Sunil Uprety
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Sunil Uprety has a total of 51 co-authors. Here are the top co-authors by number of shared publications:
- Ayayi Claude Ahyi
Department of Physics, Auburn University 1 , Auburn, Alabama 36849, USA
2 shared publications Kosala Yapabandara
2 shared publications- Minseo Park
Department of Physics Auburn University Auburn AL 36849 USA
2 shared publications - Minseo Park
Department of Physics, Auburn University, Auburn, AL 36849, USA
2 shared publications - Shiqiang Wang
Department of Electrical and Computer Engineering, Auburn University 2 , Auburn, Alabama 36849, USA
2 shared publications - Vahid Mirkhani
Auburn University Department of Physics Auburn, Alabama 36849
2 shared publications
Latest Publications
- 26 January 2024
- Published by Elsevier in Thin Solid Films
- Vol. 791
Nanosecond-laser annealing of zinc oxide thin-films: The effect of the laser wavelength and fluence
- 26 January 2024
- Published by Elsevier in Thin Solid Films
- Vol. 791
Nanosecond-laser annealing of zinc oxide thin-films: The effect of the laser wavelength and fluence
- 1 January 2021
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 581 (Pt B) , 847-859
Towards thermoneutral hydrogen evolution reaction using noble metal free molybdenum ditelluride/graphene nanocomposites
- 1 January 2021
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 581 (Pt B) , 847-859
Towards thermoneutral hydrogen evolution reaction using noble metal free molybdenum ditelluride/graphene nanocomposites
- 1 February 2019
- Published by Elsevier in Thin Solid Films
- Vol. 672, 152-156
On the anomaly in the electrical characteristics of thin film transistors with multi-layered sol-gel processed ZnO
- 1 February 2019
- Published by Elsevier in Thin Solid Films
- Vol. 672, 152-156
On the anomaly in the electrical characteristics of thin film transistors with multi-layered sol-gel processed ZnO
- 6 December 2018
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 124 (21) , 215702
Impact of 100 keV proton irradiation on electronic and optical properties of AlGaN/GaN high electron mobility transistors (HEMTs)
Proton irradiation-induced effects on AlGaN/GaN high electron mobility transistors (HEMTs) were studied by emulating a certain space radiation environment (upstream of the earth's bow shock) using a relatively low energy (100 keV) proton beam with fluences of 1 × 1010, 1 × 1012, and 1 × 1014 protons/cm2. In order to isolate radiation-induced effects produced by the modification of the epi-layer from the effects produced by the change in the device structure (such as contacts), the epi-layers were irradiated prior to device fabrication, followed by material/device characterization. Proton irradiation-induced sub-gap traps were detected by spectroscopic photo current-voltage measurement. Raman study revealed that the proton irradiation had induced strain relaxation on the AlGaN/GaN HEMTs epi-layer. No substantial change in the crystal quality of the epi-layer was indicated by Raman and PL studies. With increasing proton fluences, increasing charge carrier density was observed, which was estimated via Raman spectroscopy and the charge-control model analysis. The magnitude and direction of the transistor threshold voltage shift were also dependent on proton fluence. Overall, degradation of transistor output characteristics of the fabricated HEMTs was observed with increasing proton fluence. However, based on the observed performance and the level of influence on material/device characteristics by 100 keV protons, it can be suggested that the AlGaN/GaN HEMTs have high endurance for exposure to relatively high fluences of the low-energy proton beam.
- 6 December 2018
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 124 (21) , 215702
Impact of 100 keV proton irradiation on electronic and optical properties of AlGaN/GaN high electron mobility transistors (HEMTs)
Proton irradiation-induced effects on AlGaN/GaN high electron mobility transistors (HEMTs) were studied by emulating a certain space radiation environment (upstream of the earth's bow shock) using a relatively low energy (100 keV) proton beam with fluences of 1 × 1010, 1 × 1012, and 1 × 1014 protons/cm2. In order to isolate radiation-induced effects produced by the modification of the epi-layer from the effects produced by the change in the device structure (such as contacts), the epi-layers were irradiated prior to device fabrication, followed by material/device characterization. Proton irradiation-induced sub-gap traps were detected by spectroscopic photo current-voltage measurement. Raman study revealed that the proton irradiation had induced strain relaxation on the AlGaN/GaN HEMTs epi-layer. No substantial change in the crystal quality of the epi-layer was indicated by Raman and PL studies. With increasing proton fluences, increasing charge carrier density was observed, which was estimated via Raman spectroscopy and the charge-control model analysis. The magnitude and direction of the transistor threshold voltage shift were also dependent on proton fluence. Overall, degradation of transistor output characteristics of the fabricated HEMTs was observed with increasing proton fluence. However, based on the observed performance and the level of influence on material/device characteristics by 100 keV protons, it can be suggested that the AlGaN/GaN HEMTs have high endurance for exposure to relatively high fluences of the low-energy proton beam.
