Shiqiang Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Shiqiang Wang has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Minseo Park
Department of Physics Auburn University Auburn AL 36849 USA
3 shared publications K. Yapabandara
Department of Physics Auburn University Auburn AL 36849 USA
2 shared publications- Min P. Khanal
Auburn University Department of Physics Auburn, Alabama 36849, USA
2 shared publications - Sunil Uprety
Department of Physics, Auburn University, Auburn, AL 36849, USA
2 shared publications - Vahid Mirkhani
Auburn University Department of Physics Auburn, Alabama 36849
2 shared publications - Ayayi Claude Ahyi
Department of Physics, Auburn University 1 , Auburn, Alabama 36849, USA
1 shared publication
Latest Publications
- 6 December 2018
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 124 (21) , 215702
Impact of 100 keV proton irradiation on electronic and optical properties of AlGaN/GaN high electron mobility transistors (HEMTs)
Proton irradiation-induced effects on AlGaN/GaN high electron mobility transistors (HEMTs) were studied by emulating a certain space radiation environment (upstream of the earth's bow shock) using a relatively low energy (100 keV) proton beam with fluences of 1 × 1010, 1 × 1012, and 1 × 1014 protons/cm2. In order to isolate radiation-induced effects produced by the modification of the epi-layer from the effects produced by the change in the device structure (such as contacts), the epi-layers were irradiated prior to device fabrication, followed by material/device characterization. Proton irradiation-induced sub-gap traps were detected by spectroscopic photo current-voltage measurement. Raman study revealed that the proton irradiation had induced strain relaxation on the AlGaN/GaN HEMTs epi-layer. No substantial change in the crystal quality of the epi-layer was indicated by Raman and PL studies. With increasing proton fluences, increasing charge carrier density was observed, which was estimated via Raman spectroscopy and the charge-control model analysis. The magnitude and direction of the transistor threshold voltage shift were also dependent on proton fluence. Overall, degradation of transistor output characteristics of the fabricated HEMTs was observed with increasing proton fluence. However, based on the observed performance and the level of influence on material/device characteristics by 100 keV protons, it can be suggested that the AlGaN/GaN HEMTs have high endurance for exposure to relatively high fluences of the low-energy proton beam.
- 6 December 2018
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 124 (21) , 215702
Impact of 100 keV proton irradiation on electronic and optical properties of AlGaN/GaN high electron mobility transistors (HEMTs)
Proton irradiation-induced effects on AlGaN/GaN high electron mobility transistors (HEMTs) were studied by emulating a certain space radiation environment (upstream of the earth's bow shock) using a relatively low energy (100 keV) proton beam with fluences of 1 × 1010, 1 × 1012, and 1 × 1014 protons/cm2. In order to isolate radiation-induced effects produced by the modification of the epi-layer from the effects produced by the change in the device structure (such as contacts), the epi-layers were irradiated prior to device fabrication, followed by material/device characterization. Proton irradiation-induced sub-gap traps were detected by spectroscopic photo current-voltage measurement. Raman study revealed that the proton irradiation had induced strain relaxation on the AlGaN/GaN HEMTs epi-layer. No substantial change in the crystal quality of the epi-layer was indicated by Raman and PL studies. With increasing proton fluences, increasing charge carrier density was observed, which was estimated via Raman spectroscopy and the charge-control model analysis. The magnitude and direction of the transistor threshold voltage shift were also dependent on proton fluence. Overall, degradation of transistor output characteristics of the fabricated HEMTs was observed with increasing proton fluence. However, based on the observed performance and the level of influence on material/device characteristics by 100 keV protons, it can be suggested that the AlGaN/GaN HEMTs have high endurance for exposure to relatively high fluences of the low-energy proton beam.
- Open Access
- 1 November 2018
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 54 (22) , 1298-1300
Enhancement of electrical characteristics of a‐ZTO TFTs based on channel layers produced with alternating precursor concentration
The enhancement in electrical characteristics of the thin film transistors (TFTs) based on the mixed‐stacked amorphous zinc tin oxide (a‐ZTO) with an alternating precursor concentration is reported. The channel layers were deposited via sol–gel on oxidised p‐Si. The source/drain ohmic contacts were prepared on the ZTO layer, constructing the bottom‐gate TFTs. In this investigation, the TFTs with the following three channel layers were fabricated, and their characteristics were compared; (i) four layers produced from 0.05 M precursor solution, (ii) four layers produced from 0.2 M precursor solution, and (iii) four layers with alternating 0.05 and 0.2 M precursor solutions. It was found that the mobility (5.3 cm 2 /V s) of the TFT fabricated with the channel layers with alternating precursor concentration was higher than those with single concentration. Although the mechanism for this mobility enhancement is still being further analysed, it was conjectured that alternating precursor concentration might have reduced the trap density in the transistor channel and/or ZTO/SiO 2 interfaces.
