Ardian B. Gojani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Ardian B. Gojani has a total of 49 co-authors. Here are the top co-authors by number of shared publications:
- Jack J. Yoh
Department of Aerospace Engineering, Seoul National University , Seoul
7 shared publications Shigeru Obayashi
Institute of Fluid Science, Tohoku University, Sendai 980-8577, Japan
7 shared publicationsTae-Hee Han
Seoul National University
5 shared publicationsBurim Kamishi
Department of Physics, Faculty of Mathematical and Natural Sciences, University of Prishtina, Prishtina, Kosovo
3 shared publicationsK. Takayama
Tohoku University
3 shared publicationsE. Timofeev
McGill University
2 shared publications
Latest Publications
- Open Access
- 17 January 2022
- Published by Wiley in Advanced Engineering Materials
- Vol. 24 (6)
Generalized Analysis Approach of the Profile Roughness by Electron Microscopy with the Example of Hierarchically Grown Polystyrene–Iron Oxide–Silica Core–Shell–Shell Particles
- 17 January 2022
- Published by Wiley in Advanced Engineering Materials
- Vol. 24 (6)
Open AccessGeneralized Analysis Approach of the Profile Roughness by Electron Microscopy with the Example of Hierarchically Grown Polystyrene–Iron Oxide–Silica Core–Shell–Shell Particles
- 15 September 2021
- Published by American Chemical Society (ACS) in Journal of Chemical Education
- Vol. 98 (10) , 3237-3244
Exploring an Application of Principal Component Analysis to Laser-Induced Breakdown Spectroscopy of Stainless-Steel Standard Samples as a Research Project
- 15 September 2021
- Published by American Chemical Society (ACS) in Journal of Chemical Education
- Vol. 98 (10) , 3237-3244
Exploring an Application of Principal Component Analysis to Laser-Induced Breakdown Spectroscopy of Stainless-Steel Standard Samples as a Research Project
- Open Access
Evaluation of a Spatial Heterodyne Spectrometer for Raman Spectroscopy of Minerals
Spatial heterodyne spectroscopy (SHS) is a novel spectral analysis technique that is being applied for Raman spectroscopy of minerals. This paper presents the theoretical basis of SHS and its application for Raman measurements of calcite, quartz and forsterite in marble, copper ore and nickel ore, respectively. The SHS measurements are done using a broadband (518–686 nm) and resolving power instrument. The spectra obtained using SHS are compared to those obtained by benchtop and modular dispersive spectrometers. It is found that SHRS performance in terms of resolution is comparable to that of the benchtop spectrometer and better than the modular dispersive spectrometer, while the sensitivity of SHRS is worse than that of a benchtop spectrometer, but better than that of a modular dispersive spectrometer. When considered that SHS components are small and can be packaged into a handheld device, there is interest in developing an SHS-based instrument for mobile Raman spectroscopy. This paper evaluates the possibility of such an application.Open AccessEvaluation of a Spatial Heterodyne Spectrometer for Raman Spectroscopy of Minerals
Spatial heterodyne spectroscopy (SHS) is a novel spectral analysis technique that is being applied for Raman spectroscopy of minerals. This paper presents the theoretical basis of SHS and its application for Raman measurements of calcite, quartz and forsterite in marble, copper ore and nickel ore, respectively. The SHS measurements are done using a broadband (518–686 nm) and resolving power instrument. The spectra obtained using SHS are compared to those obtained by benchtop and modular dispersive spectrometers. It is found that SHRS performance in terms of resolution is comparable to that of the benchtop spectrometer and better than the modular dispersive spectrometer, while the sensitivity of SHRS is worse than that of a benchtop spectrometer, but better than that of a modular dispersive spectrometer. When considered that SHS components are small and can be packaged into a handheld device, there is interest in developing an SHS-based instrument for mobile Raman spectroscopy. This paper evaluates the possibility of such an application. - 1 December 2018
- Published by Elsevier in Spectrochimica Acta Part B: Atomic Spectroscopy
- Vol. 150, 33-37
Investigation of laser-induced plasma at varying pressure and laser focusing
- 1 December 2018
- Published by Elsevier in Spectrochimica Acta Part B: Atomic Spectroscopy
- Vol. 150, 33-37
Investigation of laser-induced plasma at varying pressure and laser focusing
- 8 June 2018
- Published by Optica Publishing Group in Optics Express
- Vol. 26 (12) , 15962-15971
Laser-induced plasma imaging for low-pressure detection
A novel technique based on laser induced plasma imaging is proposed to measure residual pressure in sealed containers with transparent walls, e.g. high voltage vacuum interrupter in this paper. The images of plasma plumes induced on a copper target at pressure of ambient air between 10−2Pa and 105Pa were acquired at delay times of 200ns, 400ns, 600ns and 800ns. All the plasma images at specific pressures and delay times showed a good repeatability. It was found that ambient gas pressure significantly affects plasma shape, plasma integral intensities and expansion dynamics. A subsection characteristic method was proposed to extract pressure values from plasma images. The method employed three metrics for identification of high, intermediate and low pressures: the distance between the target and plume center, the integral intensity of the plume, and the lateral size of the plume, correspondingly. The accuracy of the method was estimated to be within 15% of nominal values in the entire pressure range between 10−2Pa and 105Pa. The pressure values can be easily extracted from plasma images in the whole pressure range, thus making laser induced plasma imaging a promising technique for gauge-free pressure detection.
