the pulsed vacuum-arc method. Carbon coatings have been annealed in a vacuum as well as treated with argon ions. The alloying of carbon coatings with elements that do not form chemical bonds with the carbon matrix (Ag, Au) leads to the formation of gold or silver nanocrystallites with sizes of 2 ‑ 20 nm in the matrix of amorphous carbon, whose density depends on the concentration of the doping element. Annealing of silver-doped carbon coatings leads to the formation of islands on the surface with the size of the order of micrometers. This is due to the silver diffusion and coalescence of small islands into larger ones. The HRTEM method discovered the effect of twinning in carbon nanocrystallites after vacuum annealing as well as silver and gold in the initial state (the formation of single-crystal regions with an altered orientation of the crystal structure) in the amorphous carbon matrix. Analysis of Raman spectra of pure carbon coating and silver-doped showed that the addition of silver leads to a decrease in sp3-phase in the carbon matrix. This effect is particularly evident in the nature of changes in the spectra after vacuum annealing at 600 ºC. The addition of nitrogen in the carbon coating leads to an increase in the sp2 ‑ phase fraction, and additional annealing leads to a significant increase in the D - peak intensity and formation of clusters of the order of 5 ‑ 15 nm, which are not localized but fill the entire space. Analysis of the coating a-C: Au irradiation with argon ions shows that the number of nanopitches decreased after ion irradiation, simultaneously decreased surface roughness degree, besides, decreased electrical conductivity of the coating as a result of decreased gold content. It was found that the conditions of nanostructured coatings and their subsequent processing allow controlling the properties of nanocoatings (structure, size of nanoparticles, surface topography, and electrical conductivity).
- 28 September 2021
- Published by V. N. Karazin Kharkiv National University in East European Journal of Physics
- No. 3,p. 124-133
Open AccessInfluence Of Formation Conditions, Subsequent Annealing and Ion Irradiation on the Properties of Nanostructured Coatings Based on Amorphous Carbon with Gold, Silver and Nitrogen Additives
Nanostructured coatings based on amorphous carbon and carbon-doped with gold, silver, and nitrogen were obtained by the pulsed vacuum-arc method. Carbon coatings have been annealed in a vacuum as well as treated with argon ions. The alloying of carbon coatings with elements that do not form chemical bonds with the carbon matrix (Ag, Au) leads to the formation of gold or silver nanocrystallites with sizes of 2 ‑ 20 nm in the matrix of amorphous carbon, whose density depends on the concentration of the doping element. Annealing of silver-doped carbon coatings leads to the formation of islands on the surface with the size of the order of micrometers. This is due to the silver diffusion and coalescence of small islands into larger ones. The HRTEM method discovered the effect of twinning in carbon nanocrystallites after vacuum annealing as well as silver and gold in the initial state (the formation of single-crystal regions with an altered orientation of the crystal structure) in the amorphous carbon matrix. Analysis of Raman spectra of pure carbon coating and silver-doped showed that the addition of silver leads to a decrease in sp3-phase in the carbon matrix. This effect is particularly evident in the nature of changes in the spectra after vacuum annealing at 600 ºC. The addition of nitrogen in the carbon coating leads to an increase in the sp2 ‑ phase fraction, and additional annealing leads to a significant increase in the D - peak intensity and formation of clusters of the order of 5 ‑ 15 nm, which are not localized but fill the entire space. Analysis of the coating a-C: Au irradiation with argon ions shows that the number of nanopitches decreased after ion irradiation, simultaneously decreased surface roughness degree, besides, decreased electrical conductivity of the coating as a result of decreased gold content. It was found that the conditions of nanostructured coatings and their subsequent processing allow controlling the properties of nanocoatings (structure, size of nanoparticles, surface topography, and electrical conductivity).