- 1 November 2018
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 54 (22) , 1298-1300
Open AccessEnhancement of electrical characteristics of a‐ZTO TFTs based on channel layers produced with alternating precursor concentration
The enhancement in electrical characteristics of the thin film transistors (TFTs) based on the mixed‐stacked amorphous zinc tin oxide (a‐ZTO) with an alternating precursor concentration is reported. The channel layers were deposited via sol–gel on oxidised p‐Si. The source/drain ohmic contacts were prepared on the ZTO layer, constructing the bottom‐gate TFTs. In this investigation, the TFTs with the following three channel layers were fabricated, and their characteristics were compared; (i) four layers produced from 0.05 M precursor solution, (ii) four layers produced from 0.2 M precursor solution, and (iii) four layers with alternating 0.05 and 0.2 M precursor solutions. It was found that the mobility (5.3 cm 2 /V s) of the TFT fabricated with the channel layers with alternating precursor concentration was higher than those with single concentration. Although the mechanism for this mobility enhancement is still being further analysed, it was conjectured that alternating precursor concentration might have reduced the trap density in the transistor channel and/or ZTO/SiO 2 interfaces.
- 6 October 2017
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 123 (16)
Electrical characteristics and density of states of thin-film transistors based on sol-gel derived ZnO channel layers with different annealing temperatures
We report on the fabrication and electrical characterization of bottom gate thin-film transistors (TFTs) based on a sol-gel derived ZnO channel layer. The effect of annealing of ZnO active channel layers on the electrical characteristics of the ZnO TFTs was systematically investigated. Photoluminescence (PL) spectra indicate that the crystal quality of the ZnO improves with increasing annealing temperature. Both the device turn-on voltage (Von) and threshold voltage (VT) shift to a positive voltage with increasing annealing temperature. As the annealing temperature is increased, both the subthreshold slope and the interfacial defect density (Dit) decrease. The field effect mobility (μFET) increases with annealing temperature, peaking at 800 °C and decreases upon further temperature increase. An improvement in transfer and output characteristics was observed with increasing annealing temperature. However, when the annealing temperature reaches 900 °C, the TFTs demonstrate a large degradation in both transfer and output characteristics, which is possibly produced by non-continuous coverage of the film. By using the temperature-dependent field effect measurements, the localized sub-gap density of states (DOSs) for ZnO TFTs with different annealing temperatures were determined. The DOSs for the subthreshold regime decrease with increasing annealing temperature from 600 °C to 800 °C and no substantial change was observed with further temperature increase to 900 °C.
- 6 October 2017
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 123 (16)
Electrical characteristics and density of states of thin-film transistors based on sol-gel derived ZnO channel layers with different annealing temperatures
We report on the fabrication and electrical characterization of bottom gate thin-film transistors (TFTs) based on a sol-gel derived ZnO channel layer. The effect of annealing of ZnO active channel layers on the electrical characteristics of the ZnO TFTs was systematically investigated. Photoluminescence (PL) spectra indicate that the crystal quality of the ZnO improves with increasing annealing temperature. Both the device turn-on voltage (Von) and threshold voltage (VT) shift to a positive voltage with increasing annealing temperature. As the annealing temperature is increased, both the subthreshold slope and the interfacial defect density (Dit) decrease. The field effect mobility (μFET) increases with annealing temperature, peaking at 800 °C and decreases upon further temperature increase. An improvement in transfer and output characteristics was observed with increasing annealing temperature. However, when the annealing temperature reaches 900 °C, the TFTs demonstrate a large degradation in both transfer and output characteristics, which is possibly produced by non-continuous coverage of the film. By using the temperature-dependent field effect measurements, the localized sub-gap density of states (DOSs) for ZnO TFTs with different annealing temperatures were determined. The DOSs for the subthreshold regime decrease with increasing annealing temperature from 600 °C to 800 °C and no substantial change was observed with further temperature increase to 900 °C.