- Open Access
- 1 November 2018
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 54 (22) , 1298-1300
Enhancement of electrical characteristics of a‐ZTO TFTs based on channel layers produced with alternating precursor concentration
The enhancement in electrical characteristics of the thin film transistors (TFTs) based on the mixed‐stacked amorphous zinc tin oxide (a‐ZTO) with an alternating precursor concentration is reported. The channel layers were deposited via sol–gel on oxidised p‐Si. The source/drain ohmic contacts were prepared on the ZTO layer, constructing the bottom‐gate TFTs. In this investigation, the TFTs with the following three channel layers were fabricated, and their characteristics were compared; (i) four layers produced from 0.05 M precursor solution, (ii) four layers produced from 0.2 M precursor solution, and (iii) four layers with alternating 0.05 and 0.2 M precursor solutions. It was found that the mobility (5.3 cm 2 /V s) of the TFT fabricated with the channel layers with alternating precursor concentration was higher than those with single concentration. Although the mechanism for this mobility enhancement is still being further analysed, it was conjectured that alternating precursor concentration might have reduced the trap density in the transistor channel and/or ZTO/SiO 2 interfaces.
- 1 November 2018
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 54 (22) , 1298-1300
Open AccessEnhancement of electrical characteristics of a‐ZTO TFTs based on channel layers produced with alternating precursor concentration
The enhancement in electrical characteristics of the thin film transistors (TFTs) based on the mixed‐stacked amorphous zinc tin oxide (a‐ZTO) with an alternating precursor concentration is reported. The channel layers were deposited via sol–gel on oxidised p‐Si. The source/drain ohmic contacts were prepared on the ZTO layer, constructing the bottom‐gate TFTs. In this investigation, the TFTs with the following three channel layers were fabricated, and their characteristics were compared; (i) four layers produced from 0.05 M precursor solution, (ii) four layers produced from 0.2 M precursor solution, and (iii) four layers with alternating 0.05 and 0.2 M precursor solutions. It was found that the mobility (5.3 cm 2 /V s) of the TFT fabricated with the channel layers with alternating precursor concentration was higher than those with single concentration. Although the mechanism for this mobility enhancement is still being further analysed, it was conjectured that alternating precursor concentration might have reduced the trap density in the transistor channel and/or ZTO/SiO 2 interfaces.
- Open Access
Enhanced Gas-Sensing Performance of GO/TiO2 Composite by Photocatalysis
Few studies have investigated the gas-sensing properties of graphene oxide/titanium dioxide (GO/TiO2) composite combined with photocatalytic effect. Room temperature gas-sensing properties of the GO/TiO2 composite were investigated towards various reducing gases. The composite sensor showed an enhanced gas response and a faster recovery time than a pure GO sensor due to the synergistic effect of the hybridization, such as creation of a hetero-junction at the interface and modulation of charge carrier density. However, the issue of long-term stability at room temperature still remains unsolved even after construction of a composite structure. To address this issue, the surface and hetero-junction of the GO/TiO2 composite were engineered via a UV process. A photocatalytic effect of TiO2 induced the reduction of the GO phase in the composite solution. The comparison of gas-sensing properties before and after the UV process clearly showed the transition from n-type to p-type gas-sensing behavior toward reducing gases. This transition revealed that the dominant sensing material is GO, and TiO2 enhanced the gas reaction by providing more reactive sites. With a UV-treated composite sensor, the function of identifying target gas was maintained over a one-month period, showing strong resistance to humidity.
Open AccessEnhanced Gas-Sensing Performance of GO/TiO2 Composite by Photocatalysis
Few studies have investigated the gas-sensing properties of graphene oxide/titanium dioxide (GO/TiO2) composite combined with photocatalytic effect. Room temperature gas-sensing properties of the GO/TiO2 composite were investigated towards various reducing gases. The composite sensor showed an enhanced gas response and a faster recovery time than a pure GO sensor due to the synergistic effect of the hybridization, such as creation of a hetero-junction at the interface and modulation of charge carrier density. However, the issue of long-term stability at room temperature still remains unsolved even after construction of a composite structure. To address this issue, the surface and hetero-junction of the GO/TiO2 composite were engineered via a UV process. A photocatalytic effect of TiO2 induced the reduction of the GO phase in the composite solution. The comparison of gas-sensing properties before and after the UV process clearly showed the transition from n-type to p-type gas-sensing behavior toward reducing gases. This transition revealed that the dominant sensing material is GO, and TiO2 enhanced the gas reaction by providing more reactive sites. With a UV-treated composite sensor, the function of identifying target gas was maintained over a one-month period, showing strong resistance to humidity.