- 1 January 2019
- Published by Sumy State University in Journal of Nano- and Electronic Physics
- Vol. 11 (4) , 04019-1
Nanostructured Coatings Based on Amorphous Carbon and Gold Nanoparticles Obtained by the Pulsed Vacuum-arc Method
Journal of Nano- and Electronic Physics. Scientific journal. ISSN: 2077-6772. Journal abbreviation: J. Nano- Electron. Phys. No page charges. All articles are freely available on-line. Issued 4 times per year. Publisher: Sumy State University. (Sumy, Ukraine)
- 1 January 2019
- Published by Sumy State University in Journal of Nano- and Electronic Physics
- Vol. 11 (4) , 04019-1
Nanostructured Coatings Based on Amorphous Carbon and Gold Nanoparticles Obtained by the Pulsed Vacuum-arc Method
Journal of Nano- and Electronic Physics. Scientific journal. ISSN: 2077-6772. Journal abbreviation: J. Nano- Electron. Phys. No page charges. All articles are freely available on-line. Issued 4 times per year. Publisher: Sumy State University. (Sumy, Ukraine)
- 18 December 2018
- Published by Elsevier in Materials Today: Proceedings
- Vol. 5 (12) , 25933-25938
Properties of carbon coatings obtained by pulsed high power methods of vacuum-arc and magnetron sputtering
- 18 December 2018
- Published by Elsevier in Materials Today: Proceedings
- Vol. 5 (12) , 25933-25938
Properties of carbon coatings obtained by pulsed high power methods of vacuum-arc and magnetron sputtering
- 17 July 2018
- Published by Ivanovo State University of Chemistry and Technology in ChemChemTech
- Vol. 59 (9) , 68-73
PROPERTIES OF NITROGEN-DOPED AMORPHOUS CARBON COATINGS OBTAINED BY IMPULSE VACUUM-ARC METHOD
The paper presents results of the research of the structure and properties of nitrogen-doped amorphous carbon coatings obtained in the vacuum from the flow of pulsed carbon plasma. The doping by nitrogen of carbon coating was determined to lead to increases in electrical conductivity, reductions of internal stresses, reduce of density, hardness and modulus, and to the change in structure, surface morphology and tribological characteristics.
- 17 July 2018
- Published by Ivanovo State University of Chemistry and Technology in ChemChemTech
- Vol. 59 (9) , 68-73
PROPERTIES OF NITROGEN-DOPED AMORPHOUS CARBON COATINGS OBTAINED BY IMPULSE VACUUM-ARC METHOD
The paper presents results of the research of the structure and properties of nitrogen-doped amorphous carbon coatings obtained in the vacuum from the flow of pulsed carbon plasma. The doping by nitrogen of carbon coating was determined to lead to increases in electrical conductivity, reductions of internal stresses, reduce of density, hardness and modulus, and to the change in structure, surface morphology and tribological characteristics.
- 1 July 2018
- Published by Allerton Press in Journal of Friction and Wear
- Vol. 39 (4) , 345-348
Properties of Coatings Based on Carbon and Nitrogen-Doped Carbon Obtained Using a Pulsed Vacuum Arc Method
Diamond-like carbon coatings on hard-alloy substrates, including coatings doped with nitrogen about 1.0 μm thick have been obtained using a pulse vacuum-arc method. Three types of coatings have been...
- 1 July 2018
- Published by Allerton Press in Journal of Friction and Wear
- Vol. 39 (4) , 345-348
Properties of Coatings Based on Carbon and Nitrogen-Doped Carbon Obtained Using a Pulsed Vacuum Arc Method
Diamond-like carbon coatings on hard-alloy substrates, including coatings doped with nitrogen about 1.0 μm thick have been obtained using a pulse vacuum-arc method. Three types of coatings have been...
- 23 March 2017
- Published by Pleiades Publishing Ltd in Protection of Metals and Physical Chemistry of Surfaces
- Vol. 53 (2) , 294-298
Properties of coatings on the basis of carbon, tungsten, boron, and titanium obtained by the pulsed vacuum-arc method
Results of an investigation of the properties of coatings on the basis of carbon, tungsten, boron, and titanium obtained by the pulsed vacuum-arc method are presented. It has been found that the adhesion characteristics of coatings based on boron and titanium may be improved using a composite carbon-based coating, doped with tungsten, boron, and titanium, which, moreover, has a microhardness greater than those of a coating based on titanium and boron.