- 8 June 2018
- Published by Optica Publishing Group in Optics Express
- Vol. 26 (12) , 15962-15971
Laser-induced plasma imaging for low-pressure detection
A novel technique based on laser induced plasma imaging is proposed to measure residual pressure in sealed containers with transparent walls, e.g. high voltage vacuum interrupter in this paper. The images of plasma plumes induced on a copper target at pressure of ambient air between 10−2Pa and 105Pa were acquired at delay times of 200ns, 400ns, 600ns and 800ns. All the plasma images at specific pressures and delay times showed a good repeatability. It was found that ambient gas pressure significantly affects plasma shape, plasma integral intensities and expansion dynamics. A subsection characteristic method was proposed to extract pressure values from plasma images. The method employed three metrics for identification of high, intermediate and low pressures: the distance between the target and plume center, the integral intensity of the plume, and the lateral size of the plume, correspondingly. The accuracy of the method was estimated to be within 15% of nominal values in the entire pressure range between 10−2Pa and 105Pa. The pressure values can be easily extracted from plasma images in the whole pressure range, thus making laser induced plasma imaging a promising technique for gauge-free pressure detection.
- 1 September 2014
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 53 (9) , 092703
On two optomechanical effects of laser-induced electrostriction in dielectric liquids
This paper presents electrostriction from the phenomenological perspective, and gives details on two mechanical effects arising from laser-matter interaction. Electrostriction is the tendency of materials to compress in the presence of a varying electric field. In this paper, the investigated materials are polar and nonpolar dielectric liquids. It is stressed that the dominant factor is the time evolution of the laser pulse, which causes tensile stresses and acoustic waves. The study is supported by experimental realization of electrostriction, which can be detected only at favorable conditions (observed in water, but not in castor oil). This study will shed light in developing measurement techniques (e.g., laser-induced grating spectroscopy) and in explaining the onset of cavities and laser-induced liquid breakdown.
- 1 September 2014
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 53 (9) , 092703
On two optomechanical effects of laser-induced electrostriction in dielectric liquids
This paper presents electrostriction from the phenomenological perspective, and gives details on two mechanical effects arising from laser-matter interaction. Electrostriction is the tendency of materials to compress in the presence of a varying electric field. In this paper, the investigated materials are polar and nonpolar dielectric liquids. It is stressed that the dominant factor is the time evolution of the laser pulse, which causes tensile stresses and acoustic waves. The study is supported by experimental realization of electrostriction, which can be detected only at favorable conditions (observed in water, but not in castor oil). This study will shed light in developing measurement techniques (e.g., laser-induced grating spectroscopy) and in explaining the onset of cavities and laser-induced liquid breakdown.
- 21 June 2013
- Published by Springer Nature in Journal of Visualization
- Vol. 16 (3) , 201-207
Measurement sensitivity and resolution for background oriented schlieren during image recording
- 21 June 2013
- Published by Springer Nature in Journal of Visualization
- Vol. 16 (3) , 201-207
Measurement sensitivity and resolution for background oriented schlieren during image recording
- Open Access
Measurement sensitivity and resolution for background oriented schlieren during image recording
Background oriented schlieren (BOS) visualization technique is examined by means of optical geometry. Two most important results are the calculation of the sensitivity and spatial resolution of a BOS system, which allows for the determination of the experiment design space. A set of relations that characterize the performance of a BOS measurement is given, with emphasis on the design of background pattern and spatial placement of optical components.
Open AccessMeasurement sensitivity and resolution for background oriented schlieren during image recording
Background oriented schlieren (BOS) visualization technique is examined by means of optical geometry. Two most important results are the calculation of the sensitivity and spatial resolution of a BOS system, which allows for the determination of the experiment design space. A set of relations that characterize the performance of a BOS measurement is given, with emphasis on the design of background pattern and spatial placement of optical components.
- 12 April 2013
- Published by Springer Nature in Applied Physics B
- Vol. 112 (4) , 571-577
Identification of discontinuities in plasma plume evolution
- 12 April 2013
- Published by Springer Nature in Applied Physics B
- Vol. 112 (4) , 571-577
Identification of discontinuities in plasma plume evolution
- Open Access
- 9 April 2013
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 45, 01124
Laser ablation at the hydrodynamic regime
EPJ Web of Conferences, open-access proceedings in physics and related sciences
- 9 April 2013
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 45, 01124
Open AccessLaser ablation at the hydrodynamic regime
EPJ Web of Conferences, open-access proceedings in physics and related sciences