- 23 March 2017
- Published by Pleiades Publishing Ltd in Protection of Metals and Physical Chemistry of Surfaces
- Vol. 53 (2) , 294-298
Properties of coatings on the basis of carbon, tungsten, boron, and titanium obtained by the pulsed vacuum-arc method
Results of an investigation of the properties of coatings on the basis of carbon, tungsten, boron, and titanium obtained by the pulsed vacuum-arc method are presented. It has been found that the adhesion characteristics of coatings based on boron and titanium may be improved using a composite carbon-based coating, doped with tungsten, boron, and titanium, which, moreover, has a microhardness greater than those of a coating based on titanium and boron.
- 1 January 2016
- Published by Sumy State University in Journal of Nano- and Electronic Physics
- Vol. 8 (4(1)) , 04019-1
Formation of Nanostructured Coating Based on the Amorphous Carbon Matrix and Silver Nanocrystallites
Journal of Nano- and Electronic Physics. Scientific journal. ISSN: 2077-6772. Journal abbreviation: J. Nano- Electron. Phys. No page charges. All articles are freely available on-line. Issued 4 times per year. Publisher: Sumy State University. (Sumy, Ukraine)
- 1 January 2016
- Published by Sumy State University in Journal of Nano- and Electronic Physics
- Vol. 8 (4(1)) , 04019-1
Formation of Nanostructured Coating Based on the Amorphous Carbon Matrix and Silver Nanocrystallites
Journal of Nano- and Electronic Physics. Scientific journal. ISSN: 2077-6772. Journal abbreviation: J. Nano- Electron. Phys. No page charges. All articles are freely available on-line. Issued 4 times per year. Publisher: Sumy State University. (Sumy, Ukraine)
- 8 December 2014
- Published by AIP Publishing in Applied Physics Letters
- Vol. 105 (23) , 233110
The local crystallization in nanoscale diamond-like carbon films during annealing
The local crystallization during annealing at 600 °C in nanoscale diamond-like carbon coatings films grown by pulsed vacuum-arc deposition method was observed using modern techniques of high-resolution transmission electron microscopy. The crystallites formed by annealing have a face-centred cubic crystal structure and grow in the direction [ ] as a normal to the film surface. The number and size of the crystallites depend on the initial values of the intrinsic stresses before annealing, which in turn depend on the conditions of film growth. The sizes of crystallites are 10 nm for films with initial compressive stresses of 3 GPa and 17 nm for films with initial compressive stresses of 12 GPa. Areas of local crystallization arising during annealing have a structure different from the graphite. Additionally, the investigation results of the structure of nanoscale diamond-like carbon coatings films using Raman spectroscopy method are presented, which are consistent with the transmission electron microscopy research results.- 8 December 2014
- Published by AIP Publishing in Applied Physics Letters
- Vol. 105 (23) , 233110
The local crystallization in nanoscale diamond-like carbon films during annealing
The local crystallization during annealing at 600 °C in nanoscale diamond-like carbon coatings films grown by pulsed vacuum-arc deposition method was observed using modern techniques of high-resolution transmission electron microscopy. The crystallites formed by annealing have a face-centred cubic crystal structure and grow in the direction [ ] as a normal to the film surface. The number and size of the crystallites depend on the initial values of the intrinsic stresses before annealing, which in turn depend on the conditions of film growth. The sizes of crystallites are 10 nm for films with initial compressive stresses of 3 GPa and 17 nm for films with initial compressive stresses of 12 GPa. Areas of local crystallization arising during annealing have a structure different from the graphite. Additionally, the investigation results of the structure of nanoscale diamond-like carbon coatings films using Raman spectroscopy method are presented, which are consistent with the transmission electron microscopy research results.